Ventilation rate and behavioural responses of two species of intertidal goby (Pisces : Gobiidae) at extremes of environmental temperature

We investigated the behavioural responses of two gobiid fish species to temperature to determine if differences in behaviour and ventilation rate might explain any apparent vertical zonation. A survey of the shore at Manly, Moreton Bay revealed Favonigobius exquisitus to dominate the lower shore and Pseudogobius sp. 4 the upper shore. These species were exposed to a range of temperatures (15-40 degreesC) in aquaria for up to 6 h. At 20 degreesC F. exquisitus exhibited a mean gill ventilation rate of 26 +/- 1.4 bpm (beats per minute) differing significantly from Pseudogobius, which ventilated at a fivefold greater rate of 143 +/- 6 bpm. The ventilation rate in F. exquisitus underwent a fivefold increase from normal local water temperature (20 degreesC) to high temperature (35 degreesC) conditions, whereas that of Pseudogobius did not even double, suggesting that Pseudogobius sp. is a better thermal regulator than F. exquisitus. While both species emerged from the water at high temperatures (>30 degreesC) the behaviours they exhibited while immersed at high temperature were quite different. F. exquisitus undertook vertical displacement movements we interpret as an avoidance response, whereas Pseudogobius sp. appeared to use a coping strategy involving movements that might renew the water mass adjacent to its body. The thermal tolerances and behaviours of F. exquisitus and Pseudogobius sp. are in broad agreement with their vertical distribution on the shore.

Microbial diversity within the water column of a larval rearing system for the ornate rock lobster (Panulirus ornatus)

The ornate tropical rock lobster, Panulirus ornatus has substantial potential as an aquaculture species though disease outbreaks during the animal's extended larval lifecycle are major constraints for success. In order to effectively address such disease-related issues, an improved understanding of the composition and dynamics of the microbial communities in the larval rearing tanks is required. This study used flow cytometry and molecular microbial techniques (clone libraries and denaturing gradient gel electrophoresis (DGGE)) to quantify and characterise the microbial community of the water column in the early stages (developmental stage I-II) of a P. ornatus larval rearing system. DGGE analysis of a 5000 L larval rearing trial demonstrated a dynamic microbial community with distinct changes in the community structure after initial stocking (day I to day 2) and from day 4 to day 5, after which the structure was relatively stable. Flow cytometry analysis of water samples taken over the duration of the trial demonstrated a major increase in bacterial load leading up to and peaking on the first day of the initial larval moult (day 7), before markedly decreasing prior to when > 50% of larvae moulted (day 9). A clone library of a day 10 water sample taken following a mass larval mortality event reflected high microbial diversity confirmed by statistical analysis indices. Sequences retrieved from both clone library and DGGE analyses were dominated by gamma- and alpha-Proteobacteria affiliated organisms with additional sequences affiliated with beta- and epsilon-Proteobacteria, Bacteroidetes, Cytophagales and Chlamydiales groups. Vibrio affiliated species were commonly retrieved in the clone library, though absent from DGGE analysis.

Product performance and specification in new product development

This paper deals with product performance and specification in new product development. There are many different definitions of performance and specification in the literature. These are reviewed and a new classification scheme for product performance is proposed. The link between performance and specification is discussed in detail using a new model for the new product development process. The new model involves two stages, with each containing three main phases, and is useful for making decisions with regards to product performance and specification.

Validation of a generalized transfer function to noninvasively derive central blood pressure during exercise

Exercise brachial blood pressure ( BP) predicts mortality, but because of wave reflection, central ( ascending aortic) pressure differs from brachial pressure. Exercise central BP may be clinically important, and a noninvasive means to derive it would be useful. The purpose of this study was to test the validity of a noninvasive technique to derive exercise central BP. Ascending aortic pressure waveforms were recorded using a micromanometer-tipped 6F Millar catheter in 30 patients (56 +/- 9 years; 21 men) undergoing diagnostic coronary angiography. Simultaneous recordings of the derived central pressure waveform were acquired using servocontrolled radial tonometry at rest and during supine cycling. Pulse wave analysis of the direct and derived pressure signals was performed offline (SphygmoCor 7.01). From rest to exercise, mean arterial pressure and heart rate were increased by 20 +/- 10 mm Hg and 15 +/- 7 bpm, respectively, and central systolic BP ranged from 77 to 229 mm Hg. There was good agreement and high correlation between invasive and noninvasive techniques with a mean difference (+/- SD) for central systolic BP of -1.3 +/- 3.2 mm Hg at rest and -4.7 +/- 3.3 mm Hg at peak exercise ( for both r=0.995; P < 0.001). Conversely, systolic BP was significantly higher peripherally than centrally at rest (155 +/- 33 versus 138 +/- 32mm Hg; mean difference, -16.3 +/- 9.4mm Hg) and during exercise (180 +/- 34 versus 164 +/- 33 mm Hg; mean difference, -15.5 +/- 10.4 mm Hg; for both P < 0.001). True myocardial afterload is not reliably estimated by peripheral systolic BP. Radial tonometry and pulse wave analysis is an accurate technique for the noninvasive determination of central BP at rest and during exercise.

Integrating formal specification and software verification and validation

It is not surprising that students are unconvinced about the benefits of formal methods if we do not show them how these methods can be integrated with other activities in the software lifecycle. In this paper, we describe an approach to integrating formal specification with more traditional verification and validation techniques in a course that teaches formal specification and specification-based testing. This is accomplished through a series of assignments on a single software component that involves specifying the component in Object-Z, validating that specification using inspection and a specification animation tool, and then testing an implementation of the specification using test cases derived from the formal specification.

Do process modelling techniques get better? A comparative ontological analysis of BPMN

Current initiatives in the field of Business Process Management (BPM) strive for the development of a BPM standard notation by pushing the Business Process Modeling Notation (BPMN). However, such a proposed standard notation needs to be carefully examined. Ontological analysis is an established theoretical approach to evaluating modelling techniques. This paper reports on the outcomes of an ontological analysis of BPMN and explores identified issues by reporting on interviews conducted with BPMN users in Australia. Complementing this analysis we consolidate our findings with previous ontological analyses of process modelling notations to deliver a comprehensive assessment of BPMN.

Major issues in business process management: An Australian perspective

Business Process Management (BPM) is widely seen as the top priority in organizations wanting to survive competitive markets. However, the current academic research agenda does not seem to map with industry demands. In this paper, we address the need to identify the actual issues that organizations face in their efforts to manage business processes. To that end, we report a number of critical issues identified by industry in what we consider to be the first steps towards an industry-driven research agenda for the BPM area. The reported issues are derived from a series of focus groups conducted with Australian organizations. The findings point to, among others, a need for more consolidated efforts in the areas of business process governance, systematic change management, developing BPM methodologies, and introducing appropriate performance measures.

The co-evolutionary dynamics of IS engagement

In this paper we consider the co-evolutionary dynamics of IS engagement where episodic change of implementation increasingly occurs within the context of linkages and interdependencies between systems and processes within and across organisations. Although there are many theories that interpret the various motors of change be it lifecycle, teleological, dialectic or evolutionary, our paper attempts to move towards a unifying view of change by studying co-evolutionary dynamics from a complex systems perspective. To understand how systems and organisations co-evolve in practice and how order emerges, or fails to emerge, we adopt complex adaptive systems theory to incorporate evolutionary and teleological motors, and actor-network theory to incorporate dialectic motors. We illustrate this through the analysis of the implementation of a novel academic scheduling system at a large research-intensive Australian university.