210 resultados para Standardized terms of contract
Resumo:
This paper studies young tourists' perception of danger within the urban holiday environment of London, England. The study of perceived danger is important not only in its own right, but also because of the influence it may have on use of leisure spaces and times. This research assesses gender and group composition differences in perception of danger, addressing the relatively neglected issues of men's perception and the relationship between the genders. For the purpose of this paper 'danger' was assessed by studying how safe, relaxed, vulnerable, threatened, and at risk people felt while in London. The study found a number of similarities and differences between the men and women studied, in terms of how they perceived danger and their group composition during the day and nigh-time. These results indicate that gender may not be the only influence on perception and behaviour, and that men and women should not be regarded as-homogenous cohorts. (C) 2001 Elsevier Science Ltd. All rights reserved.
Resumo:
We study the effect of quantum interference on the population distribution and absorptive properties of a V-type three-level atom driven by two lasers of unequal intensities and different angular frequencies. Three coupling configurations of the lasers to the atom are analysed: (a) both lasers coupled to the same atomic transition, (b) each laser coupled to different atomic transition and (c) each laser coupled to both atomic transitions. Dressed stales for the three coupling configurations are identified, and the population distribution and absorptive properties of the weaker field are interpreted in terms of transition dipole moments and transition frequencies among these dressed states. In particular, we find that in the first two cases there is no population inversion between the bare atomic states, but the population can be trapped in a superposition of the dressed states induced by quantum interference and the stronger held. We show that the trapping of the population, which results from the cancellation of transition dipole moments, does not prevent the weaker field to be coupled to the cancelled (dark) transitions. As a result, the weaker field can be strongly amplified on transparent transitions. In the case of each laser coupled to both atomic transitions the population can be trapped in a linear superposition of the excited bare atomic states leaving the ground state unpopulated in the steady state. Moreover, we find that the absorption rate of the weaker field depends on the detuning of the strong field from the atomic resonances and the splitting between the atomic excited states. When the strong held is resonant to one of the atomic transitions a quasi-trapping effect appears in one of the dressed states. In the quasi-trapping situation all the transition dipole moments are different from zero, which allows the weaker field to be amplified on the inverted transitions. When the strong field is tuned halfway between the atomic excited states, the population is completely trapped in one of the dressed states and no amplification is found for the weaker field.
Resumo:
In this paper, the organophilic property of MCM-41 was studied and compared with hydrophobic silicalite-l using adsorption and temperature-programmed desorption (TPD) methods. The surface heterogeneity of MCM-41 was evaluated in terms of activation energy for desorption (E-d) and isosteric heat of adsorption (q(st)). Results show that MCM-41 has a higher affinity to polar organic compounds than to non-polar organics while silicalite-l has a higher affinity to non-polar organic compounds than to polar organics. This organophilic behaviour of MCM-41 is attributed to its surface heterogeneity. (C) 2001 Elsevier Science B.V. All rights reserved.
Resumo:
Composite clay nanostructures (CCNs) were observed in intercalating Laponite clay with alumina in the presence of alkyl polyether surfactants which contain hydrophobic alkyl chains and ether groups. Such nanostructured clays are highly porous solids consisting of randomly orientated clay platelets intercalated with alumina nanoparticles. The pores in the product solids are larger than the dimension of the surfactant molecules, ranging from 2 to 10 nm. This suggests that the micelles of the surfactant molecules, rather than the molecules, act as templates in the synthesis. Interestingly, it is found that the size of the framework pores was directly proportional to the amount of the surfactants in terms of moles, but shows no evident dependence on the size of the surfactant molecules. Broad pore size distributions were observed for the product CCNs. This study demonstrates that introducing surfactants in the pillaring process of clays is a powerful strategy for tailoring the pore structures of nanoporous clays. With this new technique, it is possible to design and engineer such composite clay nanostructures with desired pore and surface properties by the proper choice of surfactant amounts and preparation conditions.
Resumo:
Silica xerogels were prepared by a sol-gel process catalyzed by acid with tetraethylorthosilicate, and using an organic covalent ligand template (methyltriethoxysilane) or a noncovalent template C6 surfactant (triethylhexylammonium bromide). The influence of hydrotreatment on the structure of templated xerogels is examined in terms of surface area, micropore volume, average pore size, and pore size distribution, and compared against a blank xerogel (nontemplated). The role of surface functional groups was evaluated using Si-29 nuclear magnetic resonance. The structural integrity of the xerogel was maintained to a large extent in samples that had a high contribution of Q(4) species (siloxane groups). Xerogel matrix densification occurred when there was a large concentration of Q(3) and Q(2) species (silanol groups), which also were responsible for increased hydrophilicity. The templated xerogels resulted in up to a 25% concentration of methyl functional groups (T-3 and T-2 species), leading to hydrophobic xerogels. The best results in terms of structural integrity and hydrophobicity were obtained with templated xerogels prepared with the C6 surfactant. The results in this study suggest that surfactant-enhanced condensation reactions lead to structures with a high contribution of Q(4) groups, which are not susceptible to water attack, but are strong enough to oppose matrix densification during rehydration.
Resumo:
Generally employment has been studied in terms of changes in the types of goods and services that the economy is purchasing. Far less attention has been given to the occupational aggregates that go into producing these goods and services. The few studies that did investigate this area found that the mix of tabour inputs appear to have been changing over time in a systematic pattern. The increasing prevalence of white-collar, information workers gave rise to the assertion that many societies had entered a post-industrial information age. Deals first of aff with some issues of measurement in the context of the Australian labour force, then looks at trends in various occupational groups using a non-standard four-sector classification of the labour force. Finally suggests an application in relation to the link between education and training and its ability to reduce structural unemployment.
Resumo:
A survey of the floors of 3001 empty sea cargo containers in storage was undertaken to estimate the quarantine risk of importing exotic insect pests into Australia, with special reference to pests of timber. More than 7400 live and dead insects were collected from 1174 containers. No live infestations of timber-feeding insects were recorded, but feeding damage detected in one floor indicates a low risk of importing colonies of timber pests in containers. The survey collection of dead insects demonstrates that containers are regularly exposed to economically important quarantinable insects, including timber pests (bostrichids, curculionids, cerambycids, siricids and termites), agricultural pests (including Adoretus sinicus, Adoretus sp., Carpophilus obsoletus and Philaenus spumarius), and nuisance pests (vespids and Solenopsis sp.). Stored product pests were found in more than 10% of containers. The assessment of pest risk associated with shipping containers is discussed in terms of the quantity and quality of opportunities for exotic insects to establish via this pathway.
Resumo:
1. Species in the genus Neoseiulus are considered to be generalist predators. with some species used in biological control programmes against phytophagous mites and insects. 2. A general survey of Neoseiulus species in inland Australia indicated that different species are associated with particular tree species. This pattern of host plant use was investigated for four Neoseiulus species (N. buxeus, N. cappari, N. brigarinus, N. eremitus) by means of a sampling programme through time and across space. 3. Each species of Neoseiulus was collected entirely or mostly from one species of tree: little or no overlap was detected despite the tree species growing in well-mixed stands. Host plant specificity thus appears to be strong in this genus. 4. Species in two other genera (Pholaseius and Australiseiulus), also considered to be predatory, showed a similar association with particular tree species. 5. The implications for the use of these predators in biological control are considerable. In particular, phytoseiid species with specific needs in terms of host plants may not be suitable for use as general purpose predators. Meeting the needs of phytoseiids through the modification of host plant attributes may be a step towards enhancing their efficacy as biological control agents.
Resumo:
This research is part of a project whose scope was to investigate the engineering properties of new non-commercial alloy formulations based on the Cu rich corner of the Cu-Fe-Cr ternary system with the primary aim of exploring the development of a new cost-effective high-strength, high-conductivity copper alloy. Promising properties have been measured for the following alloys: Cu-0.7wt%Cr-0.3wt%Fe and Cu-0.7wt%Cr-2.0wt%Fe. This paper reports on the microstructural characterisation of these alloys and discusses the mechanical and electrical properties of these alloys in terms of their microstructure, particularly the formation of precipitates. These alloys have evinced properties that warrant further investigation. Cost modelling has shown that Cu-0.7wt%Cr-0.3wt%Fe is approximately 25% cheaper to produce than commercial Cu-1%Cr. It has also been shown to be more cost efficient on a yield stress and % IACS per dollar basis. The reason for the cost saving is that the Cu-0.7%Cr-0.3%Fe alloy can be made with low carbon ferro-chrome additions as the source of chromium rather than the more expensive Cu-Cr master-alloy. For applications in which cost is one of the primary materials selection criteria, it is envisaged that there would be numerous applications in both cast and wrought form, where the Cu-0.7%Cr-0.3%Fe alloy would be more suitable than Cu-1%Cr. (C) 2001 Kluwer Academic Publishers.
Resumo:
A theory is developed for calculating the entrapment of particles by a windbreak, with four results. (1) The fraction of particles in the oncoming flow which pass through the windbreak, or transmittance of the windbreak for particles (sigma), is related to the optical porosity (tau). The very simple approximation sigma=tau works well for most applications involving the interception of spray droplets by windbreaks. Results from a field experiment agree with the theoretical predictions. (2) A new equation for the bulk drag coefficient of a windbreak is tested against numerical, wind tunnel and field experiments. This enables the bleed velocity for the flow through the windbreak to be predicted in terms of the screen pressure coefficient (k) of the barrier. (3) The relationship between k and tau is different for a vegetative barrier than for a screen across a confined duct, implying a lower Fc for given tau. (4) The total deposition of particles to a windbreak is determined by a trade-off between particle absorption and throughflow, implying an optimum value of tau for maximum total deposition. For particles larger than 30 mum and vegetation elements smaller than 30 mm, this occurs near tau = 0.2. (C) 2001 Elsevier Science Ltd. All rights reserved.
Resumo:
Primary objective: To examine a theoretical model which suggests that a contribution of both psychological and neuropsychological factors underlie deficits in self-awareness and self-regulation. Research design: Multivariate design including correlations and analysis of variance (ANOVA). Methods: Sixty-one subjects with acquired brain injury (ABI) were administered standardized measures of self-awareness and self-regulation. Psychological factors included measures of coping-related denial, personality-related denial and personality change. Neuropsychological factors included an estimate of IQ and two measures of executive functioning that assess capacity for volition and purposive behaviour. Main outcomes and results: The findings indicated that the relative contribution of neuropsychological factors to an outcome of deficits in self-awareness and self-regulation had a more direct effect than psychological factors. In general, measures of executive functioning had a direct relationship, while measures of coping-related and personality-related denial had an indirect relationship with measures of self-awareness and self-regulation. Conclusion: The findings highlighted the importance of measuring both neuropsychological and psychological factors and demonstrated that the relative contribution of these variables varies according to different levels of self-awareness and self-regulation.
Resumo:
Highly filled thermosets are used in applications such as integrated circuit (IC) packaging. However, a detailed understanding of the effects of the fillers on the macroscopic cure properties is limited by the complex cure of such systems. This work systematically quantifies the effects of filler content on the kinetics, gelation and vitrification of a model silica-filled epoxy/amine system in order to begin to understand the role of the filler in IC packaging cure. At high cure temperatures (100 degreesC and above) there appears to be no effect of fillers on cure kinetics and gelation and vitrification times. However, a decrease in the gelation and vitrification times and increase the reaction rate is seen with increasing filler content at low cure temperatures (60-90 degreesC). An explanation for these results is given in terms of catalysation of the epoxy amine reaction by hydrogen donor species present on the silica surface and interfacial effects.
Resumo:
Patterns of water supply and use in Australia and the U.S.A. differ in many ways. This results in different perceptions concerning the nature of drought and policy approaches to its management. This paper discusses the differences and similarities and explores lessons that policy makers in both countries can learn from one another. A key difference between the two countries is that whereas drought is perceived in Australia essentially in terms of its impact on agriculture, in the U.S. both perceptions and policy are also heavily influenced by the impact of drought on urban communities. This has led to different policy emphases. In 1992 Australia established its National Drought Policy; the U.S. is presently considering the adoption of a national drought policy. These policies highlight drought being accepted as part of natural climate variability, rather than as a natural disaster. They also emphasize the protection of the natural resource base.
Resumo:
An experimental study has been carried out for the gas-liquid two-phase flow in a packed bed simulating conditions of the gas and liquid flows in the lower part of blast furnace. The localised liquid flow phenomenon in presence of gas cross flow, which usually occurs around the cohesive zone and raceway in blast furnace, was investigated in detail. Such liquid flow is characterised in terms of liquid shift distance or liquid shift angle that can effectively be measured by the experiments involved in the current study. It is found that liquid shift angle does not significantly increase or decrease with different packing depth. This finding supports the hypothesis of the force balance model where a vectorial relationship among acting forces, i.e. gas drag force, gravitational force and solid-liquid friction force, and liquid shift angle does exist. Liquid shift angle is inversely proportional to particle size and liquid density, and proportional to square of gas superficial velocity, but is almost independent on liquid flowrate and liquid viscosity. The gas-liquid drag coefficient, an important aspect for quantifying the interaction between gas and liquid flows, was conceptually modified based on the discrete feature of liquid flow through a packed bed and evaluated by the combined theoretical and experimental investigation. Experimental measurements suggest that the gas-liquid drag coefficient is approximately a constant (C-DG(')=5.4+/-1.0) and is independent on liquid properties, gas velocity and packing structure. The result shows a good agreement with previous experimental data and prediction of the existing liquid flow model.
Resumo:
Free field and twisted parafermionic representations of twisted su(3)(k)((2)) current algebra are obtained. The corresponding twisted Sugawara energy-momentum tensor is given in terms of three (beta, gamma) pairs and two scalar fields and also in terms of twisted parafermionic currents and one scalar field. Two screening currents of the first kind are presented in terms of the free fields.