Effects of alkalis, oxidants and urea on the nutritive value of rhodes grass (Chloris gayana cv. Callide)

Two in sacco experiments were conducted to evaluate the impact on the nutritive value of rhodes grass hay (Chloris gayana cv. Callide) of treatment with alkalis or oxidants. In Experiment 1, three alkalis (Ca(OH)(2), NaOH, CaO) and two oxidants (NaOCl and H2O2) were applied at levels of 0, 20, 40, 60 or 80 g/kg of dry matter (DM). NaOH, Ca(OH)(2) and CaO had negative linear effects (P < 0.05) on the neutral detergent fibre (NDF) content and positive linear effects (P < 0.05) on the 48 h in sacco disappearances of DM, organic matter (OM), NDF and acid detergent fibre (ADF). NaOCl reduced (P < 0.05) NDF content but had no effect (P > 0.05) on the in sacco disappearances. H2O2 had no effect (P > 0.05) on the composition or digestibility of rhodes grass hay. In Experiment 2, effects of urea (0, 20, 40, 60 and 80 g urea/kg DM) and water (250, 500 and 750 g/kg DM) treatment of rhodes grass hay were examined in a 5 x 3 factorial experiment. Significant interactions between water and urea (P < 0.05) occurred for concentrations of crude protein (CP) and NDF, and 48 h in sacco disappearances of DM, OM (OMD) and NDE The combinations of water (g/kg DM) and urea (g/kg DM) that resulted in the highest concentrations of CP (281 g/kg DM) and OMD (747 g/kg DM) were 250 + 80 and 500 + 80, respectively. NaOH, Ca(OH)(2), CaO and urea significantly alter the NDF content and digestibility of rhodes grass hay, and urea also increases its CP content. Overall, NaOH was the most efficacious, followed by Ca(OH)(2), CaO, urea, NaOCl and H2O2. Crown Copyright (C) 2002 Published by Elsevier Science B.V. All rights reserved.

Effect of material anisotropy on the onset of convective flow in three-dimensional fluid-saturated faults

In order to investigate the effect of material anisotropy on convective instability of three-dimensional fluid-saturated faults, an exact analytical solution for the critical Rayleigh number of three-dimensional convective flow has been obtained. Using this critical Rayleigh number, effects of different permeability ratios and thermal conductivity ratios on convective instability of a vertically oriented three-dimensional fault have been examined in detail. It has been recognized that (1) if the fault material is isotropic in the horizontal direction, the horizontal to vertical permeability ratio has a significant effect on the critical Rayleigh number of the three-dimensional fault system, but the horizontal to vertical thermal conductivity ratio has little influence on the convective instability of the system, and (2) if the fault material is isotropic in the fault plane, the thermal conductivity ratio of the fault normal to plane has a considerable effect on the critical Rayleigh number of the three-dimensional fault system, but the effect of the permeability ratio of the fault normal to plane on the critical Rayleigh number of three-dimensional convective flow is negligible.

A note on the decomposition of the health concentration index

In recent work, the concentration index has been widely used as a measure of income-related health inequality. The purpose of this note is to illustrate two different methods for decomposing the overall health concentration index using data collected from a Short Form (SF-36) survey of the general Australian population conducted in 1995. For simplicity, we focus on the physical functioning scale of the SF-36. Firstly we examine decomposition 'by component' by separating the concentration index for the physical functioning scale into the ten items on which it is based. The results show that the items contribute differently to the overall inequality measure, i.e. two of the items contributed 13% and 5%, respectively, to the overall measure. Second, to illustrate the 'by subgroup' method we decompose the concentration index by employment status. This involves separating the population into two groups: individuals currently in employment; and individuals not currently employed. We find that the inequality between these groups is about five times greater than the inequality within each group. These methods provide insights into the nature of inequality that can be used to inform policy design to reduce income related health inequalities. Copyright (C) 2002 John Wiley Sons, Ltd.

Causes and consequences of long-term climatic variability on the Australian continent

1. Ice-volume forced glacial-interglacial cyclicity is the major cause of global climate variation within the late Quaternary period. Within the Australian region, this variation is expressed predominantly as oscillations in moisture availability. Glacial periods were substantially drier than today with restricted distribution of mesic plant communities, shallow or ephemeral water bodies and extensive aeolian dune activity. 2. Superimposed on this cyclicity in Australia is a trend towards drier and/or more variable climates within the last 350 000 years. This trend may have been initiated by changes in atmospheric and ocean circulation resulting from Australia's continued movement into the Southeast Asian region and involving the onset or intensification of the El Nino-Southern Oscillation system and a reduction in summer monsoon activity. 3. Increased biomass burning, stemming originally from increased climatic variability and later enhanced by activities of indigenous people, resulted in a more open and sclerophyllous vegetation, increased salinity and a further reduction in water availability. 4. Past records combined with recent observations suggest that the degree of environmental variability will increase and the drying trend will be enhanced in the foreseeable future, regardless of the extent or nature of human intervention.

Environmental influence on the stress corrosion cracking of rock bolts

In order to understand rock bolt Stress Corrosion Cracking (SCC), a series of experiments have been performed in Linearly Increasing Stress Test (LIST) apparatus. One series of experiments determined the threshold stress of various bolt metallurgies (900 MPa for Steel A, and 800 MPa for Steel B and C). The high values of threshold stress suggest that SCC begins in rock bolts when they are sheared by moving rock strata. Typical crack velocity values have been measured to be 2.5 x 10(-8) m s(-1), indicating that there is not much benefit for rock bolt steel of higher fracture toughness. Another series of experiments were performed to understand the environmental conditions causing SCC of steel A and galvanised Steel A rock bolt steel. SCC only occurred for environmental conditions for which produce hydrogen on the sample surface, leading to hydrogen embrittlement and SCC. Fracture surfaces of LIST samples failed by SCC were found to display the same fracture regions as fracture surfaces of rock bolts failed in service by SCC: Tearing Topography Surface (TTS), Corrugated Irregular Surface (CIS), quasi Micro Void Coalescence (qMVC) and Fast Fracture Surface (FFS). Water chemistry analysis were carried out on samples collected from various Australian mines in order to compare laboratory electrolyte conditions to those found in underground mines.

Effects of restricted cochlear lesions in adult cats on the frequency organization of the inferior colliculus

Restricted cochlear lesions in adult animals result in plastic changes in the representation of the lesioned cochlea, and thus in the frequency map, in the contralateral auditory cortex and thalamus. To examine the contribution of subthalamic changes to this reorganization, the effects of unilateral mechanical cochlear lesions on the frequency organization of the central nucleus of the inferior colliculus (ICC) were examined in adult cats. Lesions typically resulted in a broad high-frequency hearing loss extending from a frequency in the range 15-22 kHz. After recovery periods of 2.5-18 months, the frequency organization of ICC contralateral to the lesioned cochlea was determined separately for the onset and late components of multiunit responses to tone-burst stimuli. For the late response component in all but one penetration through the ICC, and for the onset response component in more than half of the penetrations, changes in frequency organization in the lesion projection zone were explicable as the residue of prelesion responses. In half of the penetrations exhibiting nonresidue type changes in onset-response frequency organization, the changes appeared to reflect the unmasking of normally inhibited inputs. In the other half it was unclear whether the changes reflected unmasking or a dynamic process of reorganization. Thus, most of the observed changes were explicable as passive consequences of the lesion, and there was limited evidence for plasticity in the ICC. The implications of the data with respect to the primary locus of the changes and to the manner in which they contribute to thalamocortical reorganization are considered. (C) 2003 Wiley-Liss, Inc.

'We're not going to take it!' - Academics on the rampage

What are the social factors that can change apathy to action? Two survey-based field studies were conducted with National Tertiary Education Union members, to investigate the interplay between individual and group-based psychological processes in union support. The first study was conducted in an industrially calm context and the second, following a national strike in the Australian university sector. Drawing on social identity theory, the studies investigated both individual and group-related factors including: (a) instrumental and ideological attitudes; (b) employee identity; (c) perceptions of employment-related threat, and of relations with management; and (d) normative support for the union amongst fellow employees. Consistent with predictions, groupbased factors (i.e., perceived context and normative support) moderated the role of instrumental and ideological beliefs in the behavioural expression of union support. A subset of participants, who responded at both times, provided additional evidence for the importance of contextually activated group-processes to changes in union behaviour.

Material influence on the stress corrosion cracking of rock bolts

Rock bolt stress corrosion cracking (SCC) has been investigated using the linearly increasing stress test (LIST). One series of experiments determined the threshold stress of various bolt metallurgies (900 MPa for 1355AXRC, and 800 MPa for MAC and MA840B steels). The high values of threshold stress suggest that SCC begins in rock bolts when they are sheared by moving rock strata. SCC only occurred for environmental conditions which produce hydrogen on the sample surface, leading to hydrogen embrittlement and SCC. Different threshold potentials were determined for a range of metallurgies. Cold work was shown to increase the resistance of the steel to SCC. Rock bolt rib geometry does not have a direct impact on the SCC resistance properties of the bolt, although the process by which the ribs are produced can introduce tensile stresses into the bolt which lower its resistance to SCC. (C) 2004 Elsevier Ltd. All rights reserved.