Determination of eutectic solidification mode in Sr-modified hypoeutectic Al-Si alloys by EBSD

The effect of eutectic modification by strontium on nucleation and growth of the eutectic in hypoeutectic Al-Si foundry alloys has been investigated by electron back-scattering diffraction (EBSD) mapping. Specimens were prepared from three hypoeutectic AlSi base alloys with 5, 7 and 10 mass%Si and with different strontium contents up to 740 ppm for modification of eutectic silicon. By comparing the orientation of the aluminium in the eutectic to that of the surrounding primary aluminium dendrites? the growth mode of the eutectic could be determined. The mapping results indicate that the eutectic grew from the primary phase in unmodified alloys. When the eutectic was modified by strontium, eutectic grains nucleated separately from the primary dendrites. However, in alloys with high strontium levels, the eutectic again grew from the primary phase. These observed effects of strontium additions on the eutectic solidification mode are independent of silicon content in the range between 5 and 10 mass%Si.

Eutectic solidification mode in sodium modified Al-7 mass %Si-3.5 mass %Cu-0.2 mass %Mg casting alloys

The influence of sodium (Na) on nucleation and growth of the Al-Si eutectic in a commercial hypoeutectic Al-Si-Cu-Mg foundry alloy has been investigated. The microstructural evolution during eutectic solidification was studied by a quenching technique. By comparing the orientation of the aluminium in the eutectic to that of the surrounding primary aluminium dendrites by EBSD, the eutectic solidification mode could be determined. The results show that the eutectic solidification starts near the mould wall and evolves with front growth opposite the thermal gradient on a macro-scale, and on a micro-scale with independent heterogeneous nucleation of eutectic grains in interdendritic spaces. Na-modified alloys therefore behave significantly differently from those modified by other elemental additions.

Eutectic solidification in hypoeutectic Al-Si alloys: electron backscatter diffraction analysis

Nucleation and growth of the eutectic, in hypoeutectic Al-Si foundry alloys has been investigated by the electron backscatter diffraction (EBSD) mapping technique using a scanning electron microscope (SEM). Sample preparation procedures for optimizing mapping have been developed. To obtain a sufficiently smooth surface from a cast Al-Si eutectic microstructure for EBSD mapping, an appropriate preparation technique by ion milling was developed and applied instead of conventional electropolishing. By comparing the orientation of the aluminum in the eutectic to that of the surrounding primary aluminum dendrites, the growth mechanism of the eutectic can be determined. Two different results were found, in isolation or sometimes together, but distinct for different strontium contents: (1) crystallographic orientations of aluminum in eutectic and surrounding primary dendrites are identical, and (2) wide variation in orientations of the aluminum in the eutectic. (C) 2001 Elsevier Science Inc. All rights reserved.

Cytological basis of photoresponsive behavior in a sponge larva

Ontogenetic changes in the photoresponse of larvae from the demosponge Reneira sp. were studied by analyzing the swimming paths of individual larvae exposed to diffuse white light. Larvae swam upward upon release from the adult, but were negatively phototactic until at least 12 hours after release. The larval photoreceptors are presumed to be a posterior ring of columnar monociliated epithelial cells that possess 120-mum-long cilia and pigment-filled protrusions. A sudden increase in light intensity caused these cilia to become rigidly straight. If the light intensity remained high, the cilia gradually bent over the pigmented vesicles in the adjacent cytoplasm, and thus covered one entire pole of the larva. The response was reversed upon a sudden decrease in light intensity. The ciliated cells were sensitive to changes in light intensity in larvae of all ages. This response is similar to the shadow response in tunicate larvae or the shading of the photoreceptor in Euglena and is postulated to allow the larvae to steer away from brighter light to darker areas, such as under coral rubble-the preferred site of the adult sponge on the reef flat. In the absence of a coordinating system in cellular sponges, the spatial organization and autonomous behavior of the pigmented posterior cells control the rapid responses to light shown by these larvae.

Effect of water temperature and oxygen levels on the diving behavior of two freshwater turtles: Rheodytes leukops and Emydura macquarii

Rheodytes leukops is a bimodally respiring turtle that extracts oxygen from the water chiefly via two enlarged cloacal bursae that are lined with multi-branching papillae. The diving performance of R. leukops was compared to that of Emydura macquarii, a turtle with a limited ability to acquire aquatic oxygen. The diving performance of the turtles was compared under aquatic anoxia (0 mmHg), hypoxia (80 mmHg) and normoxia (155 mmHg) at 15, 23, and 30degreesC. When averaged across all temperatures the dive duration of R. leukops more than doubled from 22.4 +/- 7.65 min under anoxia to 49.8 +/- 19.29 min under normoxic conditions. In contrast, aquatic oxygen level had no effect on the dive duration of E. macquarii. Dive times for both species were significantly longer at the cooler temperature, and the longest dive recorded for each species was 538 min and 166 min for R. leukops and E. macquarii, respectively. Both species displayed a pattern of many short dives punctuated by occasional long dives irrespective of temperature or oxygen regime. Rheodytes leukops, on average, spent significantly less time (42 +/- 2 sec) at the surface per surfacing event than did E. macquarii (106 +/- 20 sec); however, surface times for both species were not related to either water temperature or oxygen level.

Mating behavior of Trissolcus basalis (Wollaston) (Hymenoptera : Scelionidae): Potential for outbreeding in a predominantly inbreeding species

The mating behavior of the quasi-gregarious egg parasitoid Trissolcus basalis (Wollaston) was investigated under field conditions. Trissolcus basalis has female-biased sex ratios and is a protandrous species, with males emerging 1-2 days before females. Males competed aggressively for control of the egg mass, with one male assuming dominance and control of the egg mass, although changes in dominance occurred at least once on each egg mass observed. Typical mating behavior involved the dominant male mating his sisters immediately upon their emergence from the egg mass. These behaviors are characteristic of an inbreeding species that manifests local mate competition. However, several aspects of the mating behavior of T. basalis are inconsistent with that of an inbreeding species. Over 18% of emerging females were not mated by the dominant male upon emergence, 13% of females were not observed to be mated at all and may have left their natal site as virgins, 25% of females were mated multiple times and sometimes by multiple males, females remained near the natal site for up to several hours after emergence before emigrating, and males dispersed away from the natal site during female emergence. Trissolcus basalis may be a predominantly inbreeding species but its emergence and mating behavior suggest that low-frequency outbreeding is also likely to occur.

Dynamic Behavior of the Jahn-Teller distorted Cu(H2O)(6)(2+) ion in Cu2+ doped Cs-2[Zn(H2O)(6)](ZrF6)(2) and the crystal structure of the host lattice

The temperature dependence of the X- and Q-band EPR spectra of Cs-2[Zn(H2O)(6)](ZrF6)(2) containing similar to1% Cu2+ is reported. All three molecular g-values vary with temperature, and their behavior is interpreted using a model in which the potential surface of the Jahn-Teller distorted Cu(H2O)(6)(2+) ion is perturbed by an orthorhombic strain induced by interactions with the surrounding lattice. The strain parameters are significantly smaller than those reported previously for the Cu(H2O)(6)(2+) ion in similar lattices. The temperature dependence of the two higher g-values suggests that in the present compound the lattice interactions change slightly with temperature. The crystal structure of the Cs-2[Zn(H2O)(6)](ZrF6)(2) host is reported, and the geometry of the Zn(H2O)(6)(2+) ion is correlated with lattice strain parameters derived from the EPR spectrum of the guest Cu2+ complex.

Improving attitude-behavior correspondence through exposure to normative support from a salient ingroup

Two experiments were conducted to test predictions derived from social identity/self-categorization theory concerning the role of group norms in attitude-behavior consistency. In Experiment 1, 160 students who could be classified as having a more or less certain target attitude were exposed to attitude congruent versus incongruent normative support from a relevant reference group (own university) under conditions of low versus high group salience. Experiment 2 was very similar in design and methodology (N=180), but a different correlate of attitude accessibility was used (an experimental manipulation of repeated expression), the target attitude was changed, and the reference group was gender. Across the 2 experiments there was consistent support for the hypothesis that participants would behave more in accordance with their attitudes when they received normative support for, rather than opposition to, their original attitude from a relevant reference group (i.e., their ingroup, not an outgroup). There was slightly weaker support for the second hypothesis that this effect would be stronger under high-than low-salience conditions. The third hypothesis (see Fazio, 1986), that attitude certainty and repeated expression of the attitude would strengthen attitude-behavior consistency, was well supported, as was the expectation that accessibility effects would be independent of reference group norm effects on attitude-behavior consistency.

Modelling of microstructure formation and evolution during solidification

A comprehensive probabilistic model for simulating microstructure formation and evolution during solidification has been developed, based on coupling a Finite Differential Method (FDM) for macroscopic modelling of heat diffusion to a modified Cellular Automaton (mCA) for microscopic modelling of nucleation, growth of microstructures and solute diffusion. The mCA model is similar to Nastac's model for handling solute redistribution in the liquid and solid phases, curvature and growth anisotropy, but differs in the treatment of nucleation and growth. The aim is to improve understanding of the relationship between the solidification conditions and microstructure formation and evolution. A numerical algorithm used for FDM and mCA was developed. At each coarse scale, temperatures at FDM nodes were calculated while nucleation-growth simulation was done at a finer scale, with the temperature at the cell locations being interpolated from those at the coarser volumes. This model takes account of thermal, curvature and solute diffusion effects. Therefore, it can not only simulate microstructures of alloys both on the scale of grain size (macroscopic level) and the dendrite tip length (mesoscopic level), but also investigate nucleation mechanisms and growth kinetics of alloys solidified with various solute concentrations and solidification morphologies. The calculated results are compared with values of grain sizes and solidification morphologies of microstructures obtained from a set of casting experiments of Al-Si alloys in graphite crucibles.

Predictors of cheating behavior at a university: A lesson from the psychology of work

The present study investigated students' behavior across academic departments to establish how personality, demographic, educational, attitudinal, and climate (both psychological and departmental) predicted self-reported cheating behavior at a university, Participants were 107 students from a variety of academic disciplines, The results explain 50.5% of the variability in self-reported cheating behavior in terms of demographic (male, school education qualifications), departmental climate, and individual differences (Lie and Neuroticism scales), We concluded that an expanded theoretical perspective (utilizing a wide range of person and situation variables) explained more variability than would otherwise be explained from any single perspective, and that findings from the literature of integrity at work generalize to educational settings. Finally, we discuss the limitations and implications of this research.

Rumors and stable-cause attribution in prediction and behavior

Two stock-market simulation experiments investigated the notion that rumors that invoke stable-cause attributions spawn illusory associations and less regressive predictions and behavior. In Study 1, illusory perceptions of association and stable causation (rumors caused price changes on the day after they appeared) existed despite rigorous conditions of nonassociation (price changes were unrelated to rumors). Predictions (recent price trends will continue) and trading behavior (departures from a strong buy-low-sell-high strategy) were both anti-regressive. In Study 2, stability of attribution was manipulated via a computerized tutorial. Participants taught to view price-changes as caused by stable forces predicted less regressively and departed more from buy-low-sell-high trading patterns than those taught to perceive changes as caused by unstable forces. Results inform a social cognitive and decision theoretic understanding of rumor by integrating it with causal attribution, covariation detection, and prediction theory. (C) 2002 Elsevier Science (USA). All rights reserved.

Behavior of argon gas release from manganese oxide minerals as revealed by Ar-40/Ar-39 laser incremental heating analysis

Manganese oxides in association with paleo-weathering may provide significant insights into the multiple factors affecting the formation and evolution of weathering profiles, such as temperature, precipitation, and biodiversity. Laser probe step-heating analysis of supergene hollandite and cryptomelane samples collected from central Queensland, Australia, yield well-defined plateaus and consistent isochron ages, confirming the feasibility, dating very-fined supergene manganese oxides by Ar-40/(39) Ar technique. Two distinct structural sites hosting Ar isotopes can be identified in light of their degassing behaviors obtained by incremental heating analyses. The first site, releasing its gas fraction at the laser power 0.2-0.4 W, yields primarily Ar-40(atm), Ar-38(atm), and Ar-36(atm), (atmospheric Ar isotopes). The second sites yield predominantly Ar-40* (radiogenic Ar-40), Ar-39(K), and Ar-38(K) (nucleogenic components), at similar to0.5-1.0 W. There is no significant Ar gas released at the laser power higher than 1.0 W, indicating the breakdown of the tunnel sites hosting the radiogenic and nucleogenic components. The excellent match between the degassing behaviors of Ar-40*, Ar-39(K), and Ar-38(K) suggests that these isotopes occupy the same crystallographic sites and that Ar-39(K) loss from the tunnel site by recoil during neutron irradiation and/or bake-out procedure preceding isotopic analysis does not occur. Present investigation supports that neither the overwhelming atmospheric Ar-40 nor the very-fined nature of the supergene manganese oxides poses problems in extracting meaningful weathering geo-chronological information by analyzing supergene manganese oxides minerals.