Influence of geomagnetic activity on the occurrence of midlatitude ionogram-recorded spread-F

Delayed spread-F occurrence as recorded by ionograms, following geomagnetic activity (GA) has been investigated using data from 88 stations located around the world. The spread-F occurrence is delayed progressively from one to three days, from subauroral to midlatitude regions. The equatorial latitudes show suppressed activity. An examination of daily spread-F occurrence values relative to the AE index reveals not only a main delay of one day, but also delays of two and three days. These delays involve principally GA occurring around 0600 hrs LT.

Layered silicate nanocomposites based on various high-functionality epoxy resins. Part II: The influence of an organoclay on the rheological behavior of epoxy prepolymers

The effect of an organically surface modified layered silicate on the viscosity of various epoxy resins of different structures and different functionalities was investigated. Steady and dynamic shear viscosities of the epoxy resins containing 0-10 wt% of the organoclay were determined using parallel plate rheology. Viscosity results were compared with those achieved through addition of a commonly used micron-sized CaCO3 filler. It was found that changes in viscosities due to the different fillers were of the same order, since the layered silicate was only dispersed on a micron-sized scale in the monomer (prior to reaction), as indicated by X-ray diffraction measurements. Flow activation energies at a low frequency were determined and did not show any significant changes due to the addition of organoclay or CaCO3. Comparison between dynamic and steady shear experiments showed good agreement for low layered silicate concentrations below 7.5 wt%, i.e. the Cox-Merz rule can be applied. Deviations from the Cox-Merz rule appeared at and above 10 wt%, although such deviations were only slightly above experimental error. Most resin organoclay blends were well predicted by the Power Law model, only concentrations of 10 wt% and above requiring the Herschel-Buckley (yield stress) model to achieve better fits. Wide-angle X-ray measurements have shown that the epoxy resin swells the layered silicate with an increase in the interlayer distance of approximately 15 Angstrom, and that the rheology behavior is due to the lateral, micron-size of these swollen tactoids.

Layered silicate nanocomposites based on various high-functionality epoxy resins: The influence of an organoclay on resin cure

The influence of an organically modified clay on the curing behavior of three epoxy systems widely used in the aerospace industry and of different structures and functionalities, was studied. Diglycidyl ether of bisphenol A (DGEBA), triglycidyl p-amino phenol (TGAP) and tetraglycidyl diamino diphenylmethane (TGDDM) were mixed with an octadecyl ammonium ion modified organoclay and cured with diethyltoluene diamine (DETDA). The techniques of dynamic mechanical thermal analysis (DMTA), chemorheology and differential scanning calorimetry (DSC) were applied to investigate gelation and vitrification behavior, as well as catalytic effects of the clay on resin cure. While the formation of layered silicate nanocomposite based on the bifunctional DGEBA resin has been previously investigated to some extent, this paper represents the first detailed study of the cure behavior of different high performance, epoxy nanocomposite systems.

Influence of growth hormone on the mandibular condylar cartilage of rats

Growth hormone (GH) stimulates mandibular growth but its effect on the mandibular condylar cartilage is not well. understood. Objective: This study was designed to understand the influence of GH on mitotic activity and on chondrocytes maturation. The effect of GH on cartilage thickness was also determined. Design: An animal model witt differences in GH status was determined by comparing mutant Lewis dwarf rats with reduced pituitary GH synthesis (dwarf), with normal rats and dwarf animals treated with GH. Six dwarf rats were injected with GH for 6 days, while other six normal rats and six dwarf rats composed other two groups. Mandibular condylar tissues were processed and stained for Herovici's stain and immunohistochemistry, for proliferating cell nuclear antigen (PCNA) and alkaline phosphatase (ALP). Measurements of cartilage thickness as well as the numbers of immunopositive cells for each antibody were analysed by one-way analysis of variance. Results: Cartilage thickness was significantly reduced in the dwarf animals treated with GH. PCNA expression was significant lower in the dwarf rats, but significantly increased when these animals were treated with GH. ALP expression was significant higher in the dwarf animals, while it was significantly reduced in the dwarf animals treated with GH. Conclusions: The results from this study showed that GH stimulates mitotic activity and delays cartilage cells maturation in the mandibular condyte. This effect at the cellular Level may produce changes in the cartilage thickness. (C) 2004 Elsevier Ltd. All rights reserved.

The influence of coating materials on some properties of alginate beads and survivability of microencapsulated probiotic bacteria

The probiotics, Lactobacillus acidophilus 547, Bifidobacterium bifidum ATCC 1994, and Lactobacillus casei 01, were encapsulated into uncoated calcium alginate beads and the same beads were coated with three types of material, chitosan, sodium alginate, and poly-L-lysine in combination with alginate. The thickness of the alginate beads increased with the addition of coating materials. No differences were detectable in the bead strength by texture analysis or in the thickness of the beads with different types of coating materials by transmission electron microscopy. The survivability of three probiotics in uncoated beads, coated beads, and as free cells (unencapsulated) was conducted in 0.6% bile salt solution and simulated gastric juice (pH 1.55) followed by incubation in simulated intestinal juice with and without 0.6% bile salt. Chitosan-coated alginate beads provided the best protection for L. acidophilus and L. casei in all treatments. However, B. bifidum did not survive the acidic conditions of gastric juice even when encapsulated in coated heads. (C) 2004 Elsevier Ltd. All rights reserved.

The influence of substrate kinetics on the microbial community structure in granular anaerobic biomass

The development of a strong, active granular sludge bed is necessary for optimal operation of upflow anaerobic sludge blanket reactors. The microbial and mechanical structure of the granules may have a strong influence on desirable properties such as growth rate, settling velocity and shear strength. Theories have been proposed for granule microbial structure based on the relative kinetics of substrate degradation, but contradict some observations from both modelling and microscopic studies. In this paper, the structures of four granule types were examined from full-scale UASB reactors, treating wastewater from a cannery, a slaughterhouse, and two breweries. Microbial structure was determined using fluorescence in situ hybridisation probing with 16S rRNA-directed oligonucleotide probes, and superficial structure and microbial density (volume occupied by cells and microbial debris) assessed using scanning electron microscopy (SEM), and transmission electron microscopy (TEM). The granules were also modelled using a distributed parameter biofilm model, with a previously published biochemical model structure, biofilm modelling approach, and model parameters. The model results reflected the trophic structures observed, indicating that the structures were possibly determined by kinetics. Of particular interest were results from simulations of the protein grown granules, which were predicted to have slow growth rates, low microbial density, and no trophic layers, the last two of which were reflected by microscopic observations. The primary cause of this structure, as assessed by modelling, was the particulate nature of the wastewater, and the slow rate of particulate hydrolysis, rather than the presence of proteins in the wastewater. Because solids hydrolysis was rate limiting, soluble substrate concentrations were very low (below Monod half saturation concentration), which caused low growth rates. (C) 2003 Elsevier Ltd. All rights reserved.

Influence of socioeconomic deprivation on the primary care burden and treatment of patients with a diagnosis of heart failure in general practice in Scotland: population based study

Objectives To examine whether there are socioeconomic gradients in die incidence, prevalence, treatment, and follow up of patients with heart failure in primary care. Design Population based study. Setting 53 general practices (307741 patients) participating in the Scottish continuous morbidity recording project between 1 April 1999 and 31 March 2000. Participants 2186 adults with heart failure. Main outcome measures Comorbid diagnoses, frequency of visits to general practitioner, and prescribed drugs. Results 2186 patients with heart failure were seen (prevalence 7.1 per 1000 population, incidence 2.0 per 1000 population). The age and sex standardised incidence of heart failure increased with greater socioeconomic deprivation, from 1.8 per 1000 population in the most affluent stratum to 2.6 per 1000 population in the most deprived stratum (odds ratio 1.44, P=0.0003). On average, patients were seen 2.4 times yearly, but follow up rates were less frequent with increasing socioeconomic deprivation (from 2.6 yearly in the most affluent subgroup to 2.0 yearly in the most deprived subgroup, P=0.00009). Overall, 812 (80.6%) patients were prescribed diuretics, 396 (39.3%) angiotensin converting enzyme inhibitors, 216 (21.4%) beta blockers, 208 (20.7%) digoxin, and 86 (8.5%) spironolactone. The wide discrepancies in prescribing between different general practices disappeared after adjustment for patient age and sex. Prescribing patterns did not vary by deprivation categories on univariate or multivariate analyses. Conclusions Compared with affluent patients, socioeconomically deprived patients were 44% more likely to develop heart failure but 23% less likely to see their general practitioner on an ongoing basis. Prescribed treatment did not differ across socioeconomic gradients.

Influence of explosive energy on the strength of the rock fragments and SAG mill throughput

Extensive in-situ testings has shown that blast fragmentation influences the performance of downstream processes in a mine, and as a consequence, the profit of the whole operation can be greatly improved through optimised fragmentation. Other unit operations like excavation, crushing and grinding can all be assisted by altering the blast-induced fragmentation. Experimental studies have indicated that a change in blasting practice would not only influence fragmentation but fragment strength as well. The strength of the fragments produced in a blast is clearly important to the performance of the crushing and grinding circuit as it affects the energy required to break the feed to a target product size. In order to validate the effect of blasting on fragment strength several lumps of granite were blasted, under controlled conditions, using three very different explosive products. The resulting fragments were subjected to standard comminution ore characterisation tests. Obtained comminution parameters were then used to simulate the performance of a SAG mill. Modelling results indicate that changes in post blast residual rock fragment strength significantly influences the performance of the SAG mill, producing up to a 20% increase in throughput. (c) 2004 Elsevier Ltd. All rights reserved.

Influence of growth hormone on the craniofacial complex of transgenic mice

Growth hormone (GH) secretion affects bone and cartilage physiology. This study investigated the effect of GH on the size of the craniofacial structures and their angular relationship. Three different models of mice with a genetically altered GH axis were used: GH excess (giant), dwarf GH antagonist (dwarf-Ant), and dwarf GH receptor knockout (dwarf-KO) mice. Each model was compared with the corresponding wild type (Wt). Five craniofacial distances were analysed: craniofacial length, upper face height, mandibular anterior height, mandibular ramus length, and mandibular corpus length. In addition, upper and lower incisor lengths and four angular relationships, nasal bone with cranial base, maxillary plane with cranial base, mandibular plane with cranial base, and the angle of the mandible, were determined. Data were analysed by one-way ANOVA. Craniofacial length, upper face height and mandibular corpus length were significantly increased in the giant mice and significantly reduced in the dwarf mice. Mandibular anterior height and mandibular ramus length were significantly affected in the dwarf-KO mice but not in the giant mice. The length of both the upper and lower incisors was significantly increased and reduced in the giant and dwarf-KO mice, respectively. In addition, the angle of the mandible was significantly increased in the giant mice and significantly reduced in the dwarf mice. It is concluded that GH plays a major role in the growth and development of the craniofacial complex by directly and indirectly modulating the size and the angular relationships of the craniofacial structures, including the incisor teeth.

Influence of Observer Presence on Pacific Damsel Bug Behavior: Who is Watching Whom?

When direct observations are used to study animal behavior the presence of the observer may alter the animal and hence influence the data being collected, yet few studies have quantified this effect. We conducted direct observation studies in the glasshouse to assess the relative influence of observer presence on the behavior of Pacific damsel bugs, Nabis kinbergii, a potentially important predator of crop pests. Comparisons of predator activity, predator distribution, prey (Helicoverpa armigera) mortality and prey distribution between frequently observed and minimally observed treatments, during diurnal and nocturnal observation sessions showed that the frequency of observer presence had no apparent impact on Pacific damsel bug behavior. This is the first documented test of the impact of observer presence in an insect system. To place our results in context, we reviewed 15 papers on the influence of observer presence in a range of animals. We established that just over half of these papers found evidence for an effect. Nevertheless, direct observations should be useful in further studies of Pacific damsel bug behavior, and researchers using direct observations to study the behavior of other animals should be cognizant of observer effects during design and interpretation of their study.

Boundary element method predictions of the influence of the electrolyte on the galvanic corrosion of AZ91D coupled to steel

This research investigated the galvanic corrosion of the magnesium alloy AZ91D coupled to steel. The galvanic current distribution was measured in 5% NaCl solution, corrosive water and an auto coolant. The experimental measurements were compared with predictions from a Boundary Element Method (BEM) model. The boundary condition, required as an input into the BEM model, needs to be a polarization curve that accurately reflects the corrosion process. Provided that the polarization curve does reflect steady state, the BEM model is expected to be able to reflect steady state galvanic corrosion.

Influence of anodising current on the corrosion resistance of anodised AZ91D magnesium alloy

The thickness, chemical composition and microstructure of anodised coatings formed on magnesium alloy AZ91D at various anodising current densities were measured. It was found that all these parameters could be affected by anodising current density, and hence the coatings formed at different anodising current densities had different corrosion resistances. This suggests that the corrosion performance of an anodised coating could be improved if a properly designed current waveform is used for anodising. In addition, based on the experimental results, some physical, chemical and electrochemical reactions involved in the anodising process were proposed to explain the anodising behaviour in this paper. (c) 2005 Elsevier Ltd. All rights reserved.