Energy intake and energy expenditure in elite lightweight female rowers

Purpose: The training program undertaken by many athletes will affect directly the total, habitual energy requirements of that individual. Unless that energy requirement is met via the diet and or supplementation, chronic negative energy balance will ensue, which will have both short-term and long-term effects not only on performance but also on general health. The aim of this research was therefore to determine the energy expenditure (EE) and hence energy requirements of lightweight female rowers and, further, to compare this with their self-reported energy intake (EI). Methods: The El of seven lightweight female rowers was measured using a self-reported 4-d weighed dietary record. EE was determined using the doubly labeled water (DLW) technique over a 14-d period. Results: The mean (+/-SD) age, height, and weight of the subjects was 20 (+/-1.1) yr, 168.8 (+/-4.7) cm, and 60.9 (+/-23) kg, respectively. The rowers self-reported El was 2214 (+/-313) kcal.d(-1) and their total EE was 3957 (+/-1219) kcal.d(-1). After adjusting total EE for changes in body weight (mean (+/-SD) - 1.2 (+/-1.2) kg), the comparison between adjusted El and reported showed a bias to underreporting of 1133 (+/-1539) kcal.d(-1) or 34%. The bias was not consistent across adjusted El, and two of the seven subjects overreported their intake. Conclusions: Due to the underreporting of EI, diet recording may not be an appropriate way of assessing energy requirements in lightweight female rowers. A benefit of accurately determining energy requirements, as with DLW, is that female lightweight rowers will be able to successfully manipulate their EI and achieve the set weight cut-off for participation without compromising their health or performance.

Breeding for resistance to lentil Ascochyta blight

Ascochyta blight, caused by Ascochyta lentis , is one of the most globally important diseases of lentil. Breeding for host resistance has been suggested as an efficient means to control this disease. This paper summarizes existing studies of the characteristics and control of Ascochyta blight in lentil, genetics of resistance to Ascochyta blight and genetic variations among pathogen populations (isolates). Breeding methods for control of the disease are discussed. Six pathotypes of A. lentis have been reported. Many resistant cultivars/lines have been identified in both cultivated and wild lentil. Resistance to Ascochyta blight in lentil is mainly under the control of major genes, but minor genes also play a role. Current breeding programmes are based on crossing resistant and high-yielding cultivars and multilocation testing. Gene pyramiding, exploring slow blighting and partial resistance, and using genes present in wild relatives will be the methods used in the future. Identification of more sources of resistance genes, good characterization of the host-pathogen system, and identification of molecular markers tightly linked to resistance genes are suggested as the key areas for future study.

The prediction of sharkskin instability observed during film blowing

The characteristics of sharkskin surface instability for linear low density polyethylene are studied as a function of film blowing processing conditions. By means of scanning electron microscopy and surface profilometry, is it found that for the standard industrial die geometry studied, sharkskin only occurs on the inside of the film bubble. Previous work suggests that this instability may be due to critical extensional stress levels at the exit of the die. Isothermal integral viscoelastic simulations of the annular extrusion process are reported, and confirm that the extensional stress at the die exit is large enough to cause local melt rupture. However the extensional stress level at the outer die wall predicts melt rupture of the outside bubble surface also, which contradicts the experimental findings. A significant temperature gradient is expected to exist across the die gap at the exit of the die, due to the external heating of the die and the low conductivity, of the polymer melt. It is shown that a gradient of 20 degreesC is required to cause sharkskin to only appear on the inner bubble surface.

Residential mobility in the Seoul metropolitan region: Who, where and why?

This article presents data on residential mobility for the Seoul Metropolitan Region. It addresses two questions-why do households move and who moves and finds that like research undertaken in other cities that a wide range of factors impact on the residential mobility process. Key outcomes include the impact of housing dissatisfaction on residential mobility and the impact that life cycle, period of residence and housing and dwelling characteristics have on discerning between movers and non-movers.

Effect of functional gain on satisfaction with medical rehabilitation after stroke

Objective: To examine the association between gain in motor and cognitive functional status with patient satisfaction 3-6 mo after rehabilitation discharge. Design: Patient satisfaction and changes in functional status were examined in 18,375 patients with stroke who received inpatient medical rehabilitation. Information was obtained from 144 hospitals and rehabilitation facilities contributing records to the Uniform Data System for Medical Rehabilitation and the National Follow-up Services. Results: Data analysis revealed significant (P < 0.05) differences in satisfaction responses based on whether information was collected from patient self-report or from a family member proxy, and the two subsets were analyzed separately. Logistic regression revealed the following significant predictors of satisfaction for data collected from stroke patients: cognitive and motor gain, rehospitalization, who the patient was living with at follow-up, age, and follow-up therapy. In the patient-reported data subset, compared with patients who showed improved cognitive or motor functional status, those with no change, respectively, had a 31% and 33% reduced risk of dissatisfaction. In addition, rehospitalized patients had a higher risk of dissatisfaction. For the proxy reported data subset, significant influences on satisfaction were health maintenance, rehospitalization, stroke type, ethnicity, cognitive FIM(TM) gain, length of stay, and follow-up therapy. Conclusions: Ratings of satisfaction with rehabilitation services were affected by change in functional status and whether the information was collected from patient rating or proxy response.

A metalinguistic approach to deconstructing the concepts of 'face' and 'politeness' in Chinese, English and Japanese

In this paper we investigate the concepts of 'face' and 'politeness'. We introduce a metalanguage which we believe is a framework for simplifying the analysis of 'face' and 'politeness'. This metalanguage is based on the observation that both 'face' and 'politeness' involve external evaluations of people. This common element is represented in the metalanguage as B what A shows A thinks of B and what B thinks A thinks of B. The implications of the metalanguage for the analysis of Chinese mian and lion ('face') and English face are then discussed. This is followed by an analysis of examples of politeness in English and teineisa ('politeness') in Japanese. We conclude that the metalanguage may be further developed for use in comparisons of 'face' and 'politeness' across cultures. (C) 2003 Elsevier B.V. All rights reserved.