Binding and internalization of the melanocyte stimulating hormone receptor ligand [Nle(4), D-Phe(7)]alpha-MSH in B16 melanoma cells

The current study aims to ascertain the fate of the melanocyte stimulating hormone (MSH) receptor and its ligand [Nle(4), D-Phe(7)]alpha-MsH (NDP-MSH) following binding to murine B16 melanoma cells. Cells were incubated with [I-125]-NDP-MSH for up to 180 min and binding, internalization and degradation determined. Intracellular trafficking of the radiolabel was assessed !using Percoll density gradient centrifugation of homogenized cells. Receptor down-regulation and receptor mRNA levels were also measured over 96 hr after exposure to 1 mu M ligand. NDP-MSH accumulation increased with time in a temperature-dependent manner and was inhibited by excess peptide. The ligand was rapidly internalized and translocated to the lysosomal compartment where it was degraded. Internalization was accompanied by a loss or down-regulation of cell surface receptors, suggesting internalization of the NDP-MSH-receptor complex. No recycling of the receptors between the plasma membrane and intracellular compartments could be detected in this cell-hue. Approximately 15% of the surface receptors were resistant to down-regulation, possibly indicating receptor heterogeneity. Down-regulation persisted ibr up to 96 hr and was accompanied by a decrease in MSH receptor mRNA levels 48 hr after treatment. However, before this time, transcript levels were the same in treated and control cells. In contrast to what was seen with NDP-MSH, cell surface receptors removed with trypsin wc:re rapidly replaced. These results show that NDP-MSH not only induced MSH receptor :internalization but also inhibited receptor turnover, resulting in a prolonged down-regulation. It is concluded that, in B16 cells, the MSH receptor undergoes ligand-dependent internalization, resulting in a prolonged down-regulation. Copyright (C) 1996 Elsevier Science Ltd

Can occupational therapy intervention play a part in maintaining independence and quality of life in older people? A randomised controlled trial Jeannine Liddle 1 , 2 , Lyn March 3 , Barbara Carfrae 4 , Terence Finnegan 5 , Jane Druce 6 , Jennifer Schwarz 7 Peter Brooks

The main objective of this study was to see if older people could maintain their quality of life and independence after their homes had been modified and they were using community services as recommended by an occupational therapist. There were 167 study participants aged 69 to 94 years from the Northern Sydney Area, After being assessed at home by an occupational therapist, 105 were randomly allocated to one of two groups, to either have or not have the occupational therapist's recommendations carried out, They were assessed again after six months, A third group did not require any intervention, This group was followed up by telephone and postal questionnaire at six months. The main outcome measures used were the Sickness Impact Profile, the Philadelphia Geriatric Center Morale Scale, the Life Satisfaction Index, assessment of Activities of Daily Living, the Health Assessment Questionnaire and change in residence. After six months there were no difference in outcomes among the three groups. Most study participants remained at a satisfactory level on each measure. Three people had died, One had moved to hostel care and one had moved to a nursing home. A further 14 from the group having no intervention had withdrawn from the study, A secondary objective of this study was to indicate the responsiveness of these outcome measures to change in the short term (over six months) in an elderly population. Twelve-month assessments are in progress and may indicate what to expect from these outcome measures in the medium term.

Eutectic solidification mode in sodium modified Al-7 mass %Si-3.5 mass %Cu-0.2 mass %Mg casting alloys

The influence of sodium (Na) on nucleation and growth of the Al-Si eutectic in a commercial hypoeutectic Al-Si-Cu-Mg foundry alloy has been investigated. The microstructural evolution during eutectic solidification was studied by a quenching technique. By comparing the orientation of the aluminium in the eutectic to that of the surrounding primary aluminium dendrites by EBSD, the eutectic solidification mode could be determined. The results show that the eutectic solidification starts near the mould wall and evolves with front growth opposite the thermal gradient on a macro-scale, and on a micro-scale with independent heterogeneous nucleation of eutectic grains in interdendritic spaces. Na-modified alloys therefore behave significantly differently from those modified by other elemental additions.