Characterisation of grafted supports used for solid-phase synthesis

A series of 'pellicular' type supports were fabricated by direct gamma-radiation-mediated graft polymerisation of styrene onto polypropylene, followed by aminomethylation. Raman spectroscopy was used for measuring the level of penetration of polystyrene graft into polypropylene, and other structural features such as density of graft and depth of functionalisation. The kinetics of the coupling of fluorenylmethylcarbamate (Fmoc)-labelled amino acids, to the aminomethylated polystyrene grafts have been measured by UV absorption followed cleavage of the Fmoc chromophore. The Raman spectroscopy results showed that for this series of experiments the calculated rate coefficient for coupling of Fmoc-labelled amino acids was primarily dependent on graft thickness, but was also influenced by the proportion of polystyrene graft to polypropylene. In general, it was also shown that with increasing loading capacity of support the calculated rate coefficient for amino-acid coupling decreased correspondingly. In addition, a support that had both a high rate coefficient and a high loading capacity was prepared from polypropylene base material with a co-continuous porous structure (high surface area). (C) 2003 Society of Chemical Industry.

Large amplitude vibration of thermo-electro-mechanically stressed FGM laminated plates

This paper presents a large amplitude vibration analysis of pre-stressed functionally graded material (FGM) laminated plates that are composed of a shear deformable functionally graded layer and two surface-mounted piezoelectric actuator layers. Nonlinear governing equations of motion are derived within the context of Reddy's higher-order shear deformation plate theory to account for transverse shear strain and rotary inertia. Due to the bending and stretching coupling effect, a nonlinear static problem is solved first to determine the initial stress state and pre-vibration deformations of the plate that is subjected to uniform temperature change, in-plane forces and applied actuator voltage. By adding an incremental dynamic state to the pre-vibration state, the differential equations that govern the nonlinear vibration behavior of pre-stressed FGM laminated plates are derived. A semi-analytical method that is based on one-dimensional differential quadrature and Galerkin technique is proposed to predict the large amplitude vibration behavior of the laminated rectangular plates with two opposite clamped edges. Linear vibration frequencies and nonlinear normalized frequencies are presented in both tabular and graphical forms, showing that the normalized frequency of the FGM laminated plate is very sensitive to vibration amplitude, out-of-plane boundary support, temperature change, in-plane compression and the side-to-thickness ratio. The CSCF and CFCF plates even change the inherent hard-spring characteristic to soft-spring behavior at large vibration amplitudes. (C) 2003 Elsevier B.V. All rights reserved.

Postbuckling of piezoelectric FGM plates subject to thermo-electro-mechanical loading

In this paper, we examine the postbuckling behavior of functionally graded material FGM rectangular plates that are integrated with surface-bonded piezoelectric actuators and are subjected to the combined action of uniform temperature change, in-plane forces, and constant applied actuator voltage. A Galerkin-differential quadrature iteration algorithm is proposed for solution of the non-linear partial differential governing equations. To account for the transverse shear strains, the Reddy higher-order shear deformation plate theory is employed. The bifurcation-type thermo-mechanical buckling of fully clamped plates, and the postbuckling behavior of plates with more general boundary conditions subject to various thermo-electro-mechanical loads, are discussed in detail. Parametric studies are also undertaken, and show the effects of applied actuator voltage, in-plane forces, volume fraction exponents, temperature change, and the character of boundary conditions on the buckling and postbuckling characteristics of the plates. (C) 2003 Elsevier Science Ltd. All rights reserved.

Effect of storage time and conditions on the cotyledon cell wall of the adzuki bean (Vigna angularis)

Two varieties of adzuki grown in Australia, Bloodwood and Erimo, were stored for up to 6 months at three temperatures (10, 20 and 30 degreesC), and two relative humidities (RH; 40 and 65%). The amount of cell wall material increased with time under all storage conditions. This increase was greatest at 30 degreesC and 40% RH. Storage time and conditions did not affect the total pectin levels in the cell wall. Erimo constantly exhibited a higher total pectin level than Bloodwood. The Bloodwood soluble pectin, Ca++ and Mg++ and Erimo Ca++ in the cell wall remained stable during storage, while the Erimo soluble pectin and Mg++ exhibited a slight decrease at 20 and 30 degreesC after 3 months of storage. (C) 2002 Elsevier Science Ltd. All rights reserved.

Subsoil nitrogen mineralisation and its potential to contribute to NH4 accumulation in a Vertosol

High concentrations of NH4+ (up to 270 kg N/ha) have been observed in a Vertosol below 1 m depth in south-east Queensland. This study examined the possibility that mineralisation associated with the removal of native vegetation (Acacia harpophylla) for cropping was responsible for the production of NH4+. Particularly, the potential contribution of decomposing root material and/or dissolved organic nitrogen (DON) leached into the subsoil after clearing was investigated. The amount of N that was contained within native vegetation root material was determined from an area of native vegetation adjacent to the cleared site containing elevated NH4+ concentrations. In addition, the amount of NH4+ that could be mineralised in the native vegetation soil was determined by monitoring NH4+ concentrations over 360 days in intact cores, and by conducting waterlogged incubations. To determine the rate at which a source of DON leached into the subsoil would mineralise, soil was amended with glutamic acid at a rate of 250 mg N/kg and placed under waterlogged incubation. The possibility that the acidic pH of the subsoil, or the lack of a significant subsoil microbial population, was inhibiting mineralisation was also examined by increasing soil pH from 4.4 to 7.0, and inoculating the subsoil with surface soil microorganisms during waterlogged incubations. Low concentrations of N, approximately 90 kg N/ha between 1.2 and 3 m, were found in the native vegetation root material. In addition, no net N mineralisation was observed in either the extended incubation of intact cores or in the control samples of the waterlogged incubations. Net N mineralisation was also not detected when the subsoil was amended with a source of organic N. Results indicate that this lack of mineralisation is largely due to pH inhibition of the microbial population. It is concluded that the mineralisation of either in situ organic material, or DON transported to the subsoil during leaching events, is unlikely to have significantly contributed to the subsoil NH4 accumulation at the study site.