Quantification of sulfur and sulfur-containing compounds in wastewaters by means of a combination of liquid chromatographic methods

Low-micromolar concentrations of sulfite, thiosulfate and sulfide, present in synthetic wastewater or anaerobic digester effluent, were quantified by means of derivatization with monobromobimane, followed by HPLC separation with fluorescence detection. The concentration of elemental sulfur was determined, after its extraction with chloroform from the derivatized sample, by HPLC with UV detection. Recoveries of sulfide (both matrices), and of thiosulfate and sulfite (synthetic wastewater) were between 98 and 103%. The in-run RSDs on separate derivatizations were 13 and 19% for sulfite (two tests), between 1.5 and 6.6% for thiosulfate (two tests) and between 4.1 and 7.7% for sulfide (three tests). Response factors for derivatives of sulfide and thiosulfate, but not sulfite, were steady over a 13-month period during which 730 samples were analysed. Dithionate and tetrathionate did not seem to be detectable with this method. The distinctness of the elemental sulfur and the derivatizing-agent peaks was improved considerably by detecting elution at 297 instead of 263 nm. (C) 2002 Elsevier Science B.V. All rights reserved.

Modeling of phase equilibrium and vapor adsorption on carbon black based on a combination of a lattice theory and equation of state

A thermodynamic approach is developed in this paper to describe the behavior of a subcritical fluid in the neighborhood of vapor-liquid interface and close to a graphite surface. The fluid is modeled as a system of parallel molecular layers. The Helmholtz free energy of the fluid is expressed as the sum of the intrinsic Helmholtz free energies of separate layers and the potential energy of their mutual interactions calculated by the 10-4 potential. This Helmholtz free energy is described by an equation of state (such as the Bender or Peng-Robinson equation), which allows us a convenient means to obtain the intrinsic Helmholtz free energy of each molecular layer as a function of its two-dimensional density. All molecular layers of the bulk fluid are in mechanical equilibrium corresponding to the minimum of the total potential energy. In the case of adsorption the external potential exerted by the graphite layers is added to the free energy. The state of the interface zone between the liquid and the vapor phases or the state of the adsorbed phase is determined by the minimum of the grand potential. In the case of phase equilibrium the approach leads to the distribution of density and pressure over the transition zone. The interrelation between the collision diameter and the potential well depth was determined by the surface tension. It was shown that the distance between neighboring molecular layers substantially changes in the vapor-liquid transition zone and in the adsorbed phase with loading. The approach is considered in this paper for the case of adsorption of argon and nitrogen on carbon black. In both cases an excellent agreement with the experimental data was achieved without additional assumptions and fitting parameters, except for the fluid-solid potential well depth. The approach has far-reaching consequences and can be readily extended to the model of adsorption in slit pores of carbonaceous materials and to the analysis of multicomponent adsorption systems. (C) 2002 Elsevier Science (USA).

Synthesis and characterization of nano-hetero-structured dy doped CeO2 solid electrolytes using a combination of spark plasma sintering and conventional sintering

Doped ceria (CeO2) compounds are fluorite-type oxides that show oxide ionic conductivity higher than yttria-stabilized zirconia in oxidizing atmosphere. As a consequence of this, considerable interest has been shown in application of these materials for low (500 degrees-650 degrees C) temperature operation of solid oxide fuel cells (SOFCs). To improve the conductivity in dysprosium (Dy) doped CeO2, nano-size round shape particles were prepared using a coprecipitation method. The dense sintered bodies with small grain sizes (< 300 nm) were fabricated using a combined process of spark plasma sintering (SPS) and conventional sintering (CS). Dy-doped CeO2 sintered body with large grains (1.1 mu m) had large micro-domains. The conductivity in the sintered body was low (-3.2 S/cm at 500 degrees C). On the other hand, the conductivity in the specimens obtained by the combined process was considerably improved. The micro-domain size in the grain was minimized using the present process. It is concluded that the enhancement of conductivity in dense specimens produced by the combined process (SPS+CS) is attributable to the microstructural changes within the grains.

Functional-structural plant modelling using a combination of architectural analysis, L-systems and a canonical model of function

This paper presents a new method for producing a functional-structural plant model that simulates response to different growth conditions, yet does not require detailed knowledge of underlying physiology. The example used to present this method is the modelling of the mountain birch tree. This new functional-structural modelling approach is based on linking an L-system representation of the dynamic structure of the plant with a canonical mathematical model of plant function. Growth indicated by the canonical model is allocated to the structural model according to probabilistic growth rules, such as rules for the placement and length of new shoots, which were derived from an analysis of architectural data. The main advantage of the approach is that it is relatively simple compared to the prevalent process-based functional-structural plant models and does not require a detailed understanding of underlying physiological processes, yet it is able to capture important aspects of plant function and adaptability, unlike simple empirical models. This approach, combining canonical modelling, architectural analysis and L-systems, thus fills the important role of providing an intermediate level of abstraction between the two extremes of deeply mechanistic process-based modelling and purely empirical modelling. We also investigated the relative importance of various aspects of this integrated modelling approach by analysing the sensitivity of the standard birch model to a number of variations in its parameters, functions and algorithms. The results show that using light as the sole factor determining the structural location of new growth gives satisfactory results. Including the influence of additional regulating factors made little difference to global characteristics of the emergent architecture. Changing the form of the probability functions and using alternative methods for choosing the sites of new growth also had little effect. (c) 2004 Elsevier B.V. All rights reserved.

Combination therapy with tacrolimus and anti-thymocyte globulin for the treatment of steroid-resistant acute graft-versus-host disease developing during cyclosporine prophylaxis

We report our experience with the combination of anti-thymocyte globulin (ATGAM) and tacrolimus in the treatment of 20 patients with steroid refractory and dependent acute graft-versus-host disease (GVHD) transplanted between August 1996 and February 2000. All patients received cyclosporine-based GVHD prophylaxis. Thirteen patients developed a maximum of grade TV, five grade III and two grade II acute GVHD, with 15 patients being refractory to steroids and five dependent on steroids. Patients were treated with ATGAM (15 mg/kg for 5 d) and tacrolimus (0.025-0.1 mg/kg/d) in addition to continuation of their high-dose steroids and cessation of their cyclosporine. Within 28 d of treatment, we observed eight complete responses (CR), six partial responses (PR) and six with no response. Overall response (CR + PR) was predicted by GVHD severity. Infectious complications occurred in 80% of patients. The median survival was 86.5 d (range, 21-1081 d) with 35% of patients remaining alive, Survival following combination therapy was significantly more likely in men (P < 0.001), skin-only GVHD (P = 0.027), less severe GVHD (P = 0.048), and in responders to tacrolimus and ATGAM (P< 0.001). In conclusion, concurrent introduction of ATGAM and tacrolimus is a promising therapeutic combination for GVHD refractory to steroids and cyclosporine.

Cost-effectiveness of combination peginterferon alpha-2a and ribavirin compared with interferon alpha-2b and ribavirin in patients with chronic hepatitis C

BACKGROUND: Sustained virological response (SVR) is the primary objective in the treatment of chronic hepatitis C (CHC). Results from a recent clinical trial of patients with previously untreated CHC demonstrate that the combination of peginterferon alpha-2a and ribavirin produces a greater SVR than interferon alpha-2b and ribavirin combination therapy. However, the cost-effectiveness of peginterferon alpha-2a plus ribavirin in the U.S. setting has not been investigated. METHODS: A Markov model was developed to investigate cost-effectiveness in patients with CHC using genotype to guide treatment duration. SVR and disease progression parameters were derived from the clinical trials and epidemiologic studies. The impact of treatment on life expectancy and costs were projected for a lifetime. Patients who had an SVR were assumed to remain virus-free for the rest of their lives. In genotype 1 patients, the SVRs were 46% for peginterferon alpha-2a plus ribavirin and 36% for interferon alpha-2b plus ribavirin. In genotype 2/3 patients, the SVRs were 76% for peginterferon alpha-2a plus ribavirin and 61% for interferon alpha-2b plus ribavirin. Quality of life and costs were based on estimates from the literature. All costs were based on published U.S. medical care costs and were adjusted to 2003 U.S. dollars. Costs and benefits beyond the first year were discounted at 3%. RESULTS: In genotype 1, peginterferon alpha-2a plus ribavirin increases quality-adjusted life expectancy (QALY) by 0.70 yr compared to interferon alpha-2b plus ribavirin, producing a cost-effectiveness ratio of $2,600 per QALY gained. In genotype 2/3 patients, peginterferon alpha-2a plus ribavirin increases QALY by 1.05 yr in comparison to interferon alpha-2b plus ribavirin. Peginterferon alpha-2a combination therapy in patients with HCV genotype 2 or 3 is dominant (more effective and cost saving) compared to interferon alpha-2b plus ribavirin. Results weighted by genotype prevalence (75% genotype 1; 25% genotype 2 or 3) also show that peginterferon alpha-2a plus ribavirin is dominant. Peginterferon alpha-2a and ribavirin remained cost-effective (below $16,500 per QALY gained) under sensitivity analyses on key clinical and cost parameters. CONCLUSION: Peginterferon alpha-2a in combination with ribavirin with duration of therapy based on genotype, is cost-effective compared with conventional interferon alpha-2b in combination with ribavirin when given to treatment-naive adults with CHC.

The effects of lead stimulus and reflex stimulus modality on modulation of the blink reflex at very short, short, and long lead intervals

The blink reflex is modulated if a weak lead stimulus precedes the blink-eliciting stimulus. In two experiments, we examined the effects of the sensory modality of the lead and blink-eliciting stimuli on blink modulation. Acoustic, visual, or tactile lead stimuli were followed by an acoustic (Experiment 1) or an electrotactile (Experiment 2) blink-eliciting stimulus at lead intervals of -30, 0, 30, 60, 120, 240, 360, and 4,500 msec. The inhibition of blink magnitude at the short (60- to 360-msec) lead intervals and the facilitation of blink magnitude at the long (4,500-msec) lead interval observed for each lead stimulus modality was relatively unaffected by the blink-eliciting stimulus modality. The facilitation of blink magnitude at the very short (-30- to 30-msec) lead intervals was dependent on the combination of the lead and the blink-eliciting stimulus modalities. Modality specific and nonspecific processes operate at different levels of perceptual processing.

Anesthesia of captive African wild dogs (Lycaon pictus) using a medetomidine-ketamine-atropine combination

Seven captive male African wild dogs (Lycaon pictus) weighing 25-32 kg each, were anesthetized by i.m. injection via hand syringe with a combination of 1.5 mg/kg ketamine, 40 mu g/kg medetomidine, and 0.05 mg/kg atropine. Following endotracheal intubation, each animal was connected to a bain closed-circuit system that delivered 1.5% isoflurane and 2 L/min oxygen. Atipamezole (0.1 mg/kg i.v.; 0.1 mg/kg i.m.) was given at the end of each procedure (60 min following injection of medetomidine/ketamine/atropine). Time to sternal recumbency was 5-8 min. Times to standing after atipamezole administration were 8-20 min. This anesthetic regimen was repeated on three separate occasions (September 2000, February 2002, and October 2002) on all males to perform electroejaculation procedures. Each procedure was < 80 min from injection to standing. Dogs showed excellent muscle relaxation during the procedures. Arterial blood samples were collected at 10-min intervals for blood gases in one procedure (September 2000). Separate venous samples were taken from each dog during each procedure for hematology and biochemistry. These values were within the normal range for this species. Arterial hemoglobin oxygen saturation (SpO2) and heart rate (HR) were monitored continuously in addition to other anesthesia monitoring procedures (body temperature, respiratory rate [RR], capillary refill time, blink response, pupil position, deep pain perception reflex). All dogs maintained relatively stable SpO2 profiles during monitoring, with a mean (+/- SD) SpO2 of 92% +/- 5.4%. All other physiological variables (HR, RR, body temperature, blood pressure) were within normal limits. Following each procedure, normal behavior was noted in all dogs. All the dogs were reunited into the pack at completion of their anesthetic procedures. An injectable medetomidine-ketamine-atropine combination with maintenance by gaseous isoflurane and oxygen provides an inexpensive, reliable anesthetic for captive African wild dogs.