Trophic food web and ecosystem attributes of a water reservoir of the Ria Formosa (south Portugal)

Using a top-down modelling approach, a balanced trophic food web model of a water reservoir of the Ria Formosa lagoonal system was constructed. Few adjustments of input data were necessary to run the model since most of the parameters were estimated at the study site and the characteristics of the water reservoir allowed a high degree of control and precision in terms of sampling and data collection. Trophic levels of the 14 compartments included in the model varied between 1.0 for primary producers and detritus to 3.4 for carnivorous fish and the 14 groups were aggregated in a food chain with six trophic levels. The water reservoir has a detritus based food chain, with the majority of the biomass concentrated in the first two levels, the producers level and the herbivore/detritivore level (97.6%). The transfer efficiencies were low, and decreased with increasing level number, varying between 6.0 and 0.2%. The degree of "ecosystem maturity" was difficult to establish, but several parameters indicate that it could be high. The water reservoir studied, which has similar environmental and ecological characteristics as the Ria Formosa lagoon. is near its carrying capacity. (C) 2004, Elsevier B.V. All rights reserved.

Effect of oxygen on the electrical characteristics of field effect transistors formed from electrochemically deposited films of poly(3-methylthiophene)

Field effect devices have been formed in which the active layer is a thin film of poly(3-methylthiophene) grown electrochemically onto preformed source and drain electrodes. Although a field effect is present after electrochemical undoping, stable device characteristics with a high modulation ratio are obtained only after vacuum annealing at an elevated temperature, and only then if the devices are held in vacuo. The polymer is shown to be p type and the devices operate in accumulation only. The hole mobility in devices thermally annealed under vacuum is around 10 -3 cm 2 V -1 s -1. On exposure to ambient laboratory air, the device conductance increases by several orders of magnitude. This increase may be reversed by subjecting the device to a further high-temperature anneal under vacuum. Subsidiary experiments show that these effects are caused by the reversible doping of the polymer by gaseous oxygen.

Photoconductivity and electrical properties of diamond films grown by MPCVD

The electrical and photoconductive features of as-grown microwave-plasma-assisted chemical-vapour deposition (MPCVD) diamond films are studied in correlation with magnetic results obtained from electron paramagnetic resonance (EPR). Also, the morphology is analysed by atomic force microscopy (AFM) showing [111] crystals with a good uniformity of the deposit. The photoresponse as well the current-voltage features observed show an efficient photogeneration of carriers while the optoelectronic characteristics of the metal-diamond junction have an ideality factor of 1.6 together with a rectification ratio of about 10(4) at +/-2.5 V. The nature of the mechanisms responsible for the conduction is discussed. (C) 1998 Elsevier Science S.A.