Metal speciation dynamics in colloidal ligand dispersions. Part 3: Lability features of steady-state systems

A lability criterion is developed for dynamic metal binding by colloidal ligands with convective diffusion as the dominant mode of mass transport. Scanned stripping chronopotentiometric measurements of Pb(II) and Cd(II) binding by carboxylated latex core-shell particles were in good agreement with the predicted values. The dynamic features of metal ion binding by these particles illustrate that the conventional approach of assuming a smeared-out homogeneous ligand distribution overestimates the lability of a colloidal ligand system. Due to the nature of the spatial distribution of the binding sites, the change in lability of a metal species with changing ligand concentration depends on whether the ligand concentration is varied via manipulation of the pH (degree of protonation) or via the particle concentration. In the former case the local ligand density varies, whereas in the latter case it is constant. This feature provides a useful diagnostic tool for the presence of geometrically constrained binding sites.

Metal speciation dynamics in colloidal ligand dispersions. Part 2: electrochemical lability

We investigate the dynamic nature of metal speciation in colloidal dispersions using a recently proposed theory [J.P. Pinheiro, M. Minor, H.P. Van Leeuwen, Langmuir, 21 (2005) 8635] for complexing ligands that are situated on the surface of the particles. The new approach effectively modifies the finite rates of association/dissociation of the colloidal metal complexes, thus invoking consideration of the two basic dynamic criteria: the association/dissociation kinetics of the volume complexation reaction (the ‘‘dynamic’’ criterion), and the interfacial flux of free metal to a macroscopic surface due to dissociation of complex species (the ‘‘lability’’ criterion). We demonstrate that the conventional approach for homogeneous systems that assume a smeared-out ligand distribution, overestimates both the dynamics and the lability of metal complexes when applied to colloidal ligands. It is also shown that the increase of lability with increasing particle radius, as expected for a homogeneous solution, is moderated for spherical microelectrodes and practically eliminated for planar electrodes.

“Should we all be on Marx’s side?” Contributions of post-marxist discourse theory to the historiography of communism

Drawing on post-marxist discourse theory inspired by the writings of Ernesto Laclau and Chantal Mouffe, this article puts the case for a literature on communism situated at the crossroads of critical theory, cultural studies and historiography. Specific illustration is provided by the author's own research on British communism and the Spanish Civil War. However, the scope of the article is much broader and it is intended as a contribution to the theoretical discussion of future possibilities for communist history-writing. The article concludes that discourse should be regarded neither as a flat surface of tightly knit signifiers nor as an impenetrable monolith of meaning systems. Rather, it should be seen as an inherently dynamic phenomenon, with its own condensations and dispersions along the historical continuum. In this lies its significance for historians of communism.

Application of permeation liquid membrane and scanned stripping chronopotentiometry to metal speciation analysis of colloidal complexes

The potential of permeation liquid membrane (PLM) to obtain dynamic metal speciation information for colloidal complexes is evaluated by measurements of lead(II) and copper(II) complexation by carboxyl modified latex nanospheres of different radii (15, 35, 40 and 65 nm). The results are compared with those obtained by a well characterized technique: stripping chronopotentiometry at scanned deposition potential (SSCP). Under the PLM conditions employed, and for large particles or macromolecular ligands, membrane diffusion is the rate-limiting step. That is, the flux is proportional to the free metal ion concentration with only a small contribution from labile complexes. In the absence of ligand aggregation in the PLM channels, good agreement was obtained between the stability constants determined by PLM and SSCP for both metals.

Electrical characterization of metal-oxide-polymer devices for non-volatile memory applications

The objective of this thesis is to study the properties of resistive switching effect based on bistable resistive memory which is fabricated in the form of Al2O3/polymer diodes and to contribute to the elucidation of resistive switching mechanisms. Resistive memories were characterized using a variety of electrical techniques, including current-voltage measurements, small-signal impedance, and electrical noise based techniques. All the measurements were carried out over a large temperature range. Fast voltage ramps were used to elucidate the dynamic response of the memory to rapid varying electric fields. The temperature dependence of the current provided insight into the role of trapped charges in resistive switching. The analysis of fast current fluctuations using electric noise techniques contributed to the elucidation of the kinetics involved in filament formation/rupture, the filament size and correspondent current capabilities. The results reported in this thesis provide insight into a number of issues namely: (i) The fundamental limitations on the speed of operation of a bi-layer resistive memory are the time and voltage dependences of the switch-on mechanism. (ii) The results explain the wide spread in switching times reported in the literature and the apparently anomalous behaviour of the high conductance state namely the disappearance of the negative differential resistance region at high voltage scan rates which is commonly attributed to a “dead time” phenomenon which had remained elusive since it was first reported in the ‘60s. (iii) Assuming that the current is filamentary, Comsol simulations were performed and used to explain the observed dynamic properties of the current-voltage characteristics. Furthermore, the simulations suggest that filaments can interact with each other. (iv) The current-voltage characteristics have been studied as a function of temperature. The findings indicate that creation and annihilation of filaments is controlled by filling and neutralizing traps localized at the oxide/polymer interface. (v) Resistive switching was also studied in small-molecule OLEDs. It was shown that the degradation that leads to a loss of light output during operation is caused by the presence of a resistive switching layer. A diagnostic tool that predicts premature failure of OLEDs was devised and proposed. Resistive switching is a property of oxides. These layers can grow in a number of devices including, organic light emitting diodes (OLEDs), spin-valve transistors and photovoltaic devices fabricated in different types of material. Under strong electric fields the oxides can undergo dielectric breakdown and become resistive switching layers. Resistive switching strongly modifies the charge injection causing a number of deleterious effects and eventually device failure. In this respect the findings in this thesis are relevant to understand reliability issues in devices across a very broad field.