Using recycled aggregates in green roof substrates for plant diversity

Extensive green roofs are becoming a popular tool for restoring green infrastructure in urban areas, particularly biodiverse habitats such as post-industrial/brownfield sites. This study investigated the use of six recycled lightweight aggregates and combinations of them in green roof growing substrate, to determine their effectiveness for enhancing plant abundance and species diversity. In two separate experiments, we examined the roles of substrate type and depth on the establishment of a perennial wildflower mix over a 15-month period. We found that some of the alternative substrates are comparable to the widely used crushed red brick aggregate (predominantly found in commercial green roof growing substrate) for supporting plant establishment. For some materials such as clay pellets, there was increased plant coverage and a higher number of plant species than in any other substrate. Substrates that were produced from a blend of two or three aggregate types also supported higher plant abundance and diversity. Generally, increasing substrate depth improved plant establishment, however this effect was not consistent across substrates. We conclude that recycled materials may be viable constituents of growing substrate for green roofs and they may improve green roof resilience, through increased plant cover and diversity. The results could provide evidence to support the construction of mosaic habitat types on single roofs using various substrate blends.

Bauxite residue (Red mud) as a pulverised fuel ash substitute in the manufacture of lightweight aggregate

This study looked at the potential of bauxite residue or red mud to be used in the manufacture of lightweight aggregate in replacement of pulverised fuel ash (PFA), commonly used as a way of recycling problematic wastes. The percentage replacements of red mud with PFA were as follows: 25, 31, 38, 44 and 50%. These were blended in a mix with waste excavated clay and sewage sludge – all from the Chongqing municipality in China. Lightweight pellets were produced using a Trefoil rotary kiln and were sintered to 1200 °C. Results showed that 44 % bauxite residue replacement produced lightweight pellets with the highest compressive strength, highest density and largest water holding capacity. This would be expected in materials with a low level of silicates, which causes insufficient glass phase viscosity and therefore poor bloating during firing; producing an aggregate with a higher density but with open pores that allowed for larger water absorption. All ratios of red mud aggregates were significantly reduced in pH after firing to around pH 8, and this reduced the leachability of the aggregates to levels below those set by the European landfill directive (2003/33/EC).