Cytotoxicity Evaluation of Si-Diatom Frustules in a Mouse Model

Silica additives in bone substitute materials are topical, clinically interesting and have significant support in the Orthopaedic field. Biosilica, e.g isolated from diatoms, has many advantages over its synthetic counterparts, e.g. it is amorphous, thus will be absorbed by the body, however, issues such as purity, presence of endotoxins and cytotoxicity need to be addressed before it can be further exploited. Biosilica isolated from Cyclotella Meneghiniana was then tested in a mouse model, to test the immunological response, organ toxicity (kidney, spleen, liver) and route of metabolism/excretion of silica. Five-week-old Balb-c mice were injected subcutaneously with a single high dose (50mg/ml) of Si-frustules, Si-frustules + organic linker and vehicle only control. Animals were sacrificed at 1d and 28d. The animal studies were conducted under an ethically approved protocol at Queen’s University, Belfast. The animals showed no adverse stress during the experiment and remained healthy until sacrifice. Blood results using ICP-OES analysis suggest the frustules were metabolized between comparator groups at different rates, and clearly showed elevated levels of silicon in groups injected with frustules relative to control. The histology of organs showed no variation in morphology of mice injected frustules relative compared to the control group.
Acknowledgements: The authors would like to thank Marie Curie International Outgoing Fellowships from the EU and Beaufort Marine Biodiscovery Award as part of the Marine Biotechnology Ireland Programme for providing financial support to this project.

Comparison of excess radiological risk of building materials and industrial by-products according to I-index (EU-BSS) and revised room model (IAEA SSG-32)

To get a better insight into the radiological features of industrial by-products that can be reused in building materials a review of the reported scientific data can be very useful. The current study is based on the continuously growing database of the By-BM (H2020-MSCA-IF-2015) project (By-products for Building Materials). Currently, the By-BM database contains individual data of about 431 by-products and 1095 building and raw materials. It was found that in case of the building materials the natural radionuclide content varied widely (Ra-226: <DL-27851 Bq/kg; Th-232: <DL-906 Bq/kg, K-40: <DL-17922 Bq/kg), more so than for the by-products (Ra-226: 7-3152 Bq/kg; Th-232: <DL-1350 Bq/kg, K-40: <DL-3001 Bq/kg). The average Ra-226, Th-232 and K-40 contents of the reported by-products were respectively 2.52, 2.35 and 0.39 times higher than the building materials. The gamma exposure of bulk building products was calculated according to IAEA Specific Safety Guide No. SSG-32 and the European Commission Radiation Protection 112 based I-index (EU BSS). It was found that in most cases the I-index without density consideration provides a significant overestimation in excess effective dose.