Arsenic and selenium mobilisation from organic matter treated mine spoil with and without inorganic fertilisation

Organic matter amendments are applied to contaminated soil to provide a better habitat for revegetation and remediation, and olive mill waste compost (OMWC) has been described as a promising material for this aim. We report here the results of an incubation experiment carried out in flooded conditions to study its influence in As and metal solubility in a trace elements contaminated soil. NPK fertilisation and especially organic amendment application resulted in increased As, Se and Cu concentrations in pore water. Independent of the amendment, dimethylarsenic acid (DMA) was the most abundant As species in solution. The application of OMWC increased pore water dissolved organic-carbon (DOC) concentrations, which may explain the observed mobilisation of As, Cu and Se; phosphate added in NPK could also be in part responsible of the mobilisation caused in As. Therefore, the application of soil amendments in mine soils may be particularly problematic in flooded systems. (C) 2012 Elsevier Ltd. All rights reserved.

The distribution of arsenic in soils affected by the Aznalcóllar mine spill, SW Spain

In April 1998, a holding lagoon containing pyrite ore processing waste, failed and released an estimated 5-6 million m(3) of metal rich sludge and acidic waters into the Rio Guadiamar, SW Spain. Over 2700 ha of the internationally important Doñana National and Natural Parks were contaminated. The sludge component of the waste contained up to 0.6% arsenic. This paper presents an extensive set of 0-5 cm soil analyses results from samples taken 6-8 months after the spill. Data are presented on pseudo-total arsenic levels in these samples, and on arsenic removed by both single batch and sequential extraction techniques. Pseudo-total levels of arsenic in the sludge ranged from 1521 to 3510 mg kg(-1), and a mean 4.4% of this was found to be extractable using 2.5% acetic acid. Soils in the Guadiamar Valley and Entremuros areas (those worst affected by the spill) were found to contain 85.4-782 mg kg(-1) and 7.1-196 mg kg(-1) pseudo-total arsenic, respectively. The mean acetic acid extractable component in these areas was 2.5% and 4.9%, respectively. Background pseudo-total arsenic levels in the soils of the area have been found to be 4.2-13.6 mg kg(-1). Rapid input of acidic waters, and the acidic nature of the sludge itself, may have caused depletion of Mg, Na and K, and to a lesser extent Mn, Ca and PO(4) in the upper 5 cm of the worst affected soils. Sequential extraction results suggest clear As-Fe associations, and possible As-Mn associations within the more soluble phases.

The Doñana ecological disaster:contamination of a world heritage estuarine marsh ecosystem with acidified pyrite mine waste

One of the most important bird breeding and over wintering sites in the west of Europe, the Coto Doñana, was severely impacted by the release of 5 million cubic meters of acid waste from the processing of pyrite ore. The waste entered ecologically sensitive areas of the park (including breeding areas for internationally endangered bird species) causing sustained pH decreases from pH 8.5 to 4.5 and resulting in massive metal contamination of the impacted ecosystem. The contaminating sludge waste contained arsenic at 0.6%, lead at 1.2% and zinc at 0.8% on a dry weight basis. The acid conditions facilitated the solubilization of these metals, leading to water concentrations lethal for aquatic wildlife. The accident caused considerable fish and invertebrate kills and has severe consequences for the protected bird species dependent on the impacted habitats and adjacent areas.

Stability and performance enhancements of Electrokinetic-Fenton soil remediation

Electrokinetic process is a potential in situ soil remediation process which transports the contaminants via electromigration and electroosmosis. For organic compounds contaminated soil, Fenton’s reagent is utilized as a flushing agent in electrokinetic process (Electrokinetic-Fenton) so that removal of organic contaminants could be achieved by in situ oxidation/destruction. However, this process is not applied widely in industries as the stability issue for Fenton’s reagent is the main drawback. The aim of this mini review is to summarize the developments of Electrokinetic-Fenton process on enhancing the stability of Fenton’s reagent and process efficiency in past decades. Generally, the enhancements are conducted via four paths: (1) chemical stabilization to delay H2O2 decomposition, (2) increase of oxidant availability by monitoring injection method for Fenton’s reagent, (3) electrodes operation and iron catalysts and (4) operating conditions such as voltage gradient, electrolytes and H2O2 concentration. In addition, the types of soils and contaminants are also showing significant effect as the soil with low acid buffering capacity, adequate iron concentration, low organic matter content and low aromatic ring organic contaminants generally gives better efficiency.

Performance Evaluation of Two-Stage Electrokinetic Washing as Soil Remediation Method for Lead Removal using Different Wash Solutions

The study explores the application of a two-stage electrokinetic washing system on remediation of lead (Pb) contaminated soil. The process involved an initial soil washing, followed by an electrokinetic process. The use of electrokinetic process in soil washing not only provided additional driving force for transporting the desorbed Pb away from the soil but also reduced the high usage of wash solution. In this study, the effect of NaNO3, HNO3, citric acid and EDTA as wash solutions on two-stage electrokinetic washing system were evaluated. The results revealed that a two-stage electrokinetic washing process enhanced Pb removal efficiency by 2.52-9.08% and 4.98-20.45% in comparison to a normal electrokinetic process and normal washing process, respectively. Low pH and adequate current were the most important criteria in the removal process as they provided superior desorption and transport properties. The effect of chelating by EDTA was less dominant as it delayed the removal process by forming a transport loop in anode region between Pb ion and complexes. HNO3 was not suitable as wash solution in electrokinetic washing in spite of offering highest removal efficiency as it caused pH fluctuation in the cathode chamber, corroded graphite anode and showed high power consumption. In contrast, citric acid not only yielded high Pb removal efficiency with low power consumption but also maintained a low soil: solution ratio of 1 g: <1 mL, stable pH and electrode integrity. Possible transport mechanisms for Pb under each wash solution are also discussed in this work.

Contaminants in surface water and sediments around the Tynagh Mine, Galway, Ireland.

A former silver mine in Tynagh, Co. Galway, Ireland is one of the most contaminated mine sites in Europe with maximum concentrations of Zn, As, Pb, Mn, Ni, Cu, and Cd far exceeding guideline values for water and sediment. The aims of this research were to 1) further assess the contamination, particularly metals, in surface water and sediment around the site, and 2) determine if the contamination has increased 10 years after the Environmental Protection Agency Ireland (EPAI) identified off-site contamination. Site pH is alkaline to neutral because CaCO3-rich sediment and rock material buffer the exposed acid generating sulphide-rich ore. When this study was compared to the previous EPAI study conducted 10 years earlier, it appeared that further weathering of exposed surface sediment had increased concentrations of As and other potentially toxic elements. Water samples from the tailings ponds and adjacent Barnacullia Stream had concentrations of Al, Cd, Mn, Zn and Pb above guideline values. Lead and Zn concentrations from the tailings pond sediment were 16 and 5 times higher, respectively, than concentrations reported 10 years earlier. Pb and Zn levels in most sediment samples exceeded the Expert Group (EGS) guidelines of 1000 and 5000 mg/kg, respectively. Arsenic concentrations were as high as 6238 mg/kg in the tailings ponds sediment, which is 62 and 862 times greater than the EGS and Canadian Soil Quality Guidelines (CSQG), respectively. Cadmium, Cu, Fe, Mn, Pb and Zn concentrations in water and sediment were above guideline values downstream of the site. Additionally, Fe, Mn and organic matter (OM) were strongly correlated and correlated to Zn, Pb, As, Cd, Cu and Ni in stream sediment. Therefore, the nearby Barnacullia Stream is also a significant pathway for contaminant transport to downstream areas. Further rehabilitation of the site may decrease the contamination around the area.