Tidally Distorted Exoplanets: Density Corrections for Short-period Hot-Jupiters Based Solely on Observable Parameters

The close proximity of short-period hot-Jupiters to their parent star means they are subject to extreme tidal forces. This has a profound effect on their structure and, as a result, density measurements that assume that the planet is spherical can be incorrect. We have simulated the tidally distorted surface for 34 known short-period hot-Jupiters, assuming surfaces of constant gravitational equipotential for the planet, and the resulting densities have been calculated based only on observed parameters of the exoplanet systems. Comparing these results to the density values, assuming the planets are spherical, shows that there is an appreciable change in the measured density for planets with very short periods (typically less than two days). For one of the shortest-period systems, WASP-19b, we determine a decrease in bulk density of 12% from the spherical case and, for the majority of systems in this study, this value is in the range of 1%-5%. On the other hand, we also find cases where the distortion is negligible (relative to the measurement errors on the planetary parameters) even in the cases of some very short period systems, depending on the mass ratio and planetary radius. For high-density gas planets requiring apparently anomalously large core masses, density corrections due to tidal deformation could become important for the shortest-period systems.

Do Changes in Current Flow as a Result of Arrays of Tidal Turbines Have an Effect on Benthic Communities?

Arrays of tidal energy converters have the potential to provide clean renewable energy for future generations. Benthic communities may, however, be affected by changes in current speeds resulting from arrays of tidal converters located in areas characterised by strong currents. Current speed, together with bottom type and depth, strongly influence benthic community distributions; however the interaction of these factors in controlling benthic dynamics in high energy environments is poorly understood. The Strangford Lough Narrows, the location of SeaGen, the world’s first single full-scale, grid-compliant tidal energy extractor, is characterised by spatially heterogenous high current flows. A hydrodynamic model was used to select a range of benthic community study sites that had median flow velocities between 1.5–2.4 m/s in a depth range of 25–30 m. 25 sites were sampled for macrobenthic community structure using drop down video survey to test the sensitivity of the distribution of benthic communities to changes in the flow field. A diverse range of species were recorded which were consistent with those for high current flow environments and corresponding to very tide-swept faunal communities in the EUNIS classification. However, over the velocity range investigated, no changes in benthic communities were observed. This suggested that the high physical disturbance associated with the high current flows in the Strangford Narrows reflected the opportunistic nature of the benthic species present with individuals being continuously and randomly affected by turbulent forces and physical damage. It is concluded that during operation, the removal of energy by marine tidal energy arrays in the far-field is unlikely to have a significant effect on benthic communities in high flow environments. The results are of major significance to developers and regulators in the tidal energy industry when considering the environmental impacts for site licences.

A Maxwell relation for current-induced forces

A Maxwell relation is presented involving current-induced forces. It provides a new physical picture of the origin of current-induced forces and in the small-voltage limit it enables the identification of a simple thermodynamic potential which drives electromigration. The question of whether current-induced forces are conservative or non-conservative is discussed briefly in the light of these insights.

Are current-induced forces conservative?

The expression for the force on an ion in the presence of current can be derived from first principles without any assumption about its conservative character. However, energy functionals have been constructed that indicate that this force can be written as the derivative of a potential. On the other hand, there exist specific arguments that strongly suggest the contrary. We propose physical mechanisms that invalidate such arguments and demonstrate their existence with first-principles calculations. While our results do not constitute a formal resolution to the fundamental question of whether current-induced forces are conservative, they represent a substantial step forward in this direction.

Reply to comment on 'Counterbalancing forces in electromigration'

Reply to comment by K-H W Chu.

Counterbalancing forces in electromigration

In electromigration (EM) experiments on metallic wires, a flux of atoms can lead to motion of the centre of mass (COM) of the wire. Hence, it may be tempting to assume that the flow of current produces a net force on the wire as a whole. We point out, on the basis of known momentum-balance arguments, that the net force on a metallic wire due to a passing steady-state current is zero. This is possible, because in addition to EM driving forces, acting on scattering centres, there are counterbalancing forces, acting on the rest of the system. Drift of the COM in EM experiments occurs inevitably because the substrate keeps the crystal lattice of the wire fixed, while allowing diffusion of defects in the bulk of the wire. This drift is not evidence for a net force on the wire.

Current-induced forces in atomic-scale conductors

We present a self-consistent tight-binding formalism to calculate the forces on individual atoms due to the flow of electrical current in atomic-scale conductors. Simultaneously with the forces, the method yields the local current density and the local potential in the presence of current flow, allowing a direct comparison between these quantities. The method is applicable to structures of arbitrary atomic geometry and can be used to model current-induced mechanical effects in realistic nanoscale junctions and wires. The formalism is implemented within a simple Is tight-binding model and is applied to two model structures; atomic chains and a nanoscale wire containing a vacancy.

Purification capacity of a highly loaded laboratory scale tidal flow reed bed system with effluent recirculation

The purification capacity of a laboratory scale tidal flow reed bed system with final effluent recirculation at a ratio of 1:1 was investigated in this study. In particular, this four-stage reed bed system was highly loaded with strong agricultural wastewater. Under the hydraulic and organic loading rates as high as 0.43 m3/m2d and 1055 gCOD/m2d, respectively, the average removal efficiencies of COD, BOD5, SS, NH4-N and P were 77%, 78%, 66%, 62% and 38%. Even with the high loading rates, approximately 30% of NH4-N was converted into NO2-N and NO3-N from the mid-stage of the system where nitrification took place. The results suggest that the multi-stage reed bed system could be employed to treat strong wastewater under high loading, especially for the substantive mass removal of solids, organic matter and ammoniacal-nitrogen. Tidal flow combined with effluent recirculation is a favourable operation strategy to achieve this objective.

Age and palaeoenvironmental significance of an inter-tidal peat bed at Ballywoolen, Bann estuary, Co. Londonderry.

A recently exposed inter-tidal peat bed at Ballywoolen, Bann estuary, Co. Londonderry, has yielded new information about mid-Holocene coastal environmental change in the northeast of Ireland. Pollen analytical data and wood detritus demonstrate that peat accumulation occurred in a terrestrial environment that was free from marine influence. Radiocarbon dates suggest that the peat accumulated rapidly during a period of low relative sea level subsequent to the maximum of Holocene relative sea-level rise along the north coast of Northern Ireland. The absence of marine/brackish indicator taxa at the site suggests that the tidal range was somewhat less than that at present and/or that the channel of the river was located some distance east of its present alignment. The dates indicate that the low stand lasted for at least ~0.2 ka and possibly for ~1.1 ka. Stable, woodland-dominated landscapes are indicated at both this site and neighbouring ones around ~6.4-5.3 cal ka BP. There is no evidence for large-scale aeolian sand movement or human impact on the landscape during the period of peat accumulation.

Millimeter-wave stealth radio for special operations forces

For Special Operations Forces, an important attribute of any future radio will be the ability to conceal transmissions from the enemy while transmitting large amounts of data for situational awareness and communications. These requirements will mean that military wireless systems designers will need to consider operating frequencies in the mm-wave bands: The high data rates that are achievable at these frequencies and the propagation characteristics at this wavelength will provide many benefits for the implementation of 'stealth radio'. This article discusses some of the recent advances in RF front-end technology, alongside physical layer transmission schemes that could be employed for millimeter-wave soldier-mounted radio. The operation of a hypothetical millimeter-wave soldier-to-soldier communications system that makes use of smart antenna technology is also described.