Phase agile reflectarray cells based on liquid crystals

Experimental results at X-band are used to compare the electromagnetic scattering from a printed reflectarray cell, which is constructed on 500 mu m thick layers of three different nematic state liquid crystals. It is shown that a small voltage can be used to vary the permittivity of the tunable substrate and thereby control the phase of the reflected signals. Numerical results using Ansoft HFSS are compared with the measured phase, resonant frequencies and signal attenuation for two orientations of the liquid crystal molecules. Data fitting is employed to quantify the loss tangent and the permittivity values of the three anisotropic specimens. The performance trade-offs that are imposed by the use of commercially available materials are discussed, and the computer model is used to specify the electrical properties of a liquid crystal mixture, which can provide a signal loss of <1 dB and a dynamic phase range of 300 degrees from the patch elements at 10 GHz.

Separate Density and Viscosity Determination of Room Temperature Ionic Liquids using Dual Quartz Crystal Microbalances

The drive towards cleaner industrial processes has led to the development of room temperature ionic liquids (RTIL) as environmentally friendly solvents. They comprise solely of ions which are liquid at room temperature and with over one million simple RTIL alone it is important to characterize their physical properties using minimal sample volumes. Here we present a dual Quartz Crystal Microbalance (QCM) which allows separate determination of viscosity and density using a total sample volume of only 240 mu L. Liquid traps were fabricated on the sensing area of one QCM using SU-8 10 polymer with a second QCM having a flat surface. Changes in the resonant frequencies were used to extract separate values for viscosity and density. Measurements of a range of pure RTIL with minimal water content have been made on five different trap designs. The best agreement with measurements from the larger volume techniques was obtained for trap widths of around 50 pm thus opening up the possibility of integration into lab-on-a-chip systems.

Quality factor assessment of subwavelength resonant cavities at FIR frequencies

Subwavelength resonators at FIR are presented and studied. The structures consist of 1D cavities formed between a metallized (silver) surface and a metamaterial surface comprising a periodic array of silver patches on a silver-backed silicon substrate. The concept derives from recent discoveries of artificial magnetic conductors (AMC). By studying the currents excited on the metamaterial surface by a normally incident plane wave, the nature of the emerging resonant phenomena and the physical mechanism underlying the AMC operation are investigated. Full wave simulations, based on finite element method and time-domain transmission line modelling technique, have been carried out to demonstrate the effective AMC boundary condition and prove the possibilities for subwavelength cavities. The quality factor of the resonant cavities is assessed as a function of the cavity profile. It is demonstrated that the quality factor drops to about 1/8 of the half-wavelength value for lambda/8 resonant cavity.

Efficient analysis, design, and filter applications of EBG waveguide with periodic resonant loads

An efficient analysis and design of an electromagnetic-bandgap (EBG) waveguide with resonant loads is presented. Equivalent-circuit analysis is employed to demonstrate the differences between EBG waveguides with resonant and nonresonant loadings. As a result of the resonance, transmission zeros at finite frequencies emerge. The concept is demonstrated in E-plane waveguides. A generic fast and efficient formulation is presented, which starts from the generalized scattering matrix of the unit cell and derives the dispersion properties of the infinite structure. Both real and imaginary parts of the propagation constant are derived and discussed. The Floquet wavelength and impedance are also presented. The theoretical results are validated by comparison with simulations of a finite structure and experimental results. The application of the proposed EBG waveguide in the suppression of the spurious passband of a conventional E-plane filter is presented by experiment.

Singly, doubly and triply resonant multiphoton processes involving autoionizing states in magnesium

Using the R-matrix Floquet theory we have carried out non-perturbative, ab initio one- and two-colour calculations of the multiphoton ionization of magnesium with the laser frequencies chosen such that the initial state of the atom is resonantly coupled with autoionizing resonances of the atom. Good agreement is obtained with previous calculations in the low-intensity regimes. The single-photon ionization from the 3s3p P excited state of magnesium has been studied in the vicinity of the 3p S autoionizing resonance at non-perturbative laser intensities. Laser-induced degenerate states (LIDS) are observed for modest laser intensities. By adding a second laser which resonantly couples the 3p S = and 3p3d P autoionizing levels, we show that, due to the small width of the 3p3d P state, LIDS occur between this state and the 3s3p P state at intensities of the first laser below 10 W cm . We next investigate the case in which the first laser induces a resonant two-photon coupling between the ground state and the 3p S autoionizing state, while the second laser again resonantly couples the respective 3p S and 3p3d P autoionizing states. At weak intensities, our calculations compare favourably with recent experimental data and calculations. We show that when the intensity of the first laser is increased, the effect of an additional autoionizing state, the 4s5s S state, becomes significant. This state is coupled to the 3p3d P autoionizing level by one photon, inducing a triply resonant processes. We show that LIDS occur among the three autoionizing levels and we discuss their effect on the decay rate of the ground state. We consider dressed two- and three-level atoms which can be used to model the results of our calculations.

Identification and bisection of temporal durations and tone frequencies: Common models for temporal and non-temporal stimuli.

Two experiments examined identification and bisection of tones varying in temporal duration (Experiment 1) or frequency (Experiment 2). Absolute identification of both durations and frequencies was influenced by prior stimuli and by stimulus distribution. Stimulus distribution influenced bisection for both stimulus types consistently, with more positively skewed distributions producing lower bisection points. The effect of distribution was greater when the ratio of the largest to smallest stimulus magnitude was greater. A simple mathematical model, temporal range frequency theory, was applied. It is concluded that (a) similar principles describe identification of temporal durations and other stimulus dimensions and (b) temporal bisection point shifts can be understood in terms of psychophysical principles independently developed in nontemporal domains, such as A. Parducci's (1965) range frequency theory.

Micromachined 300GHz high Q resonant slot frequency selective surface filter

The design of a low loss quasi-optical beam splitter which is required to provide efficient diplexing of the bands 316.5-325.5 GHz and 349.5-358.5 GHz is presented. To minimise the filter insertion loss, the chosen architecture is a three-layer freestanding array of dipole slot elements. Floquet modal analysis and finite element method computer models are used to establish the geometry of the periodic structure and to predict its spectral response. Two different micromachining approaches have been employed to fabricate close packed arrays of 460 mm long elements in the screens that form the basic building block of the 30mm diameter multilayer frequency selective surface. Comparisons between simulated and measured transmission coefficients for the individual dichroic surfaces are used to determine the accuracy of the computer models and to confirm the suitability of the fabrication methods.

Multiphoton absorption by helium, magnesium and H-2 at high frequencies and intensities

We review principally some recent work carried out in Belfast and Heraklion which handles the few-electron dynamics of atomic and molecular systems exposed to high frequency. high intensity laser fields. The design and application of the quantitatively accurate computational methods is discussed. The Belfast work is illustrated by results for double ionization of helium and the hydrogen molecule where in each case the two electrons have been handled in full-dimensionality. The first results for multiphoton, double ionization of a complex atom, namely magnesium demonstrate an important application of the Heraklion approach.

Total and single differential cross sections for simple resonant collisions using a fully orthonormal continuum-distorted-wave basis

Simple electron capture processes are studied using an orthonormal two state continuum-distorted-wave (CDW) basis. The suitability of the basis set is tested by comparing predictions for total and differential cross sections with available experimental data. Overall good agreement is obtained and the authors conclude that a relatively small CDW basis set may be suitable to model a wide variety of low-energy collisions if the members of this extended set are astutely chosen.