Deactivation of Oxidation Catalysts by Oil-Derived Sulphur

The most common mode of deactivation suffered by catalysts fitted to two-stroke engines has traditionally been thermal degradation, or even meltdown, of the washcoat and substrate. The high temperatures experienced by these catalysts are caused by excessively high concentrations of HC and CO in the exhaust gas which are, in turn, caused by a rich AFR and the loss of neat fuel to the exhaust during the scavenging period. The effects of catalyst poisoning due to additives in the oil is often regarded as a secondary, or even negligible, deactivating mechanism in two-stroke catalysts and has therefore received little attention. However, with the introduction of direct in-cylinder fuel injection to some larger versions of this engine, the quantities of HC escaping to the exhaust can be reduced to levels similar to those found on four-stroke gasoline engines. Under these conditions, the effects of poisoning are much more significant to catalyst durability, particularly for crankcase scavenged derivatives which allow considerable quantities of oil to escape into the exhaust in a neat, or partially burned form. In this paper the effects of oil-derived sulphur on catalyst performance are examined using specialised test apparatus. The oil used throughout the study was formulated specifically for a two-stroke engine fitted with direct in-cylinder fuel injection. The sulphur content of this oil was 0.21% by mass and particular attention was paid to the role of this element in the resulting deactivation. The catalyst was also designed for two-stroke applications and contained a high palladium loading of 300g/ft3 (28g/l) to prolong the life of the catalyst. It was found that the sulphur caused permanent deactivation of the CO reaction and increased the light-off temperature by around 40oC after oiling for 60 hours. This deactivation was progressive and led to a reduction in surface area of the washcoat, particularly in the micropores of around 5Å diameter. By using a validated catalyst model the change in surface area of the precious metal was estimated. It was found that the simulated palladium surface area had to be reduced by a factor of around 7.5 to produce the light-off temperature of the deactivated catalyst. Conversely, the light-off temperature of the C3H6 reaction was barely affected by the deactivation.

What motion distributions yield global transparency and spatial segmentation?

We have examined the ability of observers to parse bimodal local-motion distributions into two global motion surfaces, either overlapping (yielding transparent motion) or spatially segregated (yielding a motion boundary). The stimuli were random dot kinematograms in which the direction of motion of each dot was drawn from one of two rectangular probability distributions. A wide range of direction distribution widths and separations was tested. The ability to discriminate the direction of motion of one of the two motion surfaces from the direction of a comparison stimulus was used as an objective test of the perception of two discrete surfaces. Performance for both transparent and spatially segregated motion was remarkably good, being only slightly inferior to that achieved with a single global motion surface. Performance was consistently better for segregated motion than for transparency. Whereas transparent motion was only perceived with direction distributions which were separated by a significant gap, segregated motion could be seen with abutting or even partially overlapping direction distributions. For transparency, the critical gap increased with the range of directions in the distribution. This result does not support models in which transparency depends on detection of a minimum size of gap defining a bimodal direction distribution. We suggest, instead, that the operations which detect bimodality are scaled (in the direction domain) with the overall range of distributions. This yields a flexible, adaptive system that determines whether a gap in the direction distribution serves as a segmentation cue or is smoothed as part of a unitary computation of global motion.

Effects of plastic coating on K-alpha yield from ultra-short pulse

A study of the K-alpha radiation emitted from Ti foils irradiated with intense, similar to0.2 J, 67 fs, 800 nm laser pulses, scanning a range of intensities (similar to10(15)-10(18) W cm(-2)), is reported. The brightness of single-shot K-alpha line emission from the front of the targets is recorded. The yield from bare titanium (Ti) is compared to that from plastic (parylene-E) coated Ti. It is demonstrated that, for a defocused beam, a thin layer of plastic increases the yield.

Effects of the stockperson on dairy cow behaviour and milk yield

The relationship between stockperson behaviour, measured as verbal and physical interactions with the dairy cows (no. ¼ 210), during milking and the subsequent milk yield obtained was examined. The numbers of steps and kicks made by the cows during milking was recorded. The behaviour of two stockteams, each consisting of two stockmen, were recorded over 10 weekend sessions. The two teams varied in the types of interactions and when the stockteam that performed more positive interactions worked with the cows (team A), the cows had a significantly higher milk yield (P , 0·05) although this difference was small (17·54 v. 17·44 kg). When team A was milking the cows also stepped and kicked on the platform significantly more ( P , 0·05) compared with team B. The results also indicated that while each stockteam tended to interact with the same cows each session, different stockpersons interacted with different cows. These findings highlight the importance of the role of the stockperson in milk output and dairy cow behaviour in a commercial setting.

Reduced sperm yield from testicular biopsies of vasectomized men is due to increased apoptosis

Objective: To compare sperm yields, apoptotic indices, and sperm DNA fragmentation from vasectomized men and fertile men undergoing vasectomy.

Design: Testicular biopsies from vasectomized (n 26) and fertile men (n 46), were milked to calculate sperm/gram and also formalin-?xed to determine the numbers of developing sperm and incidence and intensities of testicular FasL, Fas, Bax, and Bcl-2. Testicular sperm DNA fragmentation was assessed using the alkaline Comet assay.

Setting: An ART unit.

Patient(s): Twenty-six men attending for intracytoplasmic sperm injection (ICSI) and 46 men attending for vasectomies.

Main Outcome Measure(s): Spermatocyte, spermatid and sperm yields, Fas, FasL, and Bax staining.

Result(s): Sperm yields from men vasectomized 5 years previously were markedly reduced compared to fertile men. Increased intensities of FasL and Bax staining were observed in the seminiferous tubules of vasectomy men. FasL positivity (percentage) also increased in Sertoli cells, and both FasL and Fas positivity (percentage) increased in primary spermatocytes and round spermatids of vasectomized men. Sperm DNA fragmentation, an end point marker of apoptosis, increased signi?cantly in vasectomized men compared to fertile men.

Conclusion(s): Reduced sperm yields after vasectomy are associated with increased apoptosis through the Fas–FasL and Bax pathways. Sperm after vasectomy displayed increased DNA fragmentation. (Fertil Steril 2007;87:834–41. ©2007 by American Society for Reproductive Medicine.)