Modeling of Turbulent Natural Gas and Biogas Flames of the Delft Jet-in-Hot-Coflow Burner: Effects of Coflow Temperature, Fuel Temperature and Fuel Composition on the Flame Lift-Off Height

The structure of a turbulent non-premixed flame of a biogas fuel in a hot and diluted coflow mimicking moderate and intense low dilution (MILD) combustion is studied numerically. Biogas fuel is obtained by dilution of Dutch natural gas (DNG) with CO2. The results of biogas combustion are compared with those of DNG combustion in the Delft Jet-in-Hot-Coflow (DJHC) burner. New experimental measurements of lift-off height and of velocity and temperature statistics have been made to provide a database for evaluating the capability of numerical methods in predicting the flame structure. Compared to the lift-off height of the DNG flame, addition of 30 % carbon dioxide to the fuel increases the lift-off height by less than 15 %. Numerical simulations are conducted by solving the RANS equations using Reynolds stress model (RSM) as turbulence model in combination with EDC (Eddy Dissipation Concept) and transported probability density function (PDF) as turbulence-chemistry interaction models. The DRM19 reduced mechanism is used as chemical kinetics with the EDC model. A tabulated chemistry model based on the Flamelet Generated Manifold (FGM) is adopted in the PDF method. The table describes a non-adiabatic three stream mixing problem between fuel, coflow and ambient air based on igniting counterflow diffusion flamelets. The results show that the EDC/DRM19 and PDF/FGM models predict the experimentally observed decreasing trend of lift-off height with increase of the coflow temperature. Although more detailed chemistry is used with EDC, the temperature fluctuations at the coflow inlet (approximately 100K) cannot be included resulting in a significant overprediction of the flame temperature. Only the PDF modeling results with temperature fluctuations predict the correct mean temperature profiles of the biogas case and compare well with the experimental temperature distributions.

Temperature fields in a channel partially filled with a porous material under local thermal non-equilibrium condition-an exact solution

This work examines analytically the forced convection in a channel partially filled with a porous material and subjected to constant wall heat flux. The Darcy–Brinkman–Forchheimer model is used to represent the fluid transport through the porous material. The local thermal non-equilibrium, two-equation model is further employed as the solid and fluid heat transport equations. Two fundamental models (models A and B) represent the thermal boundary conditions at the interface between the porous medium and the clear region. The governing equations of the problem are manipulated, and for each interface model, exact solutions, for the solid and fluid temperature fields, are developed. These solutions incorporate the porous material thickness, Biot number, fluid to solid thermal conductivity ratio and Darcy number as parameters. The results can be readily used to validate numerical simulations. They are, further, applicable to the analysis of enhanced heat transfer, using porous materials, in heat exchangers.

Stable oxygen isotopes in irish oaks: potential for reconstructing local and regional climate

The long Irish oak tree-ring chronology, developed for archaeological dating and radiocarbon calibration, is the longest of any in northwest maritime Europe, spanning most of the Holocene (7,272 years). Unfortunately, the rings widths do not carry a strong climate signal and the record hasnever been satisfactorily applied for dendroclimatic reconstruction. This pilot study explores the potential for extracting a climate signal from Irish oaks by comparing the stable oxygen isotopes ratios from 10 oak tree cores (Quercus robur and Quercus petraea L.) collected across the Armagh region of NE Ireland with local and regional climatic and stable isotopic data. Statistically significant correlations between isotope ratios and the amount of summer precipitation (r = -0.44) point to the isotopic composition of summer rainfall as the dominant signal. Including the Armagh data into an extended regional oxygen isotope series did not reduce the correlation coefficient with regional precipitation (r = -0.68, p < 0.01). Correlations of this magnitude in dendro-hydroclimatology are typically restricted to trees growing at their ecological limits. This research suggests that there is considerable potential for including living trees and ancient timbers from Ireland into a regional composite to reconstruct the summer hydroclimate of Britain and Ireland.