ALK translocation is associated with ALK immunoreactivity and extensive signet-ring morphology in primary lung adenocarcinoma.

BACKGROUND: ALK rearrangement is particularly observed in signet-ring sub-type adenocarcinoma. Since fluorescence in situ hybridization (FISH) is not suitable for mass screening, we aimed to characterize the predictive utility of tumour morphology and ALK immunoreactivity to identify ALK rearrangement, in a primary lung adenocarcinoma dataset enriched for signet-ring morphology, compared with that of other morphology. METHODS: 7 adenocarcinomas from diagnostic archives reported with signet-ring morphology were assessed and compared with 11 adenocarcinomas without signet-ring features over the same time period. Growth patterns were reviewed, ALK expression was assessed by standard immunohistochemistry using ALK1 clone and Envision detection (Dako), and ALK rearrangement was assessed by FISH (Abbott Molecular). Associations between groups and predictive utility of tumour morphology and ALK expression using FISH as gold standard were calculated. RESULTS: 2 excision lung biopsy cases with pure (100%) signet-ring morphology and solid patterns demonstrated diffuse moderate cytoplasmic ALK immunoreactivity (2+) and harboured ALK rearrangements (p=0.007), unlike 5 mixed-signet-ring and 11 non-signet-ring adenocarcinomas, which showed negative or 1+ immunoreactivity; and did not harbour ALK rearrangements (p>0.1). ALK expression was not associated with ALK copy number. 6 of 7 cases with signet ring morphology stained for TTF-1. Pure signet-ring morphology and moderate ALK expression were both associated with ALK rearranged tumours. CONCLUSION: ALK rearrangement is strongly associated with ALK immunoreactivity, and was seen only in tumours with pure signet-ring morphology and solid growth pattern. Tumour morphology, growth pattern and ALK immunoreactivity appear to be good indicators of ALK rearrangement, with TTF-1 positivity aiding in proving primary pulmonary origin.

Bridge weigh-in-motion system and Structural Health Monitoring using fiber optic sensors

There have been over 3000 bridge weigh-in-motion (B-WIM) installations in 25 countries worldwide, this has led vast improvements in post processing of B-WIM systems since its introduction in the 1970’s. This paper introduces a new low-power B-WIM system using fibre optic sensors (FOS). The system consisted of a series of FOS which were attached to the soffit of an existing integral bridge with a single span of 19m. The site selection criteria and full installation process has been detailed in the paper. A method of calibration was adopted using live traffic at the bridge site and based on this calibration the accuracy of the system was determined.

Experimental Study of Interfacial Stress Distribution of Bonded-in BFRP Rod Glulam Joints Using Fibre Optic Sensors (FOS)

In this study, fibre optic sensors (FOS) were used to investigate the interfacial stress-strain behaviour of bonded-in basalt fibre reinforced polymer (BFRP) rods loaded into glulam members. Pull-out tests were conducted to examine the effect of bonded length and load-to-grain direction on the distribution of stress at the BFRP rod/adhesive zone. It was observed that the stress concentration at the loaded end of the BFRP rod of the samples was significantly the highest while the unloaded end showed the lowest. Increasing the bonded length at the same loading configuration resulted in a decrease in stress concentration at the loaded end. The stress concentration at the loaded end of the perpendicular to the grain samples was relatively higher than that of the corresponding parallel to the grain samples.