Twenty-two novel microsatellite loci for lumpfish (Cyclopterus lumpus)

Lumpfish (Cyclopterus lumpus L. 1758) are widely distributed on both sides of the North Atlantic. They are a commercially important species, but stock size estimates have declined since the mid-1980s in Canada, Norway and Iceland. Little is known about the biology of this species, in particular the breeding migrations and population structure which are fundamental for effective management. This paper describes the development and characterization of twenty-two polymorphic microsatellite loci using next generation sequencing. The number of alleles per locus ranged from 3 to 27 in two geographically distant North Atlantic populations, with observed and expected heterozygosities ranging between 0. 0625-0. 979 and 0. 0618-0. 946, respectively. These loci are an important resource that will allow assessment of the population genetic structure of this species, and contribute to its appropriate management.

Genetic structure of the lumpfish Cyclopterus lumpus across the North Atlantic

Lumpfish, or lumpsucker, Cyclopterus lumpus (Linnaeus, 1758) is widely distributed in the North Atlantic Ocean. It has a considerable economic value and substantial fisheries occur in several North Atlantic regions owing to the use of its fully ripe internal egg masses in the ovaries as an alternative to sturgeon caviar. Despite being intensively fished in several locations, biological knowledge is limited and no genetic structure information is available. In this study, the stock structure of C. lumpus was investigated across the North Atlantic using ten microsatellite loci. Out of ten loci, two exhibited higher level of differentiation but their inclusion/ exclusion from the analyses did not drastically change the observed genetic pattern. A total of three distinct genetic groups were detected: Maine-Canada-Greenland, Iceland-Norway and Baltic Sea. These results, discussed in terms of origin of differentiation, gene flow, and selection, showed that gene flow was rather limited among the detected groups, and also between Greenland and Maine-Canada.

Ovariole number - a predictor of differential reproductive success among worker subfamilies in queenless honeybee (Apis mellifera L.) colonies

A honeybee queen normally mates with 10-20 drones, and reproductive conflicts may arise among a colony's different worker patrilines, especially after a colony has lost its single queen and the workers commence egg laying. In this study, we employed microsatellite markers to study aspects of worker reproductive competition in two queenless Africanized honeybee colonies. First, we determined whether there was a bias among worker patrilines in their maternity of drones and, second, we asked whether this bias could be attributed to differences in the degree of ovary activation of workers. Third, we relate these behavioral and physiological factors to ontogenetic differences between workers with respect to ovariole number. Workers from each of three (colony A) and one (colony B) patrilineal genotypes represented less than 6% of the worker population, yet each produced at least 13% of the drones in a colony, and collectively they produced 73% of the drones. Workers representing these genotypes also had more developed follicles and a greater number of ovarioles per ovary. Across all workers, ovariole development and number were closely correlated. This suggests a strong effect of worker genotype on the development of the ovary already in the postembryonic stages and sets a precedent to adult fertility, so that

Pyrrolo-1,5-benzoxazepines:a new class of apoptotic agents

Some members of a series of novel pyrrolo-1,5-benzoxazepines (PBOXs) potently induce apoptosis in a number of human cancerous cell lines including HL-60 cells and the drug-resistant chronic myelogenous leukaemia cell line, K562. The apoptotic induction seems to be independent of the mitochondrial peripheral-type benzodiazepine receptor (PBR), which binds these PBOXs with high affinity, due to a lack of correlation between their affinities for the receptor and their apoptotic potencies and their high apoptotic activity in PBR-deficient cells. PBOX-6, a potent member of the series, induces a transient activation of c-Jun N-terminal kinase (JNK) in a dose-dependent manner, which correlates with induction of apoptosis. Expression of a cytoplasmic inhibitor of the JNK signal transduction pathway, Jip-1, prevents JNK activity and significantly reduces the extent of apoptosis induced by PBOX-6. This demonstrates the requirement for JNK in the cellular response to this apoptotic agent. In addition, PBOX-6 activates caspase-3-like proteases in K562 and HL-60 cells. The caspase-3 inhibitor, Z-Asp-Glu-Val-Asp-fluoromethylketone (z-DEVD-fmk), blocks caspase-3-like protease activity in both cell types but only prevents PBOX-6-induced apoptosis in HL-60 cells, suggesting that the requirement for caspase-3-like proteases in the apoptotic pathway is dependent on the cell type.

A novel structural class of photoswitchable oligonucleotide

Directed Michaelis–Arbuzov reactions of support-bound internucleotide O-benzyl- or O-methyl-phosphite triesters with meta-phenylazobenzylamine or alkane-/glycol-linked a,x-diamines were effected in the presence of iodine. The corresponding tritylated phosphoramidate-linked 11-mers were fully deprotected and released from the support under standard conditions and the fast- and slow-diastereoisomers of both the E- and the Z-meta-phenylazobenzyl-appended oligomers were readily resolved by RP-HPLC. The primary amine-functionalised oligonucleotides were either purified, detritylated and then finally treated with Nhydroxysuccinimidyl carboxylic acid ester derivatives of photoswitchable moieties (Route A) or first derivatised and then subsequently purified and detritylated (Route B). This latter route enabled resolution of fast- and slow-isomers of the trityl-on oligomers bearing novel photoswitchable azopyridine or 9-alkoxyanthracene moieties using RP-HPLC, following which the pure diastereoisomers were detritylated and characterised by MALDI-MS.

Peptide DV-28 amide: Prototype of a novel class of bradykinin receptor antagonist isolated from the defensive skin secretion of bombinid toads

Kinestatin, isolated from the skin of the Chinese toad, Bombina maxima, was the first bradykinin B2 receptor antagonist identified in amphibians. Molecular cloning established that it is co-encoded with the bradykinin-related peptide, maximakinin, within one of several skin kininogens. To examine other species within the genus Bombina for the presence of structural homologues of kinestatin, we subjected skin secretion of the toad, Bombina orientalis, to HPLC fractionation with subsequent bioassay of fractions for antagonism of bradykinin activity using an isolated rat tail artery smooth muscle preparation. A single fraction was located that inhibited bradykinin-induced relaxation of rat arterial smooth muscle and MALDI-TOF analysis of this fraction revealed that it contained a single peptide of molecular mass 3198.5 Da. Further primary structural analysis of this peptide showed that it was a 28-mer with an N-terminal Asp (D) residue and a C-terminal Val (V) residue that was amidated. The peptide was named DV-28 amide in accordance with these primary structural attributes. Synthetic DV-28 amide replicated the observed bradykinin antagonistic effect within the smooth muscle bioassay in a dose-dependent manner. In addition, it was observed to inhibit the proliferation of human microvessel endothelial cells (HMECs) as assessed by MTT assay. Bioinformatic analysis revealed that DV-28 amide was, like kinestatin, co-encoded with a bradykinin receptor agonist on one of two skin kininogens identified in B. orientalis. DV-28 amide thus represents a novel class of bradykinin antagonist from skin secretions of bombinid toads that appear to be a rich source of such novel peptides.

Hybridization of a class of "second order" models of traffic flow

Despite the simultaneous progress of traffic modelling both on the macroscopic and microscopic front, recent works [E. Bourrel, J.B. Lessort, Mixing micro and macro representation of traffic flow: a hybrid model based on the LWR theory, Transport. Res. Rec. 1852 (2003) 193–200; D. Helbing, M. Treiber, Critical discussion of “synchronized flow”, Coop. Transport. Dyn. 1 (2002) 2.1–2.24; A. Hennecke, M. Treiber, D. Helbing, Macroscopic simulations of open systems and micro–macro link, in: D. Helbing, H.J. Herrmann, M. Schreckenberg, D.E. Wolf (Eds.), Traffic and Granular Flow ’99, Springer, Berlin, 2000, pp. 383–388] highlighted that one of the most promising way to simulate efficiently traffic flow on large road networks is a clever combination of both traffic representations: the hybrid modelling. Our focus in this paper is to propose two hybrid models for which the macroscopic (resp. mesoscopic) part is based on a class of second order model [A. Aw, M. Rascle, Resurection of second order models of traffic flow?, SIAM J. Appl. Math. 60 (2000) 916–938] whereas the microscopic part is a Follow-the Leader type model [D.C. Gazis, R. Herman, R.W. Rothery, Nonlinear follow-the-leader models of traffic flow, Oper. Res. 9 (1961) 545–567; R. Herman, I. Prigogine, Kinetic Theory of Vehicular Traffic, American Elsevier, New York, 1971]. For the first hybrid model, we define precisely the translation of boundary conditions at interfaces and for the second one we explain the synchronization processes. Furthermore, through some numerical simulations we show that the waves propagation is not disturbed and the mass is accurately conserved when passing from one traffic representation to another.