6 resultados para 2X2
Resumo:
Quantum nonlocality is tested for an entangled coherent state, interacting with a dissipative environment. A pure entangled coherent state violates Bell's inequality regardless of its coherent amplitude. The higher the initial nonlocality, the more rapidly quantum nonlocality is lost. The entangled coherent state can also be investigated in the framework of 2x2 Hilbert space. The quantum nonlocality persists longer in 2x2 Hilbert space. When it decoheres it is found that the entangled coherent state fails the nonlocality test, which contrasts with the fact that the decohered entangled state is always entangled.
Resumo:
Structural and magnetic properties of thin Mn films on the Fe(001) surface have been investigated by a combination of photoelectron spectroscopy and computer simulation in the temperature range 300 Kless than or equal toTless than or equal to750 K. Room-temperature as deposited Mn overlayers are found to be ferromagnetic up to 2.5-monolayer (ML) coverage, with a magnetic moment parallel to that of the iron substrate. The Mn atomic moment decreases with increasing coverage, and thicker samples (4-ML and 4.5-ML coverage) are antiferromagnetic. Photoemission measurements performed while the system temperature is rising at constant rate (dT/dtsimilar to0.5 K/s) detect the first signs of Mn-Fe interdiffusion at T=450 K, and reveal a broad temperature range (610 Kless than or equal toTless than or equal to680 K) in which the interface appears to be stable. Interdiffusion resumes at Tgreater than or equal to680 K. Molecular dynamics and Monte Carlo simulations allow us to attribute the stability plateau at 610 Kless than or equal toTless than or equal to680 K to the formation of a single-layer MnFe surface alloy with a 2x2 unit cell and a checkerboard distribution of Mn and Fe atoms. X-ray-absorption spectroscopy and analysis of the dichroic signal show that the alloy has a ferromagnetic spin structure, collinear with that of the substrate. The magnetic moments of Mn and Fe atoms in the alloy are estimated to be 0.8mu(B) and 1.1mu(B), respectively.
Resumo:
The work presented in this article shows the power of the variable temperature, in-situ FT-IR spectroscopy system developed in Newcastle with respect to the investigation of fuel cell electro-catalysis. On the Ru(0001) electrode surface, CO co-adsorbs with the oxygen-containing adlayers to form mixed [CO+(2x2)-O(H)] domains. The electro-oxidation of the Ru(0001) surface leads to the formation of active (1x1)-O(H) domains, and the oxidation of adsorbed CO then takes place at the perimeter of these domains. At 20 degrees C, the adsorbed CO is present as rather compact islands. In contrast, at 60 degrees C, the COads is present as a relatively looser and weaker adlayer. Higher temperature was also found to facilitate the surface diffusion and oxidation of COads. No dissociation or electro-oxidation of methanol was observed at potentials below approximately 950mV; however, the Ru(0001) surface at high anodic potentials was observed to be very active. On both Pt and PtRu nanoparticle surfaces, only one linear bond CO adsorbate was formed from methanol adsorption, and the PtRu surface significantly promoted both methanol dissociative adsorption to CO and its further oxidation to CO2. Increasing temperature from 20 to 60 degrees C significantly facilitates the methanol turnover to CO2.
Resumo:
Ab initio total energy calculations within the Density Functional Theory framework were carried out for Pt(111), Pt(111)-p(2x2)-CO, Pt(111)-p(2x2)-O, and Pt(111)-p(2x2)-(CO+O) to provide an insight into the interaction between CO and O on metal surfaces, an important issue in CO oxidation, and also in promotion and poisoning effects of catalysis. The geometrical structures of these systems were optimized with respect to the total energy, the results of which agree with existing experimental values very well. It is found that (i) the local structures of Pt(111)-p(2x2)-(CO+O), such as the bond lengths of C-O, C-Pt, and O-Pt (chemisorbed O atom with Pt), are almost the same as that in Pt(111)-p(2x2)-CO and Pt(111)-p(2x2)-O, respectively, (ii) the total valence charge density distributions in Pt(111)-p(2x2)-(CO+O) are very similar to that in Pt(111)-p(2x2)-CO, except in the region of the chemisorbed oxygen atom, and also nearly identical to that in Pt(111)-p(2x2)-O, apart from in the region of the chemisorbed CO, and (iii) the chemisorption energy of CO on a precovered Pt(111)-p(2x2)-O and the chemisorption energy of O on a precovered Pt(111)-p(2x2)CO are almost equal to that in Pt(111)-p(2x2)-CO and Pt(111)-p(2x2)-O, respectively. These results indicate that the interaction between CO and chemisorbed oxygen on a metal surface is mainly shore range in nature. The discussions of Pt-CO and Pt-O bonding and the interaction between CO and the chemisorbed oxygen atom on Pt(111) are augmented by local densities of states and real space distributions of quantum states.
Resumo:
Using low-energy electron-diffraction (LEED) formalism, we demonstrate theoretically that LEED I-V spectra are characterized mainly by short-range order. We also show experimentally that diffuse LEED (DLEED) I-V spectra can be accurately measured from a disordered system using a video-LEED system even at very low coverage. These spectra demonstrate that experimental DLEED I-V spectra from disordered systems may be used to determine local structures. As an example, it is shown that experimental DLEED I-V spectra from K/Co {1010BAR} at potassium coverages of 0.07, 0.1, and 0.13 monolayer closely resemble calculated and experimental LEED I-V spectra for a well-ordered Co{1010BAR}-c(2X2)-K superstructure, leading to the conclusion that at low coverages, potassium atoms are located in the fourfold-hollow sites and that there is no large bond-length change with coverage.