Role of charge in the radioprotection of E. coli by thiols.

The role of net charge (Z) of thiols in their ability to radioprotect cells has been investigated in a glutathione (GSH)-deficient strain of E. coli. This strain, 7, is deficient in the enzyme gamma-glutamylcysteine synthetase and allows the effects of added low molecular weight thiols to be studied. Using the gas explosion system it is possible to measure the chemical repair of the free-radical precursors of lethal lesions by thiols in intact cells. The first-order chemical repair rate in strain 7 is 280s(-1) in comparison with 1100s(-1) in the wild-type strain 1157. From the measured difference in the intracellular concentration of GSH between the wild-type and the mutant, this gives a second-order repair rate, k(r)'s of 1.23 +/- 0.3 X 10(5) dm(3)mol(-1)s(-1). Measurement of intracellular thiol levels after addition of various low molecular weight thiols showed that uptake was rapid, leading to stable thiol levels within 1 min. The ratios of the intracellular to extracellular concentrations (C-in/C-out) were 0.74 for 3-mercaptopropionic acid (Z=-1), 0.56 for 2-mercaptoethanol (Z=0), 1.47 for cysteamine (Z=+1) and 1.04 for WR1065 (Z=+2). The k(r)'s for these thiols were 1.3 +/- 0.5 X 10(5) dm(3)mol(-1)s(-1) for 30-mercaptopropionic acid, 3.3 +/- 1.6 x 10(5) dm(3)mol(-1)s(-1) for 2-mercaptoethanol, 3.9 +/- 1.1 X 10(5) dm(3)mol(-1)s(-1) for cysteamine and 2.7 +/- 1.1 X 10(6) dm(3)mol(-1)s(-1) for WR1065. These are lower and increase less with charge than previously published values for chemical repair in isolated pBR322 DNA, probably because of the association of nucleoproteins and polyamines with the cellular DNA of E. coli. However, the approximate three-fold increase in k(r) per unit increase in Z shows that the counter-ion condensation and co-ion depletion are important in determining the effectiveness of charged thiols in the radioprotection of E. coli.

Influence of chloride, water, and organic solvents on the physical properties of ionic liquids

We report here the first systematic study of the effect of impurities and additives (e.g., water, chloride, and cosolvents) on the physical properties of room-temperature ionic liquids. Remarkably, it was discovered that the viscosity of mixtures was dependent mainly on the mole fraction of added molecular solvents and only to a lesser extent upon their identity, allowing viscosity changes during the course of a reaction to be entirely predictable. While the addition of such molecular solvents decreases the viscosity and density, chloride impurities, arising from the preparation of the ionic liquids, increase viscosity dramatically. The commonly used methods of preparation were validated with respect to chloride impurity.

Investigating the promotional effect of methanol on the low temperature SCR reaction on Ag/Al2O3

Methanol has been shown to promote the hydrocarbon selective catalytic reduction of NO with octane and toluene over 2wt% Ag/AlO catalyst for the first time. In order to understand its role in the reaction fast transient kinetic methods and in situ DRIFTS analysis have been used. The catalytic activity tests showed that the addition of methanol to the HC-SCR reaction results in a significant improvement in the low temperature activity of a Ag/AlO catalyst, despite the fact that methanol on its own is not reactive for the HC-SCR reaction. This promotional effect of methanol is dependent on the concentration of added methanol and is not necessarily associated with a higher concentration of reductant in the SCR feed. The fast transient kinetic analysis has shown that at each temperature the addition of methanol enhances the conversions of both NO and octane and the production of N with high selectivity in comparison with those observed with n-octane or toluene alone. This phenomenon is similar to the effect of H which may be associated with the release of hydrogen and ammonia during the transient switches at 250 and 300°C. Together with the fast transient experiments, the DRIFTS results showed that NCO species are formed when introducing methanol to the n-octane-SCR feed while CN species are removed/consumed from the surfaces of the Ag catalyst. These NCO species formed by adding methanol may play a vital role in promoting the catalytic activity of NO reduction and methanol itself can be an in situ source for hydrogen formation, which subsequently enhances the SCR reaction. © 2014 Elsevier B.V.

Investigation of organic xenobiotic transfers, partitioning and processing in air-soil-plant systems using a microcosm apparatus. Part I:Microcosm development

A microcosm system was developed to investigate transfers of organic xenobiotics in air-soil-plant systems. This was validated using ¹⁴C labelled 1,2-dichlorobenzene (DCB) as a model compound. Trapping efficiency was 106 ± 3% for volatile compounds and 93.0 ± 2.2% for carbon dioxide in a blank microcosm arrangement. Recovery of 1,2-dichlorobenzene spiked to grassed and unplanted soils was > 90% after 1 week. The predominant DCB loss process was volatilisation with no evidence for mineralisation over 1 week and 20-30% of the added spike remained in soil. Although there was no evidence for root uptake and translocation of added label, foliar uptake of soil volatilised compound was detected. The microcosm showed good potential for study of ¹⁴C labelled and unlabelled organic xenobiotic transfers in air-soil-plant systems with single plants and also intact planted cores.

Bioavailability of atrazine to soil microbes in the presence of the earthworm Lumbricus terrestrius (L.)

Experiments were conducted to investigate the interactions between an earthworm species (Lumbricus terrestrius) and soil microflora with respect to the bioavailability and mineralisation of ¹⁴C ring-labelled atrazine. Presence of earthworms had no affect on atrazine in soil solution (assayed by soil centrifugation). This soil solution pool was highly time dependent, decreasing considerably as the experiment proceeded. KCl-extractable label was, however, affected by the presence of earthworms, with this pool initially increasing in the presence of the worms. This pool was also highly time-dependent although, the pattern of this dependence did not follow that for label in soil solution. Mineralisation of the atrazine closely followed the KCl exchangeable pool and not that of the soil solution pool. However, label sorbed to the surface of the worms was closely correlated to the soil solution pool. Mineralisation in the presence of earthworms was double that of the controls. By the end of the experiment 6% of added radioactivity was present in the earthworm biomass.

Development and Validation of a Procedure for Numerical Vibration Analysis of an Oscillating Wave Surge Converter

During extreme sea states so called impact events can be observed on the wave energy converter Oyster. In small scale experimental tests these impact events cause high frequency signals in the measured load which decrease confidence in the data obtained. These loads depend on the structural dynamics of the model. Amplification of the loads can occur and is transferred through the structure from the point of impact to the load cell located in the foundation. Since the determination of design data and load cases for Wave Energy Converters originate from scale experiments, this lack of confidence has a direct effect on the development.

Numerical vibration analysis is a valuable tool in the research of the structural load response of Oyster to impact events, but must take into account the effect of the surrounding water. This can be done efficiently by adding an added mass distribution, computed with a linearised potential boundary element method. This paper presents the development and validation of a numerical procedure, which couples the OpenSource boundary element code NEMOH with the Finite Element Analysis tool CodeAster. Numerical results of the natural frequencies and mode shapes of the structure under the influence of added mass due to specific structural modes are compared with experimental results.

Designing photosensitizers for photodynamic therapy: strategies, challenges and promising developments

Photodynamic therapy (PDT) and photodynamic antimicrobial chemotherapy (PACT) are techniques that combine the effects of visible light irradiation with subsequent biochemical events that arise from the presence of a photosensitizing drug (possessing no dark toxicity) to cause destruction of selected cells. Despite its still widespread clinical use, Photofrin (R) has several drawbacks that limit its general clinical use. Consequently, there has been extensive research into the design of improved alternative photosensitizers aimed at overcoming these drawbacks. While there are many review articles on the subject of PDT and PACT, these have focused on the photosensitizers that have been used clinically, with little emphasis placed on how the chemical aspects of the molecule can affect their efficacy as PDT agents. Indeed, many of the PDT/PACT agents used clinically may not even be the most appropriate within a given class. As such, this review aims to provide a better understanding of the factors that have been investigated, while aiming at improving the efficacy of a molecule intended to be used as a photosensitizer. Recent publications, spanning the last 5 years, concerning the design, synthesis and clinical usage of photosensitizers for application in PDT and PACT are reviewed, including 5-aminolevulinic acid, porphyrins, chlorins, bacteriochlorins, texaphyrins, phthalocyanines and porphycenes. It has been shown that there are many important considerations when designing a potential PDT/PACT agent, including the influence of added groups on the lipophilicity of the molecule, the positioning and nature of these added groups within the molecule, the presence of a central metal ion and the number of charges that the molecule possesses. The extensive ongoing research within the field has led to the identification of a number of potential lead molecules for application in PDT/PACT. The development of the second-generation photosensitizers, possessing shorter periods of photosensitization, longer activation wavelengths and greater selectivity for diseased tissue provides hope for attaining the ideal photosensitizer that may help PDT and PACT move from laboratory investigation to clinical practice.

Nucleoside Azide-Alkyne Cycloaddition Reactions Under Solvothermal Conditions or Using Copper Vials in a Ball Mill

Novel nucleoside analogues containing photoswitchable moieties were prepared using 'click' cycloaddition reactions between 5 '-azido-5 '-deoxythymidine and mono- or bis-N-propargylamide-substituted azobenzenes. In solution, high to quantitative yields were achieved using 5mol% Cu(I) in the presence of a stabilizing ligand. 'Click' reactions using the monopropargylamides were also effected in the absence of added cuprous salts by the application of liquid assisted grinding (LAG) in metallic copper reaction vials. Specifically, high speed vibration ball milling (HSVBM) using a 3/32('') (2.38mm) diameter copper ball (62mg) at 60Hz overnight in the presence of ethyl acetate lead to complete consumption of the 5 '-azido nucleoside with clean conversion to the corresponding 1,3-triazole.

Environmental Value Added - Ein neues Maß zur Messung der Öko-Effizienz. (Environmental Value Added. A new measure for the measurement of eco-efficiency)

To increase eco-efficiency environmental information needs to be integrated into corporate decision making. For decision makers the interpretation of eco-efficiency as a ratio can however be quite difficult in practice. One of the reasons for this is, that eco-efficiency as a ratio is measured in a unit, that is difficult to interpret. This article therefore suggests an alternative measure for eco-efficiency. The Environmental Value Added, the measure proposed in this paper, reflects the excess economic benefit, resulting from the difference between the eco-efficiency under consideration and a benchmark eco-efficiency. It is measured in a purely monetary unit and is thus easier to interpret and integrate than eco-efficiency as a ratio.

Development of a value-added soil conditioner from high shear co-granulation of organic waste and limestone powder

This paper reports on a technical feasibility study of the production of organo-mineral fertiliser from the co-granulation of limestone powders with tea waste. The results from this preliminary study show that the co-granulation of tea waste provided an alternative method of waste recovery, as it converts the waste into a value-added product. Fertiliser granules were successfully produced from various compositions of limestone and tea waste. The effect of tea waste concentration on granule strength was analysed; the granule strength
was in the range 0.2 to 1.8 MPa depending on powder composition; increasing the tea waste mass fraction resulted in a reduction in granule strength.Varying the teawaste to limestone ratio also influenced the compressibility of the granules; the granules compressibility increased with increasing tea waste mass fraction. It was further found that increasing the mass fraction of tea waste in the binary mixture of powder reduced the granule median size of the batch.