Assessment of bioavailable arsenic and copper in soils and sediments from the Antofagasta region of northern Chile

Copper levels of nearly 500 mg l(-1) were measured in aqueous extracts of soil and sediment samples from the lowlands of Antofagasta. Arsenic levels of up to 183 mg l(-1) were found in river sediments, and 27.5 mg l(-1) arsenic was found at the location of a dam where potable water is extracted. This indicates that the arsenic contamination of water supplies reported recently for the pre-Andes may be a widespread problem throughout the region. Copper contamination from smelting activities also provides cause for concern as elevated levels were found in aqueous extracts of soil up to 20 km away from a smelter. This study went beyond traditional chemical analysis by assessing the potential benefits of using microbial biosensors as an alternative to determination of chemical speciation, to provide an environmentally relevant interpretation of soil/sediment residue levels. This approach is simple to use and enables a rapid, low cost assessment of pollutant bioavailability. It may, therefore, be of use for further investigations in the region and beyond.

Formation of soluble mercury oxide coatings: transformation of elemental mercury in soils

The impact of mercury (Hg) on human and ecological health has been known for decades. Although a treaty signed in 2013 by 147 nations regulates future large-scale mercury emissions, legacy Hg contamination exists worldwide and small scale releases will continue. The fate of elemental mercury, Hg(0), lost to the subsurface and its potential chemical transformation that can lead to changes in speciation and mobility are poorly understood. Here we show that Hg(0) beads interact with soil or manganese oxide solids and x-ray spectroscopic analysis indicates that the soluble mercury coatings are HgO. Dissolution studies show that after reacting with a composite soil, > 20 times more Hg is released into water from the coated beads than from a pure liquid mercury bead. An even larger, > 700 times, release occurs from coated Hg(0) beads that have been reacted with manganese oxide, suggesting that manganese oxides are involved in the transformation of the Hg(0) beads and creation of the soluble mercury coatings. Although the coatings may inhibit Hg(0) evaporation, the high solubility of the coatings can enhance Hg(II) migration away from the Hg(0)-spill site and result in potential changes in mercury speciation in the soil and increased mercury mobility.

Distribution of Uranium Contamination in Weathered Fractured Saprolite/Shale and Ground Water

The objective of this study was to determine how structure, stratigraphy, and weathering influence fate and transport of contaminants (particularly U) in the ground water and geologic material at the Department of Energy (DOE) Environmental Remediation Sciences Department (ERSD) Field Research Center (FRC). Several cores were collected near four former unlined adjoining waste disposal ponds. The cores were collected, described, analyzed for U, and compared with ground water geochemistry from surrounding multilevel wells. At some locations, acidic U-contaminated ground water was found to preferentially flow in small remnant fractures weathering the surrounding shale (nitric acid extractable U [UNA] usually <50 mg kg–1) into thin (

Development and validation of a lateral flow device for the detection of nicarbazin contamination in poultry feeds

Concentrations of the coccidiostat nicarbazin as low as 2 mg/kg in feed can result in violative drug residues arising in poultry liver. A lateral flow device (LFD) was developed for the detection of contaminating concentrations of nicarbazin following solvent extraction of poultry feeds. Test results, as determined by both visual and instrumental measurement, are available within minutes. For 22 feed samples, nicarbazin-free and fortified at 2 mg/kg, the % relative inhibition ranged from 0 to 45% and from 53 to 85%, respectively. Nicarbazin contamination at the critical concentration (2 mg/kg) can be determined in all cases providing the sampling is representative. A wide range of feed samples taken at a mill that incorporated nicarbazin into poultry feed were analyzed. Data generated for these samples by both the LFDs and a mass spectrometric method were compared, and a significant correlation was achieved.