Echolocation signal structure in the Megachiropteran bat Rousettus aegyptiacus Geoffroy 1810

Rousettus aegyptiacus Geoffroy 1810 is a member of the only genus of Megachiropteran bats to use vocal echolocation, but the structure of its brief, click-like signal is poorly described. Although thought to have a simple echolocation system compared to that of Microchiroptera, R. aegyptiacus is capable of good obstacle avoidance using its impulse sonar. The energy content of the signal was at least an order of magnitude smaller than in Microchiropteran bats and dolphins (approximately 4 X 10(-8) J m(-2)). Measurement of the duration, amplitude and peak frequency demonstrate that the signals of this animal are broadly similar in structure and duration to those of dolphins. Gabor functions were used to model signals and to estimate signal parameters, and the quality of the Gabor function fit to the early part of the signal demonstrates that the echolocation signals of R. aegyptiacus match the minimum spectral spread for their duration and amplitude and are thus well matched to its best hearing sensitivity. However, the low energy content of the signals and short duration should make returning echoes difficult to detect. The performance of R. aegyptincus in obstacle avoidance experiments using echolocation therefore remains something of a conundrum.

The Complexity of Approximately Solving Influence Diagrams

Influence diagrams allow for intuitive and yet precise description of complex situations involving decision making under uncertainty. Unfortunately, most of the problems described by influence diagrams are hard to solve. In this paper we discuss the complexity of approximately solving influence diagrams. We do not assume no-forgetting or regularity, which makes the class of problems we address very broad. Remarkably, we show that when both the treewidth and the cardinality of the variables are bounded the problem admits a fully polynomial-time approximation scheme.

Microcontroller based double beam modulation system for atomic scattering experiments

Double beam modulation is widely used in atomic collision experiments in the case where the noise arising froth each of the beams exceeds the measured signal. A method for minimizing the statistical uncertainty in a measured signal in a given time period is discussed, and a flexible modulation and counting system based on a low cost PIC microcontroller is described. This device is capable of modifying the acquisition parameters in real time during the course of an experimental run. It is shown that typical savings in data acquisition time of approximately 30% can be achieved using this optimized modulation scheme.