Safe fabrication of sharp gold tips for light emission in scanning tunnelling microscopy

Gold is the optimal tip metal for light emission in scanning tunnelling microscopy (LESTM) under ambient conditions. Sharp Au-tips of similar to 10nm radius were produced reliably using a safe, two-step etching method in 20% (w/w) CaCl2 solution. Previous CaCl2-based methods have tended to produce blunter tips, while other etching techniques that do produce sharp Au-tips, do so with the use of toxic or hazardous electrolytes. The tips are characterised using scanning electron microscopy and their efficacy in LESTM is evidenced by high-resolution, simultaneous topographic and photon mapping of Au(1 1 1)- and polycrystalline Au-surfaces. Spectra of the optical emission exhibit only one or two peaks with etched tips in contrast to the more complex spectra typical of cut tips; this feature, together with the highly symmetric geometry of the tips, facilitates a definitive analysis of the light emission process. (c) 2007 Elsevier B. V.. All rights reserved.

Chemical etching of optical fibre tips - experiment and model

The formation of chemically etched fibre tips for use in optical scanning probe microscopy is addressed. For tips formed at a cleaved fibre end in the bulk of a buffered HF acid solution the morphological features (tip height, cone angle) are found to depend strongly on the temperature and etchant composition. The tip formation process is analysed and explained in terms of a simple model in which the only pertinent physical parameters are the fibre core diameter and etch rates of the fibre core and cladding. The etch rates are determined in separate experiments as a function of temperature (in the range 24-50 degreesC) for etchant solutions of de ionised water: 50% HF acid: 40% NH4F in the volume ratio 1 : 1 : X for X=2, 4 and 6, and used in the model to yield a correct description of the experimental tip cone angles. The model is successfully extended to the intriguing case of negative tip formation which initiates in a normal, positive tip structure. By contrast, tip formation in the meniscus region of a bare fibre/etchant/organic solvent system is found to be independent of etchant composition and temperature. (C) 2000 Elsevier Science B.V. All rights reserved.

A Pilot Evaluation of the Palliative Performance Scale in Long Term Care: Tips for Success

Aims: Palliative care in long-term care (LTC) homes is an area of growing concern. Little work has been done to explore innovative ways to identify and care for residents who become palliative. The purpose of this intervention study was to evaluate the implementation of the Palliative Performance Scale (PPS) in LTC. Specifically we explored staff perceptions about implementing the PPS and how it cued staff to initiate palliative care discussion with residents and family when a resident’s health declined.

Methods: This study utilized a qualitative descriptive design that included data from four separate sources: journals of three ‘champions’ who were responsible for leading the implementation of the PPS; staff evaluations of three educational training sessions; minutes from meetings; and 11 interviews from key staff who were involved in the implementation process. Data were analyzed using thematic content analysis.

Results: Staff generally felt positively about using the PPS in LTC and stated that it increased awareness of palliative care and helped identify those residents who were nearing the end of life. There were some barriers to implementing it, such as staff resistance and lack of time to complete it. The importance of having a designated ‘champion’ and effective interdisciplinary communication in addition to widespread training, were identified as successful strategies to facilitate the implementation process.

Conclusion: These study findings support the use of the PPS in LTC and offer some perspective about ways to implement it successfully. Future work is needed to evaluate the PPS in LTC using more rigorous designs.

Raman Analysis of Dilute Aqueous Samples by Localized Evaporation of Submicroliter Droplets on the Tips of Superhydrophobic Copper Wires

Raman analysis of dilute aqueous solutions is normally prevented by their low signal levels. A very general method to increase the concentration to detectable levels is to evaporate droplets of the sample to dryness, creating solid deposits which are then Raman probed. Here, superhydrophobic (SHP) wires with hydrophilic tips have been used as supports for drying droplets, which have the advantage that the residue is automatically deposited at the tip. The SHP wires were readily prepared in minutes using electroless galvanic deposition of Ag onto copper wires followed by modification with a polyfluorothiol (3,3,4,4,5,5,6,6,7,7,8,8,9,9,10,10,10-heptadecafluoro-1-decanethiol, HDFT). Cutting the coated wires with a scalpel revealed hydrophilic tips which could support droplets whose maximum size was determined by the wire diameter. Typically, 230 μm wires were used to support 0.6 μL droplets. Evaporation of dilute melamine droplets gave solid deposits which could be observed by scanning electron microscopy (SEM) and Raman spectroscopy. The limit of detection for melamine using a two stage evaporation procedure was 1 × 10^-6 mol dm^-3. The physical appearance of dried droplets of sucrose and glucose showed that the samples retained significant amounts of water, even under high vacuum. Nonetheless, the Raman detection limits of sucrose and glucose were 5 × 10^-4 and 2.5 × 10^-3 mol dm^-3, respectively, which is similar to the sensitivity reported for surface-enhanced Raman spectroscopy (SERS) detection of glucose. It was also possible to quantify the two sugars in mixtures at concentrations which were similar to those found in human blood through multivariate analysis.

The Effect of Tacticity on the Conformational Properties of Poly(1-olefin sulfone)s

The effect of tacticity on the conformational properties of poly(olefin sulfone)s was studied. Tactic polymers, prepared from racemic thiirane monomers using chiral inititators were compared with atactic polymers prepared by free radical co-polymerisation of the 1-olefin with sulfur dioxide. Analysis of the XRD patterns showed that the tactic polymers formed more ordered structures in the bulk with longer layer spacings, consistent with a model in which their side chains meet at the tips in contrast with the atactic polymers whose side chains interdigitate. 13C MAS nmr experiments suggest that as tacticity increases so too does the proportion of C-S bonds in the gauche conformation, however the proportion of S-C bonds in the trans conformation falls, in contrast to a reported molecular mechanics study. Finally, DSC measurements on the polymers with longer side chains showed the presence of two endotherms on heating, illustrating definite liquid crystalline behaviour.

Investigation of an electron string ion source with field emission cathode

The string mode of operation for an electron beam ion source uses axially oscillating electrons in order to reduce power consumption, also simplifying the construction by omitting the collector with cooling requirements and has been called electron string ion source (ESIS). We have started a project (supported by INTAS and GSI) to use Schottky field emitting cathode tips for generating the electron string. The emission from these specially conditioned tips is higher by orders of magnitude than the focused Brillouin current density at magnetic fields of some Tesla and electron energies of some keV. This may avoid the observed instabilities in the transition from axially oscillating electrons to the string state of the electron plasma, opening a much wider field of possible operating parameters for an ESIS. Besides the presentation of the basic features, we emphasize in this paper a method to avoid damaging of the field, emission tip by backstreaming ions. (C) 2008 American Institute of Physics.

A Research Guide for Health & Clinical Psychology

This must-have, practical guide for trainee psychologists working towards their British Psychological Society (BPS) qualification in either health psychology or clinical psychology is designed to address the key concerns and questions that students often have when applying research designs in real settings.

The book:

- looks specifically at what is required to demonstrate research competence for the qualifications;
- is structured around a simple question-and-answer format, making it easy to navigate;
- is packed full of tips, including on ethical considerations and conducting qualitative and quantitative research designs; and
- uses health and clinical psychology research examples to highlight key issues for trainees.

Light emission from gold and silver thin films in a scanning tunneling microscope: role of contamination and interpretation of grain structure in photon maps

Scanning tunnelling microscope (STM) tip-induced light emission from Au and Ag has been studied. Thin film samples similar to100nm thick were prepared by thermal evaporation at 0.5nm/s onto a room-temperature glass substrate to produce grains of 20-50nm in lateral dimension at the surface. Light emission from the samples in the STM was quasi-simultaneously recorded with the topography, at 1.8V tip bias and 3-40nA current, alternating pixel by pixel at the same bias. Typically, a surface scan range of 150 nm x 150 nm was surveyed. Au, W and PtIr tips were used.

Characterization of Numb expression in astrocytomas

During early neurodevelopment, asymmetric segregation of Numb in mitotic progenitor cells influences the fate of daughter cells, whereby one daughter retains the progenitor phenotype while the other proceeds along a differentiation pathway. Numb has also been reported to function as a tumor suppressor in breast cancers and medulloblastomas. Given its role in maintaining neural progenitor pools in animal models and its reported role as a tumor suppressor, Numb could potentially contribute to astrocytoma oncogenesis. We characterized Numb expression in both human astrocytoma tissue samples and glioblastoma cell lines. We found that Numb is expressed in all grades of astrocytomas, being predominantly cytoplasmic in higher-grade astrocytomas but nuclear in pilocytic astrocytomas. Numb is also present in normal neurons, but not in normal astrocytes. In cultured glioblastoma cells, Numb concentrates in the perinuclear region and process tips. Numb expression in astrocytomas recapitulates that of progenitor cells during neurodevelopment, and suggests a role for Numb in astrocytoma oncogenesis.