Physicochemical and mineralogical characteristics of soil/saprolite cores from a field research site, Tennessee

Site characterization is an essential initial step in determining the feasibility of remedial alternatives at hazardous waste sites. Physicochemical and mineralogical characterization of U-contaminated soils in deeply weathered saprolite at Area 2 of the DOE Field Research Center (FRC) site, Oak Ridge, TN, was accomplished to examine the feasibility of bioremediation. Concentrations of U in soil–saprolite (up to 291 mg kg–1 in oxalate-extractable Uo) were closely related to low pH (ca. 4–5), high effective cation exchange capacity without Ca (64.7–83.2 cmolc kg–1), amorphous Mn content (up to 9910 mg kg–1), and the decreased presence of relative clay mineral contents in the bulk samples (i.e., illite 2.5–12 wt. %, average 32 wt. %). The pH of the fill material ranged from 7.0 to 10.5, whereas the pH of the saprolite ranged from 4.5 to 8. Uranium concentration was highest (about 300 mg kg–1) at around 6 m below land surface near the saprolite–fill interface. The pH of ground water at Area 2 tended to be between 6 and 7 with U concentrations of about 0.9 to 1.7 mg L–1. These site specific characteristics of Area 2, which has lower U and nitrate contamination levels and more neutral ground water pH compared with FRC Areas 1 and 3 (ca. 5.5 and

Analysis and comparison of displacement granular pile anchors

Granular piles can resist only compressive and shear loads owing to their inherent nature. By a simple modification of providing a pedestal/geogrid at the bottom and attaching a cable to the same, they are made to resist pullout/uplift forces. This paper presents an analysis of granular pile anchor (GPA), considering it and the in situ soil to behave linearly and the in situ ground to be semi-infinite. A parametric study presents results in the form of variations of normalised shear stress, displacement influence coefficient and axial uplift force with depth with relative stiffness factor. Two methods for the estimation of deformation moduli of the GPA and the in situ soil are proposed. Based on the estimated values of the moduli, the displacements of GPA were estimated and the results compared with test results of Kumar (2002). The predicted displacements compare well with the measured ones.

Just a matter of time: Fungi and roots significantly and rapidly aggregate soil over four decades along the Tagliamento River, NE Italy

Fluvial islands are emergent landforms which form at the interface between the permanently inundated areas of the river channel and the more stable areas of the floodplain as a result of interactions between physical river processes, wood and riparian vegetation. These highly dynamical systems are ideal to study soil structure development in the short to medium term, a process in which soil biota and plants play a substantial role. We investigated soil structure development on islands along a 40 year chronosequence within a 3 km island-braided reach of the Tagliamento River, Northeastern Italy. We used several parameters to capture different aspects of the soil structure, and measured biotic (e.g., fungal and plant root parameters) and abiotic (e.g. organic carbon) factors expected to determine the structure. We estimated models relating soil structure to its determinants, and, in order to confer statistical robustness to our results, we explicitly took into account spatial autocorrelation, which is present due to the space for time substitution inherent in the study of chronosequences and may have confounded results of previous studies. We found that, despite the eroding forces from the hydrological and geomorphological dynamics to which the system is subject, all soil structure variables significantly, and in some case greatly increased with site age. We interpret this as a macroscopic proxy for the major direct and indirect binding effects exerted by root variables and extraradical hyphae of arbuscular mycorrhizal fungi (AMF). Key soil structure parameters such as percentage of water stable aggregates (WSA) can double from the time the island landform is initiated (mean WSA = 30%) to the full 40 years (mean WSA = 64%) covered by our chronosequence. The study demonstrates the fundamental role of soil biota and plant roots in aggregating soils even in a system in which intense short to medium term physical disturbances are common.

Interactions between soil, toxicant, and a lux-marked bacterium during solid phase-contact toxicity testing

Bioluminescence-based, solid-contact toxicity assays allow test bacterium and toxicant to interact at the solid-solution interface. A lux- marked bacterium, Burkholderia sp. RASC, and 2,4-dichlorophenol (2,4-DCP) were used to characterize these interactions. In the basic bioassay, cells were added to soil slurries containing 2,4-DCP (0-120 μg ml^-1). After 15 min, soil was removed by centrifugation, and bioluminescence in the supernatant was determined. Investigation of 2,4-DCP adsorption to soil revealed that sorption was linear and not significantly (p > 0.1) affected by the presence of Burkholderia cells. The numbers of culturable Burkholderia cells in the assay supernatant were 48.2 to 64.8% of the inoculum and independent of the soil weight. The effect of soil on 2,4-DCP toxicity was investigated by comparing soil aqueous extract and contact assays. The percentage bioluminescence for the contact assay was consistently higher than the extract assay at all test concentrations, and counts of viable Burkholderia cells were enhanced by the presence of 2,4-DCP in the contact assay. Expressing results as specific bioluminescence decreased the variability in response and the discrepancy in results between the two protocols. We suggest that solid-contact assays need improvement to ensure defined contact between cells and solid phase, and that the reporting of specific activity should be emphasized.

Hardware Software Interface: a Strategy for the implementation of Urban Agriculture

This paper describes how urban agriculture differs from conventional agriculture not only in the way it engages with the technologies of growing, but also in the choice of crop and the way these are brought to market. The authors propose a new model for understanding these new relationships, which is analogous to a systems view of information technology, namely Hardware-Software- Interface.
The first component of the system is hardware. This is the technological component of the agricultural system. Technology is often thought of as equipment, but its linguistic roots are in ‘technis’ which means ‘know how’. Urban agriculture has to engage new technologies, ones that deal with the scale of operation and its context which is different than rural agriculture. Often the scale is very small, and soils are polluted. There this technology in agriculture could be technical such as aquaponic systems, or could be soil-based agriculture such as allotments, window-boxes, or permaculture. The choice of method does not necessarily determine the crop produced or its efficiency. This is linked to the biotic that is added to the hardware, which is seen as the ‘software’.
The software of the system are the ecological parts of the system. These produce the crop which may or may not be determined by the technology used. For example, a hydroponic system could produce a range of crops, or even fish or edible flowers. Software choice can be driven by ideological preferences such as permaculture, where companion planting is used to reduce disease and pests, or by economic factors such as the local market at a particular time of the year. The monetary value of the ‘software’ is determined by the market. Obviously small, locally produced crops are unlikely to compete against intensive products produced globally, however the value locally might be measured in different ways, and might be sold on a different market. This leads to the final part of the analogy - interface.
The interface is the link between the system and the consumer. In traditional agriculture, there is a tenuous link between the producer of asparagus in Peru and the consumer in Europe. In fact very little of the money spent by the consumer ever reaches the grower. Most of the money is spent on refrigeration, transport and profit for agents and supermarket chains. Local or hyper-local agriculture needs to bypass or circumvent these systems, and be connected more directly to the consumer. This is the interface. In hyper-localised systems effectiveness is often more important than efficiency, and direct links between producer and consumer create new economies.