Ecotoxicological screening of Kenyan tannery dust using a luminescent-based bacterial biosensor

Ecotoxicological screening of dust sampled throughout a Kenyan tannery was conducted using a luminescence (lux)-based bacterial biosensor for both solid and liquid assays. This was complemented by chemical analysis in an attempt to identify possible causative toxic components. The biosensor results showed a highly significant (p <0.001) difference in both solid and liquid phase toxicity in samples collected from various identified sampling points in the tannery. A positive correlation was observed between results of the solid and liquid phase techniques, for most of the sampling points indicating that the toxic contaminants were bioavailable both in the solid and liquid state. However, the results generally indicated toxicity associated with liquid phase except certain areas in solid phase such as chemical handling, buffing area and weighing. The most toxic tannery area identified was the weighing area (p <0.001), showing the lowest bioluminescence for both the solid (0.38 +/- 2.21) and liquid phases (0.01 +/- 0.001). Chromium was the metal present in the highest concentration indicating levels higher than the stipulated regulatory requirement of 0.5 mg Cr/m3 for total Cr (highest Cr concentration was at chemical handling at 209.24 mg l(-1)) in all dust samples. The weighing area had the highest Ni concentration (1.87 mg l(-1)) and the chemical handling area showed the highest Zn concentration (31.9 mg l(-1)). These results raise environmental health concerns, as occupational exposure to dust samples from this site has been shown to give rise to elevated concentrations (above the stipulated levels) of chromium in blood, urine and some body tissues, with inhalation being the main route. Health and Safety Executive (HSE), UK, and American Conference of Governmental Industrial Hygienist (ACGIH) and National Institute for Occupational Safety and Health (NIOSH), USA stipulates an occupational exposure limit of 0.5 mg Cr/m3 (8 h TWA) for total chromium. However, schedule 1 of Controls of substances hazardous to health (COSHH) regulations developed by HSE, indicate 0.05 mg m3 (8 h TWA reference periods) to be the limit for Cr (VI) exposure. The exposure limit for individual (e.g., Cr, Zn, Ni etc.) contaminants (homogeneity) was not exceeded, but potential impact of heterogeneity (multi-element synergistic effect) on toxicity requires application of the precautionary principle.

Resource utilization and cost analyses of home-based palliative care service provision:The Niagara West End-of-Life Shared-Care Project

Background: Increasing emphasis is being placed on the economics of health care service delivery - including home-based palliative care. Aim: This paper analyzes resource utilization and costs of a shared-care demonstration project in rural Ontario (Canada) from the public health care system's perspective. Design: To provide enhanced end-of-life care, the shared-care approach ensured exchange of expertise and knowledge and coordination of services in line with the understood goals of care. Resource utilization and costs were tracked over the 15 month study period from January 2005 to March 2006. Results: Of the 95 study participants (average age 71 years), 83 had a cancer diagnosis (87%); the non-cancer diagnoses (12 patients, 13%) included mainly advanced heart diseases and COPD. Community Care Access Centre and Enhanced Palliative Care Team-based homemaking and specialized nursing services were the most frequented offerings, followed by equipment/transportation services and palliative care consults for pain and symptom management. Total costs for all patient-related services (in 2007 CAN) were 1,625,658.07 - or 17,112.19 per patient/117.95 per patient day. Conclusion: While higher than expenditures previously reported for a cancer-only population in an urban Ontario setting, the costs were still within the parameters of the US Medicare Hospice Benefits, on a par with the per diem funding assigned for long-term care homes and lower than both average alternate level of care and hospital costs within the Province of Ontario. The study results may assist service planners in the appropriate allocation of resources and service packaging to meet the complex needs of palliative care populations. © 2012 The Author(s).

Biosensor based toxicity dissection of tannery and associated environmental samples

Kenyan tannery and associated environmental samples were selected for ecotoxicological assessment. A tool-kit of techniques was developed, including whole-cell biosensor and chemical assays. A luminescence based bacterial biosensor (Escherichia coli HB101 pUCD607) (via a multi-copy plasmid) was used for toxicity assessment. Samples were manipulated prior to biosensor interrogation to identify the nature of the toxic contaminants. Untreated samples (before any manipulations) showed a strong toxic effect at the discharge point in comparison to other sampling points. Sparging was used to identify toxicity associated with volatile organics. The toxicity of contaminants, removed by treatment with activated charcoal was identified for all the sampling points except for those upstream of effluent discharges. Filtration identified toxicity associated with suspended solids. Changes in availability of toxic contaminants due to pH adjustment of most samples from the tannery effluent treatment pits were also associated with the extreme pH values (4.0 and 8.0). The approach used has highlighted the complexicity of toxic pollutants in effluent from the tanning industry and the dissection of toxicity points to possible remediation strategies for effluents from the tanning industry.

A comparison of nitogen fate and transport in catchments underlain by high and low permeability aquifers using chemical and isotopic tools.

Variability in nitrogen fate and transport in different catchments types is often not considered. This research considers the importance of such nitrogen processes within groundwater pathways in two agricultural catchments in Ireland; a well drained catchment, underlain by karstified Carboniferous limestone, and a poorly drained catchment, underlain by Silurian greywacke.
Depth specific low-flow groundwater sampling was used to evaluate the hydrochemical stratification in groundwater. Groundwater samples, as well as surface water samples, along river courses were analysed for nitrogen species (NO3, NH4 and NO2) and nitrate isotopes (d15N and d18O) as well as field parameters and major ions
.
The dominant nitrate (NO3) groundwater pathway in the poorly drained greywacke catchment is through the shallow weathered bedrock, as indicated by transmissivity values and the ionic and isotopic signatures, and a clear reduction in NO3 concentration is observed with depth. A similar chloride trend would suggest dilution is a major factor, however d15N and d18O isotopic values producing an enrichment ratio of 1.8 indicate that denitrification is also an important process involved in the fate of the NO3 within the groundwater flow system. This consistent trend with depth is in contrast to the stratification pattern observed in the karstified catchment. NO3 was not detected in the shallow groundwater pathway; the dominant groundwater pathway is in the deeper groundwater where there is little change in the nitrate isotope values with depth (d15N values range between 4.1 and 4.6 ‰). This deeper groundwater contributes the dominant proportion of the river flow through a number of springs. As a result, the deeper groundwater, springs and river have a similar ionic signature and NO3 concentration range (23 ± 3 mg/l). Despite this pattern, the NO3 isotopes show a distinct difference in isotopic values between the deeper groundwater in the diffuse karst and the springs indicating some denitrification is occurring during groundwater discharge into the river. Furthermore the isotopes give an indication of the variability of the spatial extent of the springs and the complexities of the fissures through which they are fed. The results of this study clearly show the importance of the geology in the fate and transport of NO3 in agricultural catchments.

Pathways for delivery of surface water nutrients to receptors

Diffuse contaminants can make their way into rivers via a number of different pathways, including overland flow, interflow, and shallow and deep groundwater. Identification of the key pathway(s) delivering contaminants to a receptor is important for implementing effective water management strategies. The ‘Pathways Project’, funded by the Irish Environmental Protection Agency, is developing a catchment management tool that will enable practitioners to identify the critical source areas for diffuse contaminants, and the key pathways of interest in assessing contaminant problems on a catchment and sub-catchment scale.
One of the aims of the project is to quantify the flow and contaminant loadings being delivered to the stream via each of the main pathways. Chemical separation of stream event hydrographs is being used to supplement more traditional physical hydrograph separation methods. Distinct, stable chemical signatures are derived for each of the pathway end members, and the proportion of flow from each during a rainfall event can be determined using a simple mass balance approach.
Event sampling was carried out in a test catchment underlain by poorly permeable soils and bedrock, which is predominantly used for grazing with a number of one-off rural residential houses. Results show that artificial field drainage, which includes subterranean land drains and collector drains around the perimeters of the 1 to 10 ha fields, plays an important role in the delivery of flow and nutrients to the streams in these types of hydrogeological settings.
Nitrate infiltrates with recharge and is delivered to the stream primarily via the artificial drains and the shallow groundwater pathway. Longitudinal stream profiles show that the nitrate load input is relatively uniform over the 8 km length of the stream at high flows, suggesting widespread diffuse contaminant input. In contrast, phosphorus is adsorbed in the clay-rich soil and is transported mainly via the overland flow pathway and the artificial drains. Longitudinal stream profiles for phosphorus suggest a pattern of more discrete points of phosphorus inputs, which may be related to point sources of contamination.
These techniques have application elsewhere within a toolkit of methods for determining the key pathways delivering contaminants to surface water receptors.

An ecotoxicological approach to assessing the impact of tanning industry effluent on river health

A study was conducted to investigate the sediment health and water quality of the River Sagana, Kenya, as impacted by the local tanning industry. Chemical analysis identified the main chemical pollutants (pentachlorophenols and chromium) while a bioassay addressed pollutant bioavailability. The bioassay, exploiting the luminescence response of a lux marked bacterial biosensor, was coupled to a dehydrogenase and Dapnia magna test to determine toxicity effects on sediments. Results highlighted the toxicity of the tannery effluent to the sediments at the point of discharge (64% of control bioluminescence) with gradual improvement downstream. There was a significant increase in dehydrogenase downstream, with the enzyme activity attaining a peak at 600 m, also indicating a gradual reduction of toxicity. Biological oxygen demand (19.56 mg L(-1)) dissolved oxygen (3.97 mg L(-1)) and high lethal dose value (85%) of D. magna also confirmed an initial stress at the point of discharge and recovery downstream. Optical density of surface water demonstrated an increase in suspended particulates and colour after the discharge point, eventually decreasing beyond 400 m. In conclusion, the study highlighted the importance of understanding the biogeochemistry of river systems impacted by industries discharging effluent into them and the invaluable role of a biosensor-based ecotoxicological approach to address effluent hazards, particularly in relation to river sediments.

Assessing the occupational risk of dust particles in the Kenyan tanning industry using rapid image processing and microscopy techniques

The purpose of this study was to investigate the occupational hazards within the tanning industry caused by contaminated dust. A qualitative assessment of the risk of human exposure to dust was made throughout a commercial Kenyan tannery. Using this information, high-risk points in the processing line were identified and dust sampling regimes developed. An optical set-up using microscopy and digital imaging techniques was used to determine dust particle numbers and size distributions. The results showed that chemical handling was the most hazardous (12 mg m(-3)). A Monte Carlo method was used to estimate the concentration of the dust in the air throughout the tannery during an 8 h working day. This showed that the high-risk area of the tannery was associated with mean concentrations of dust greater than the UK Statutory Instrument 2002 No. 2677. stipulated limits (exceeding 10 mg m(-3) (Inhalable dust limits) and 4 mg m(-3) (Respirable dust limits). This therefore has implications in terms of provision of personal protective equipment (PPE) to the tannery workers for the mitigation of occupational risk.

Enhancing family physician capacity to deliver quality palliative home care:An end-of-life, shared-care model

PROBLEM BEING ADDRESSED: Family physicians face innumerable challenges to delivering quality palliative home care to meet the complex needs of end-of-life patients and their families. OBJECTIVE OF PROGRAM: To implement a model of shared care to enhance family physicians' ability to deliver quality palliative home care, particularly in a community-based setting. PROGRAM DESCRIPTION: Family physicians in 3 group practices (N = 21) in Ontario's Niagara West region collaborated with an interprofessional palliative care team (including a palliative care advanced practice nurse, a palliative medicine physician, a bereavement counselor, a psychosocial-spiritual advisor, and a case manager) in a shared-care partnership to provide comprehensive palliative home care. Key features of the program included systematic and timely identification of end-of-life patients, needs assessments, symptom and psychosocial support interventions, regular communication between team members, and coordinated care guided by outcome-based assessment in the home. In addition, educational initiatives were provided to enhance family physicians' knowledge and skills. CONCLUSION: Because of the program, participants reported improved communication, effective interprofessional collaboration, and the capacity to deliver palliative home care, 24 hours a day, 7 days a week, to end-of-life patients in the community.

A Framework for Context-Driven End-to-End QoS Control in Converged Next Generation Networks”

This paper presents a framework for context-driven policy-based QoS control and end-to-end resource management in converged next generation networks. The Converged Networks QoS Framework (CNQF) is being developed within the IU-ATC project, and comprises distributed functional entities whose instances co-ordinate the converged network infrastructure to facilitate scalable and efficient end-to-end QoS management. The CNQF design leverages aspects of TISPAN, IETF and 3GPP policy-based management architectures whilst also introducing important innovative extensions to support context-aware QoS control in converged networks. The framework architecture is presented and its functionalities and operation in specific application scenarios are described.

Buffer Management for Multimedia QoS control over HSDPA Downlink

HSDPA specifications include support for a flexible framework for QoS management. In this paper, it is shown how buffer management could be incorporated into HSDPA QoS framework for 'multimedia' traffic QoS control in the MAC-hs of the Node-B. A time-space-priority (TSP) scheme is proposed as viable buffer management scheme to this effect. Comparative simulation study with other schemes is presented, demonstrating the effectiveness of the TSP buffer management scheme for 'multimedia' service QoS control in HSDPA Node-B data buffers