Extreme ultraviolet emission lines of Ca XV in solar and laboratory spectra

New R-matrix calculations of electron impact excitation rates in Ca XV are used to derive theoretical electron density diagnostic emission line intensity ratios involving 2s(2)2p(2)- 2s2p(3) transitions, specifically R-1 = I(208.70 Angstrom)/I(200.98 Angstrom), R-2 = I(181.91 Angstrom)/I(200.98 Angstrom), and R-3 = I(215.38 Angstrom)/I(200.98 Angstrom), for a range of electron temperatures (T-e = 10(6.4)-10(6.8) K) and densities (Ne = 10(9)-10(13) cm(-3)) appropriate to solar coronal plasmas. Electron densities deduced from the observed values of R-1, R-2, and R-3 for several solar flares, measured from spectra obtained with the Naval Research Laboratory's S082A spectrograph on board Skylab, are found to be consistent. In addition, the derived electron densities are in excellent agreement with those determined from line ratios in Ca XVI, which is formed at a similar electron temperature to Ca XV. These results provide some experimental verification for the accuracy of the line ratio calculations, and hence the atomic data on which they are based. A set of eight theoretical Ca XV line ratios involving 2s(2)2p(2)-2s2p(3) transitions in the wavelength range similar to140-216 Angstrom are also found to be in good agreement with those measured from spectra of the TEXT tokamak plasma, for which the electron temperature and density have been independently determined. This provides additional support for the accuracy of the theoretical line ratios and atomic data.

Electron impact excitation of Ar XVII

Energies for the lowest 49 levels among the 1s(2) and 1snl (n = 2-5) configurations of Ar XVII have been calculated using the GRASP code of Dyall et al. (1989, Comput. Phys. Comm., 55, 424). Additionally, radiative rates, oscillator strengths, and line strengths are calculated for all electric dipole (E1), magnetic dipole (M1), electric quadrupole (E2), and magnetic quadrupole (M2) transitions among these levels. Furthermore, collision strengths have also been calculated for all the 1176 transitions among the above 49 levels using the Dirac Atomic R-matrix Code (DARC) of Norrington & Grant (2005, Comput. Phys. Commun., in preparation), over a wide energy range up to 580 Ryd. Resonances have been resolved in the threshold region, and effective collision strengths have been obtained over a wide temperature range up to log T-e = 7.2 K. Comparisons are made with the limited results available in the literature, and the accuracy of the data is assessed. Our energy levels are estimated to be accurate to better than 0.1%, whereas results for other parameters are probably accurate to better than 20%.

Excitation rates for transitions in Ca XV

Collision strengths for transitions among the energetically lowest 46 fine-structure levels belonging to the (1s(2)) 2s(2)2p(2), 2s2p(3), 2p(4), and 2s(2)2p3l configurations of Ca XV are computed, over a wide electron energy range below 300 Ryd, using the Dirac Atomic R-matrix Code (DARC) of Norrington & Grant (2003). Resonances in the threshold region have been resolved in a fine energy mesh, and excitation rates are determined over a wide electron temperature range below 10(7) K. The results are compared with those available in the literature, and the accuracy of the data is assessed.

Radiative rates for transitions in Fe XVII

Energies of the lowest 157 levels belonging to the (1s(2)) 2s(2)2p(6), 2s(2)p(5)3l, 2s(2)2p(5)4l, 2s(2)2p(5)4l, 2s2p(5)5l, 2s2p(6)4l and 2s2p(6)5l configurations of Fe XVII have been calculated using the GRASP code of Dyall et al. (1989). Additionally, radiative rates, oscillator strengths, and line strengths are calculated for all electric dipole (E I), magnetic dipole (M I), electric quadrupole (E2), and magnetic quadrupole (M2) transitions among these levels. Comparisons are made with the results already available in the literature, and the accuracy of the data is assessed. Our energy levels are expected to be accurate to better than M whereas results for other parameters are probably accurate to better than 20%.

Effective collision strengths for transitions in Fe XV

Collision strengths for transitions among the energetically lowest 53 fine-structure levels belonging to the (1s(2)2s(2)2p(6)) 3l(2), 3l3l', 3s4l and 3p4s configurations of Fe XV are computed, over an electron energy range below 160 Ryd, using the Dirac Atomic R-matrix Code (DARC) of Norrington & Grant (2003). Effective collision strengths, obtained after integrating the collision strengths over a Maxwellian distribution of electron energies, have also been calculated. These results of effective collision strengths are tabulated for all 1378 inelastic transitions over a wide temperature range of 10(5) to 10(7) K. Comparisons are also made with other R-matrix calculations and the accuracy of the results is assessed.

Energy levels, radiative rates, and collision strengths for transitions in Fe XVII

Energy levels and radiative rates have been calculated for fine-structure transitions among the lowest 89 levels of the (1s(2)) 2s(2)2p(6), 2s(2) 2p(5) 3 l, 2s(2) 2p(5) 4l, 2s2p(6) 3 l, and 2s2p(6)4l configurations of Fe XVII using the GRASP code of Dyall et al. Collision strengths have also been calculated, for transitions among the lowest 55 levels, using the recently developed Dirac atomic R-matrix code (DARC) of Norrington & Grant. The results are compared with those available in the literature, and the accuracy of the data is assessed.

Effective collision strengths for transitions among the 3s(2), 3s3p and 3p(2) configurations of Fe xv

Effective collision strengths for transitions among the ten energetically lowest fine-structure levels belonging to the (1s(2)2s(2)2p(6))3s(2), 3s3p and 3p(2) configurations of Fe xv have been calculated in the electron temperature range of 10(5)-10(7) K, using the recent Dirac atomic R-matrix code of Norrington and Grant. The results are compared with the other recently available independent Breit-Pauli R-matrix calculations of Eissner et al (Eissner W, Galavis M E, Mendoza C and Zeippen C J 1999 Astron. Astrophys. Suppl. 137 165) and Griffin et al (Griffin DC, Badnell N R, Pindzola M S and Shaw J A 1999 J. Phys. B: At. Mol. Opt. Phys. 32 2139, 4129). Large differences are observed for many transitions over almost the entire temperature range. These differences are analysed and discussed, and the accuracy of the calculations is assessed.

Energy levels and radiative rates for transitions in Ar XIII, Ar XIV and Ar XV

Energies for 524 levels of Ar XIII, 460 levels of Ar XIV and 156 levels of Ar XV have been calculated using the GRASP code of Dyall et al. (1989). Additionally, radiative rates, oscillator strengths, and line strengths are calculated for all electric dipole (E1), magnetic dipole (M1), electric quadrupole (E2), and magnetic quadrupole (M2) transitions among these levels. Comparisons are made with the limited results available in the literature, and the accuracy of the data is assessed. Our energy levels are estimated to be accurate to better than 1%, whereas results for other parameters are probably accurate to better than 20%. Additionally, the level lifetimes derived from our radiative rates are in excellent agreement with measured values.

Emission lines of Na-like ions in spectra obtained with the Solar EUV Research Telescope and Spectrograph (SERTS)

Theoretical emission-line ratios involving transitions in the 236-412 Angstrom wavelength range are presented for the Na-like ions Ar viii, Cr xiv, Mn xv, Fe xvi, Co xvii, Ni xviii and Zn xx. A comparison of these with an extensive data set of the solar active region, quiet-Sun, subflare and off-limb observations, obtained during rocket flights by the Solar EUV Research Telescope and Spectrograph (SERTS), reveals generally very good agreement between theory and experiment. This indicates that most of the Na-like ion lines are reliably detected in the SERTS observations, and hence may be employed with confidence in solar spectral analyses. However, the features in the SERTS spectra at 236.34 and 300.25 Angstrom, originally identified as the Ni xviii 3p (2) P-3/2 -3d (2) D- 3/2 and Cr xiv 3p (2) P-3/2 -3d (2) D-5/2 transitions, respectively, are found to be due to emission lines of Ar xiii (236.34 Angstrom) and possibly S v or Ni vi (300.25 Angstrom). The Co xvii 3s (2) S-3p (2) P-3/2 line at 312.55 Angstrom is always badly blended with an Fe xv feature at the same wavelength, but Mn xv 3s (2) S-3p (2) P-1/2 at 384.75 Angstrom may not always be as affected by second-order emission from Fe xii 192.37 Angstrom as previously thought. On the other hand, we find that the Zn xx 3s (2) S-3p (2) P-3/2 transition can sometimes make a significant contribution to the Zn xx/Fe xiii 256.43- Angstrom blend, and hence care must be taken when using this feature as an Fe xiii electron density diagnostic. A line in the SERTS-89 active region spectrum at 265.00 Angstrom has been re-assessed, and we confirm its identification as the Fe xvi 3p (2) P-3/2 -3d (2) D-3/2 transition.

An analytic geometry-variant approach to line ratio enhancement above the optically thin limit

We describe a simple theoretical model to investigate the anomalous effects of opacity on spectral line ratios, as previously studied in elements such as Fe XV and Fe XVII. The model developed is general: it is not specific to a particular atomic system, thus giving applicability to a number of coronal and chromospheric plasmas; furthermore, it may be applied to a variety of astrophysically relevant geometries. The analysis is underpinned by geometrical arguments, and we outline a technique for it to be used as a tool for the explicit diagnosis of plasma geometry in distant astrophysical objects.

Inner-shell photoexcitation of Fe XV and Fe XVI

The configuration-interaction method as implemented in the computer code CIV3 is used to determine energy levels, electric dipole radiative transition wavelengths, oscillator strengths and transition probabilities for inner-shell excitation of transitions in Fe XV and Fe XVI. Specifically, transitions are considered of the type 1s(2) 2s(2) 2p(6) 3s(2) -1s(2) 2s(2) 2p(5) 3l3l' 3l" (l, l' and l" = s,p or d) in FeXV and 1s(2) 2s(2) 2p(6) 3s- 1s(2) 2s(2) 2p(5) 3l3l' (l and l' = s,p or d) in FeXVI, using the relativistic Breit-Pauli approach. An assessment of the accuracy of the derived atomic data is performed.

An investigation of Fe XV emission lines in solar flare spectra

Previously, large discrepancies have been found between theory and observation for Fe XV emission line ratios in solar flare spectra covering the 224-327 angstrom wavelength range, obtained by the Naval Research Laboratory's S082A instrument on board Skylab. These discrepancies have been attributed to either errors in the adopted atomic data or the presence of additional atomic processes not included in the modelling, such as fluorescence. However our analysis of these plus other S082A flare observations (the latter containing Fe XV transitions between 321-482 angstrom), performed using the most recent Fe XV atomic physics calculations in conjunction with a chianti synthetic flare spectrum, indicate that blending of the lines is primarily responsible for the discrepancies. As a result, most Fe XV lines cannot be employed as electron density diagnostics for solar flares, at least at the spectral resolution of S082A and similar instruments (i.e.similar to 0.1 angstrom). An exception is the intensity ratio I(3s3p P-3(2)-3p(2) P-3(1))/I(3s3p P-3(2)-3p(2) D-1(2))=I(321.8 angstrom)/I(327.0 angstrom), which appears to provide good estimates of the electron density at this spectral resolution.