Determining the electronic structure and chemical potentials of molecules in solution

A simulation scheme is proposed for determining the excess chemical potential of a substance in solution. First, a Monte Carlo simulation is performed with classical models for solute and solvent molecules. A representative sample of these configurations is then used in a hybrid quantum/classical (QM/MM) calculation, where the solute is treated quantum-mechanically, and the average electronic structure is used to construct an improved classical model. This procedure is iterated to self-consistency in the classical model, which in practice is attained in one or two steps, depending on the quality of the initial guess. The excess free energy of the molecule within the QM/MM approach is determined relative to the classical model using thermodynamic perturbation theory with a cumulant expansion. The procedure provides a method of constructing classical point charge models appropriate for the solution and gives a measure of the importance of solvent fluctuations.

Mutual Solubilities of Water and Hydrophobic Ionic Liquids

The ionic nature of ionic liquids (ILs) results in a unique combination of intrinsic properties that produces increasing interest in the research of these fluids as environmentally friendly "neoteric" solvents. One of the main research fields is their exploitation as solvents for liquid-liquid extractions, but although ILs cannot vaporize leading to air pollution, they present non-negligible miscibility with water that may be the cause of some environmental aquatic risks. It is thus important to know the mutual solubilities between ILs and water before their industrial applications. In this work, the mutual solubilities of hydrophobic yet hygroscopic imidazolium-, pyridinium-, pyrrolidinium-, and piperidinium-based ILs in combination with the anions bis(trifluoromethylsulfonyl)imide, hexafluorophosphate, and tricyanomethane with water were measured between 288.15 and 318.15 K. The effect of the ILs structural combinations, as well as the influence of several factors, namely cation side alkyl chain length, the number of cation substitutions, the cation family, and the anion identity in these mutual solubilities are analyzed and discussed. The hydrophobicity of the anions increases in the order [C(CN)3] <[PF6] <[Tf2N] while the hydrophobicity of the cations increases from [Cnmim] <[Cnmpy] [Cnmpyr] <[Cnmpip] and with the alkyl chain length increase. From experimental measurements of the temperature dependence of ionic liquid solubilities in water, the thermodynamic molar functions of solution, such as Gibbs energy, enthalpy, and entropy at infinite dilution were determined, showing that the solubility of these ILs in water is entropically driven and that the anion solvation at the IL-rich phase controls their solubilities in water. The COSMO-RS, a predictive method based on unimolecular quantum chemistry calculations, was also evaluated for the description of the water-IL binary systems studied, where it showed to be capable of providing an acceptable qualitative agreement with the experimental data.

Mutual Solubilities of Water and the [Cnmim][Tf2N] Hydrophobic Ionic Liquids

Ionic liquids (ILs) have recently garnered increased attention because of their potential environmental benefits as "green" replacements over conventional volatile organic solvents. While ILs cannot significantly volatilize and contribute to air pollution, even the most hydrophobic ones present some miscibility with water posing environmental risks to the aquatic ecosystems. Thus, the knowledge of ILs toxicity and their water solubility must be assessed before an accurate judgment of their environmental benefits and prior to their industrial applications. In this work, the mutual solubilities for [C2-C8mim][Tf2N] (n-alkyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide) and water between 288.15 and 318.15 K at atmospheric pressure were measured. Although these are among the most hydrophobic ionic liquids known, the solubility of water in these compounds is surprisingly large, ranging from 0.17 to 0.36 in mole fraction, while the solubility of these ILs in water is much lower ranging from 3.2 × 10-5 to 1.1 × 10-3 in mole fraction, in the temperature and pressure conditions studied. From the experimental data, the molar thermodynamic functions of solution and solvation such as Gibbs energy, enthalpy, and entropy at infinite dilution were estimated, showing that the solubility of these ILs in water is entropically driven. The predictive capability of COSMO-RS, a model based on unimolecular quantum chemistry calculations, was evaluated for the description of the binary systems investigated providing an acceptable agreement between the model predictions and the experimental data both with the temperature dependence and with the ILs structural variations.

Movement-related potentials in high-functioning autism and Asperger's disorder

Autism and Asperger's disorder (AD) are neurodevelopmental conditions that affect cognitive and social-communicative function. Using a movement-related potential (MRP) paradigm, we investigated the clinical and neurobiological issue of 'disorder separateness' versus 'disorder variance' in autism and AD. This paradigm has been used to assess basal ganglia/supplementary motor functioning in Parkinson's disease. Three groups (high functioning autism [HFA]: 16 males, 1 female; mean age 12y 5mo [SD 4y 4mo]; AD: 11 males, 2 females; mean age 13y 5mo [SD 3y 8mo]; comparison group: 13 males, 8 females; mean age 13y 10mo, [SD 3y 11 mo]) completed a cued motor task during electroencephalogram recording of MRPs. The HFA group showed reduced peak amplitude at Cz, indicating less activity over the supplementary motor area during movement preparation. Although an overall significant between-group effect was found for early slope and peak amplitude, subanalysis revealed that the group with AD did not differ significantly from either group. However, it is suggested that autism and AD may be dissociated on the basis of brain-behaviour correlations of IQ with specific neurobiological measures. The overlap between MRP traces for autism and Parkinson's disease suggests that the neurobiological wiring of motor functioning in autism may bypass the supplementary motor area/primary motor cortex pathway.

Effect of an attentional strategy on movement-related potentials recorded from subjects with Huntington's disease

Huntington's disease patients perform automatic movements in a bradykinetic manner, somewhat similar to patients with Parkinson's disease. Cortical activity relating to the preparation of movement in Parkinson's disease is significantly improved when a cognitive strategy is used. It is unknown whether patients with Huntington's disease can utilise an attentional strategy, and what effect this strategy would have on the premovement cortical activity. Movement-related potentials were recorded from 12 Huntington's disease patients and controls performing externally cued finger tapping movement, allowing an examination of cortical activity related to movement performance and bradykinesia in this disease. All subjects were tested in two conditions, which differed only by the presence or absence of the cognitive strategy. The Huntington's disease group, unlike controls, did not produce a rising premovement potential in the absence of the strategy. The Huntington's disease group did produce a rising premovement potential for the strategy condition, but the early slope of the potential was significantly reduced compared with the control group's early slope. These results are similar to those found previously with Parkinson's disease patients. The strategy may have put the task, which previously might have been under deficient automatic control, under attentional control. (C) 2002 Movement Disorder Society.

Movement-related potentials in Huntington's disease: movement preparation and execution

Movement-related potentials (MRPs) reflect increasing cortical activity related to the preparation and execution of voluntary movement. Execution and preparatory components may be separated by comparing MRPs recorded from actual and imagined movement. Imagined movement initiates preparatory processes, but not motor execution activity. MRPs are maximal over the supplementary motor area (SMA), an area of the cortex involved in the planning and preparation of movement. The SMA receives input from the basal ganglia, which are affected in Huntington's disease (HD), a hyperkinetic movement disorder. In order to further elucidate the effects of the disorder upon the cortical activity relating to movement, MRPs were recorded from ten HD patients, and ten age-matched controls, whilst they performed and imagined performing a sequential button-pressing task. HD patients produced MRPs of significantly reduced size both for performed and imagined movement. The component relating to movement execution was obtained by subtracting the MRP for imagined movement from the MRP for performed movement, and was found to be normal in HD. The movement preparation component was found by subtracting the MRP found for a control condition of watching the visual cues from the MRP for imagined movement. This preparation component in HD was reduced in early slope, peak amplitude, and post-peak slope. This study therefore reported abnormal MRPs in HD. particularly in terms of the components relating to movement preparation, and this finding may further explain the movement deficits reported in the disease.

Liquid marble formation using hydrophobic powders

This work aims to investigate and quantitatively measure “liquid marble” phenomena using hydrophobic powders (granules). The hydrophobic powders based on a copper substrate were prepared by a silver deposition technique of particle sizes 9 µm, 20 µm and 320 µm and of contact angle with water approaching 160°. The hydrophobic powder poly-methylmethacralate (PMMA) particle size 42 µm and contact angle of 120° was also used to determine the effect of powder density on liquid marble stability. The experimental investigations indicated that for successful formation of liquid marbles a number of variables in addition to hydrophobicity need to be considered, namely: powder density; powder particle size; powder shape; liquid marble formation technique. It was found that liquid marbles were formed using all four powders to varying extents, with a low powder particle size forming more stable liquid marbles. In a series of gravimetric tests, adhered powder mass on liquid marbles was found to be directly proportional to the water droplet surface area. A more complete coverage of the water drops were found with PMMA powder than the hydrophobic granules. Moreover, a further procedure was developed to increase the mechanical strength of the liquid marble, by polymerising methylmethacrylate (MMA) on the surface of a PMMA powder – liquid marble, with the aim of maintaining water within a more robust PMMA – liquid marble shell. This technique may prove to be a novel way of encapsulating drug compounds, such as gentamicin sulphate, for PMMA bone cement.

Solvation of 1-butyl-3-methylimidazolium hexafluorophosphate in aqueous ethanol - a green solution for dissolving 'hydrophobic' ionic liquids

The relatively hydrophobic ionic liquid 1-butyl-3-methylimidazolium hexafluorophosphate has been found to be totally miscible with aqueous ethanol between 0.5 and 0.9 mol fraction ethanol, whereas the ionic liquid is only partially miscible with either pure water or absolute ethanol; the ability to dissolve 1-butyl-3-methylimidazolium hexafluorophosphate in a 'green' aqueous solvent system has important implications for cleaning, purification, and separations using ionic liquids.

Hydrophobic ionic liquids incorporating N-alkylisoquinolinium cations and their utilization in liquid-liquid separations

The first examples of Room Temperature Ionic Liquids (RTIL) containing fused polycyclic N-alkylisoquinolinium cations ([C(n)isoq](+)) in combination with the bis(perfluoroethylsulfonyl) imide anion ([BETI](-)) have been synthesized, characterized, and utilized in liquid-liquid partitioning from water; these salts have unexpectedly low melting points and give high distribution ratios for aromatic solutes, especially chlorobenzenes, between the RTIL and water.