Extracting statistically dominant modes of a steel truss bridge from vehicle-induced vibrations

This study is intended to investigate the validity of the stability diagram (SD) aided multivariate autoregressive (MAR) analysis for identifying modal parameters of a real truss bridge. The MAR models are adopted to fit the time series of the dynamic accelerations recorded from a number of observation points on the bridge; then the modal parameters are extracted from the MAR model coefficient matrix. The SD is adopted to determine statistically dominant modes. In plotting the SD, a number of stability criteria are further adopted for filtering out those modes with unstable modal parameters. By the present method, the first five modal frequencies and mode shapes are identified with very high precision, while the damping ratios are identified with high precision for the 1st mode but with poorer precision for higher modes. Moreover, the ability of the SD in selecting structural modes without getting involved in any model-order optimization problem is highlighted through a comparison study.

Changes in modal parameters of a steel truss bridge due to artificial damage

This study investigated how damage changes the modal parameters of a real bridge by means of a field experiment which was conducted on a real steel truss bridge consecutively subjected to four artificial damage scenarios. In the experiment, both the forced and free vibrations of the bridge were recorded, the former for identifying higher modes available exclusively and the latter for lower modes with higher resolution. Results show that modal parameters are little affected by damage causing low stress redistribution. Modal frequencies decrease as damage causing high stress redistribution is applied; such a change can be observed if the damage is at the non-nodal point of the corresponding mode shape. Mode shapes are distorted due to asymmetric damage; they show an amplification in the damaged side as damage is applied at the non-nodal point. Torsion modes become more dominant as damage is applied either asymmetrically or on an element against large design loads. © 2013 Taylor & Francis Group, London.

Ion-acoustic waves in a plasma consisting of adiabatic warm ions, non-isothermal electrons and a weakly relativistic electron beam: linear and higher-order nonlinear effects

The nonlinear propagation of finite amplitude ion acoustic solitary waves in a plasma consisting of adiabatic warm ions, nonisothermal electrons, and a weakly relativistic electron beam is studied via a two-fluid model. A multiple scales technique is employed to investigate the nonlinear regime. The existence of the electron beam gives rise to four linear ion acoustic modes, which propagate at different phase speeds. The numerical analysis shows that the propagation speed of two of these modes may become complex-valued (i.e., waves cannot occur) under conditions which depend on values of the beam-to-background-electron density ratio , the ion-to-free-electron temperature ratio , and the electron beam velocity v0; the remaining two modes remain real in all cases. The basic set of fluid equations are reduced to a Schamel-type equation and a linear inhomogeneous equation for the first and second-order potential perturbations, respectively. Stationary solutions of the coupled equations are derived using a renormalization method. Higher-order nonlinearity is thus shown to modify the solitary wave amplitude and may also deform its shape, even possibly transforming a simple pulse into a W-type curve for one of the modes. The dependence of the excitation amplitude and of the higher-order nonlinearity potential correction on the parameters , , and v0 is numerically investigated.

Oblique modulation of electrostatic modes and envelope excitations in pair-ion and electron-positron plasmas

The nonlinear amplitude modulation of electrostatic waves propagating in a collisionless two-component plasma consisting of negative and positive species of equal mass and absolute charge is investigated. Pair-ion (e.g., fullerene) and electron-positron (e-p) plasmas (neglecting recombination) are covered by this description. Amplitude perturbation oblique to the direction of propagation of the wave has been considered. Two distinct linear electrostatic modes exist, namely an acoustic lower mode and Langmuir-type optic-type upper one. The behavior of each of these modes is examined from the modulational stability point of view. The stability criteria are investigated, depending on the electrostatic carrier wave number, the angle theta between the modulation and propagation directions, and the positron-to-electron temperature ratio sigma. The analysis shows that modulated electrostatic wavepackets associated to the lower (acoustic) mode are unstable, for small values of carrier wave number k (i.e., for large wavelength lambda) and for finite (small) values of the angle theta (yet stable for higher theta), while those related to the upper (optic-like) mode are stable for large values of the angle theta only, in the same limit, yet nearly for all values of sigma. These results are of relevance in astrophysical contexts (e.g., in pulsar environments), where e-p plasmas are encountered, or in pair fullerene-ion plasmas, in laboratory. (c) 2006 American Institute of Physics.