The demand for labor: An analysis using matched employer-employee data from the German LIAB. Will the high unskilled worker own-wage elasticity please stand up?

This paper uses matched employee-employer LIAB data to provide panel estimates of the structure of labor demand in western Germany, 1993-2002, distinguishing between highly skilled, skilled, and unskilled labor and between the manufacturing and service sectors. Reflecting current preoccupations, our demand analysis seeks also to accommodate the impact of technology and trade in addition to wages. The bottom-line interests are to provide elasticities of the demand for unskilled (and other) labor that should assist in short-run policy design and to identify the extent of skill biases or otherwise in trade and technology.

EMAS and ISO 14001 in the German industry – complements or substitutes?

The two environmental management system (EMS) standards EMAS and ISO 14001 have been available in Europe for the last 15 years. ISO 14001 has been taken up at a much larger scale but many firms in the German automotive and engineering industry have certified their EMSs according to both standards. Two research questions are addressed: (i) What explains why companies adopt both EMAS and ISO 14001? (ii) Are EMAS and ISO 14001 complements or substitutes? Based on 21 interviews with industrial and institutional representatives, this study finds that, first, the two standards are adopted for completely different reasons: while ISO 14001 is often done as a response to external pressure, EMAS tends to be motivated internally. Second, it is argued that EMAS and ISO 14001 are likely in a situation of direct competition at present which may well turn into complementarity in the future.

Influence of Manufacturing Tolerance on Aircraft Direct Operating Cost (DOC)

The influence of manufacturing tolerance on direct operating cost (DOC) is extrapolated from an engine nacelle to be representative of an entire aircraft body. Initial manufacturing tolerance data was obtained from the shop floor at Bombardier Aerospace Shorts, Belfast while the corresponding costs were calculated according to various recurring elements such as basic labour and overtime labour, rework, concessions, and redeployment; along with the non-recurrent costs due to tooling and machinery, etc. The relation of tolerance to cost was modelled statistically so that the cost impact of tolerance change could be ascertained. It was shown that a relatively small relaxation in the assembly and fabrication tolerances of the wetted surfaces resulted in reduced costs of production that lowered aircraft DOC, as the incurred drag penalty was predicted and taken into account during the optimisation process.

Parametric optimisation of manufacturing tolerances at the aircraft surface

Up until now, aircraft surface smoothness requirements have been aerodynamically driven with tighter manufacturing tolerance to minimize drag, that is, the tighter the tolerance, the higher is the assembly cost in the process of manufacture. In the current status of commercial transport aircraft operation, it can be seen that the unit cost contributes to the aircraft direct operating cost considerably more than the contribution made by the cost of block fuel consumed for the mission profile. The need for a customer-driven design strategy to reduce direct operating cost by reducing aircraft cost through manufacturing tolerance relaxation at the wetted surface without unduly penalizing parasite drag is investigated. To investigate this, a preliminary study has been conducted at 11 key manufacturing features on the surface assembly of an isolated nacelle. In spite of differences in parts design and manufacture, the investigated areas associated with the assembly of nacelles are typical of generic patterns in the assembly of other components of aircraft. The study is to be followed up by similar studies extended to lifting surfaces and fuselage