Alkali-Activated Natural Pozzolan Concrete as New Construction Material

In the near future, geopolymers or alkali-activated cementitious materials will be used as new high-performance construction materials of low environmental impact with a reasonable cost. This material is a good candidate to partially replace ordinary portland cement (OPC) in concrete as a major construction material that plays an outstanding role in the construction industry of different structures. Geopolymer materials are inorganic polymers based on alumina and silica units; they are synthesized from a wide range of dehydroxylated alumina-silicate powders condensed with alkaline silicate in a highly alkaline environment. Geopolymeric materials can be produced from a wide range of alumina-silica, including natural products--such as natural pozzolan and metakaolin--or coproducts--such as fly ash (coal and lignite), oil fuel ash, blast furnace or steel slag, and silica fume--and provide a route toward sustainable development. Using lesser amounts of calcium-based raw materials, lower manufacturing temperature, and lower amounts of fuel result in reduced carbon emissions for geopolymer cement manufacture up to 22 to 72% in comparison with portland cement. A study has been done by the authors to investigate the intrinsic nature of different types of Iranian natural pozzolans to determine the activators and methods that could be used to produce a geopolymer concrete based on alkali-activated natural pozzolan (AANP) and optimize mixture design. The mechanical behavior and durability of these types of geopolymer concrete were investigated and compared with normal OPC concrete mixtures cast by the authors and also reported in the literature. This paper summarizes the main conclusions of the research regarding pozzolanic activity, activator properties, engineering and durability properties, applications and evaluation of carbon footprint, and cost for AANP concrete.

Vitamin D, calcium and dairy intake, and risk of oesophageal adenocarcinoma and its precursor conditions

Evidence is accumulating that vitamin D may be protective against carcinogenesis, although exceptions have been observed for some digestive tract neoplasms. The aim of the present study was to explore the association between dietary vitamin D and related nutrients and the risk of oesophageal adenocarcinoma and its precursor conditions, Barrett's oesophagus and reflux oesophagitis. In an all-Ireland case-control study conducted between March 2002 and July 2005, 218 oesophageal adenocarcinoma patients, 212 Barrett's oesophagus patients, 208 reflux oesophagitis patients and 252 population-based controls completed a 101-item FFQ, and provided lifestyle and demographic information. Multiple logistic regression analysis was applied to examine the association between dietary intake and disease risk. Oesophageal adenocarcinoma risk was significantly greater for individuals with the highest compared with the lowest tertile of vitamin D intake (OR 1·99, 95 % CI 1·03, 3·86; P for trend = 0·02). The direct association could not be attributed to a particular vitamin D food source. Vitamin D intake was unrelated to Barrett's oesophagus and reflux oesophagitis risk. No significant associations were observed for Ca or dairy intake and oesophageal adenocarcinoma, Barrett's oesophagus or reflux oesophagitis development. High vitamin D intake may increase oesophageal adenocarcinoma risk but is not related to reflux oesophagitis and Barrett's oesophagus. Ca and dairy product intake did not influence the development of these oesophageal lesions. These findings suggest that there may be population subgroups at an increased risk of oesophageal adenocarcinoma if advice to improve vitamin D intake from foods is implemented. Limited work has been conducted in this area, and further research is required.

Development of a bovine collagen-apatitic calcium phosphate cement for potential fracture treatment through vertebroplasty

The aim of this study was to examine the potential of incorporating bovine fibres as a means of reinforcing a typically brittle apatite calcium phosphate cement for vertebroplasty. Type I collagen derived from bovine Achilles tendon was ground cryogenically to produce an average fibre length of 0.96 ± 0.55 mm and manually mixed into the powder phase of an apatite-based cement at 1, 3 or 5 wt.%. Fibre addition of up to 5 wt.% had a significant effect (P = 0.001) on the fracture toughness, which was increased by 172%. Adding =1 wt.% bovine collagen fibres did not compromise the compressive properties significantly, however, a decrease of 39-53% was demonstrated at =3 wt.% fibre loading. Adding bovine collagen to the calcium phosphate cement reduced the initial and final setting times to satisfy the clinical requirements stated for vertebroplasty. The cement viscosity increased in a linear manner (R = 0.975) with increased loading of collagen fibres, such that the injectability was found to be reduced by 83% at 5 wt.% collagen loading. This study suggests for the first time the potential application of a collagen-reinforced calcium phosphate cement as a viable option in the treatment of vertebral fractures, however, issues surrounding efficacious cement delivery need to be addressed. © 2012 Acta Materialia Inc.

Printability of calcium phosphate: Calcium sulphate powders for the application of tissue engineered bone scaffolds using the 3D printing technique

In this study, calcium phosphate (CaP) powders were blended with a three-dimensional printing (3DP) calcium sulfate (CaSO4)-based powder and the resulting composite powders were printed with a water-based binder using the 3DP technology. Application of a water-based binder ensured the manufacture of CaP:CaSO4 constructs on a reliable and repeatable basis, without long term damage of the printhead. Printability of CaP:CaSO4 powders was quantitatively assessed by investigating the key 3DP process parameters, i.e. in-process powder bed packing, drop penetration behavior and the quality of printed solid constructs. Effects of particle size, CaP:CaSO4 ratio and CaP powder type on the 3DP process were considered. The drop penetration technique was used to reliably identify powder formulations that could be potentially used for the application of tissue engineered bone scaffolds using the 3DP technique. Significant improvements (p < 0.05) in the 3DP process parameters were found for CaP (30-110 μm):CaSO4 powders compared to CaP (< 20 μm):CaSO4 powders. Higher compressive strength was obtained for the powders with the higher CaP:CaSO4 ratio. Hydroxyapatite (HA):CaSO4 powders showed better results than beta-tricalcium phosphate (β-TCP):CaSO4 powders. Solid and porous constructs were manufactured using the 3DP technique from the optimized CaP:CaSO4 powder formulations. High-quality printed constructs were manufactured, which exhibited appropriate green compressive strength and a high level of printing accuracy.

Interlaboratory studies on in vitro test methods for estimating in vivo resorption of calcium phosphate ceramics

A potential standard method for measuring the relative dissolution rate to estimate the resorbability of calcium-phosphate-based ceramics is proposed. Tricalcium phosphate (TCP), magnesium-substituted TCP (MgTCP) and zinc-substituted TCP (ZnTCP) were dissolved in a buffer solution free of calcium and phosphate ions at pH 4.0, 5.5 or 7.3 at nine research centers. Relative values of the initial dissolution rate (relative dissolution rates) were in good agreement among the centers. The relative dissolution rate coincided with the relative volume of resorption pits of ZnTCP in vitro. The relative dissolution rate coincided with the relative resorbed volume in vivo in the case of comparison between microporous MgTCPs with different Mg contents and similar porosity. However, the relative dissolution rate was in poor agreement with the relative resorbed volume in vivo in the case of comparison between microporous TCP and MgTCP due to the superimposition of the Mg-mediated decrease in TCP solubility on the Mg-mediated increase in the amount of resorption. An unambiguous conclusion could not be made as to whether the relative dissolution rate is predictive of the relative resorbed volume in vivo in the case of comparison between TCPs with different porosity. The relative dissolution rate may be useful for predicting the relative amount of resorption for calcium-phosphate-based ceramics having different solubility under the condition that the differences in the materials compared have little impact on the resorption process such as the number and activity of resorbing cells.

'Off-On' Fluorescent Sensors for Physiological levels of Magnesium Ions based on Photoinduced Electron Transfer (PET) which also behave as OR Logic Gates

The fluorescence of molecules 1-3 is enhanced by factors of up to 67 in the presence of magnesium and calcium ions in neutral water which allows the selective monitoring of magnesium ions under simulated physiological conditions and permits the construction of truth tables with OR logic when these molecules are viewed as ion input-photon output molecuIar devices.

Factors influencing the compressive strengths of fly ash based geopolymers

Several factors affecting the reactivity of pulverised fuel ash (pfa) as a precursor for geopolymer concrete have been investigated. These include physical and chemical properties of various pfa sources, inclusion of ground granulated blast furnace slag (ggbs), chemical activator dosages and curing temperature. Alkali-activated pfa was found to require elevated curing temperatures and high alkali concentrations. A mixture of sodium hydroxide and sodium silicate was used and this was shown to result in high strengths, as high as 70 MPa at 28-days. The presence of silicates in solution was found to be a key factor. Detailed physical and chemical characterisation was carried out on thirteen pfa sources from the UK. The most important factor affecting the reactivity was found to be the particle size of pfa. The loss on ignition (LOI) and the amorphous content are also important parameters that need to be considered for the selection of pfa for use in geopolymer concrete. The partial replacement of pfa by ground granulated blast furnace slag (ggbs) was found to be beneficial in not only avoiding the need for elevated curing temperatures but also in improving compressive strengths. Microstructural characterisation with scanning electron microscope (SEM) coupled with energy dispersive X-ray spectroscopy (EDS) was performed on pfa/ggbs pastes. The reaction product of pfa and ggbs in these binary systems was calcium aluminium silicate hydrate gel (C-A-S-H) with inclusion of Na in the structure.

A randomised controlled trial of calcium channel blockade (CCB) with Amlodipine For the treatment oF subcortical ischaEmic vasCular demenTia (AFFECT): study protocol

BACKGROUND: Vascular dementia is the second most common cause of dementia affecting over seven million people worldwide, yet there are no licensed treatments. There is an urgent need for a clinical trial in this patient group. Subcortical ischaemic vascular dementia is the most common variant of vascular dementia. This randomised trial will investigate whether use of calcium channel blockade with amlodipine, a commonly used agent, can provide the first evidence-based pharmacological treatment for subcortical ischaemic vascular dementia.

METHODS/DESIGN: This is a randomised controlled trial of calcium channel blockade with Amlodipine For the treatment oF subcortical ischaEmic vasCular demenTia (AFFECT) to test the hypothesis that treatment with amlodipine can improve outcomes for these patients in a phase IIb, multi-centre, double-blind, placebo-controlled randomised trial. The primary outcome is the change from baseline to 12 months in the Vascular Dementia Assessment Scale cognitive subscale (VADAS-cog). Secondary outcomes include cognitive function, executive function, clinical global impression of change, change in blood pressure, quantitative evaluation of lesion accrual based on magnetic resonance imaging (MRI), health-related quality of life, activities of daily living, non-cognitive dementia symptoms, care-giver burden and care-giver health-related quality of life, cost-effectiveness and institutionalisation. A total of 588 patients will be randomised in a 1:1 ratio to either amlodipine or placebo, recruited from sites across the UK and enrolled in the trial for 104 weeks.

DISCUSSION: There are no treatments licensed for vascular dementia. The most common subtype is subcortical ischaemic vascular dementia (SIVD). This study is designed to investigate whether amlodipine can produce benefits compared to placebo in established SIVD. It is estimated that the numbers of people with VaD and SIVD will increase globally in the future and the results of this study should inform important treatment decisions.

Calcium Channel Blocker Use and Risk of Prostate Cancer by TMPRSS2:ERG Gene Fusion Status

BACKGROUND: Calcium channel blockers (CCBs) may affect prostate cancer (PCa) growth by various mechanisms including those related to androgens. The fusion of the androgen-regulated gene TMPRSS2 and the oncogene ERG (TMPRSS2:ERG or T2E) is common in PCa, and prostate tumors that harbor the gene fusion are believed to represent a distinct disease subtype. We studied the association of CCB use with the risk of PCa, and molecular subtypes of PCa defined by T2E status.

METHODS: Participants were residents of King County, Washington, recruited for population-based case-control studies (1993-1996 or 2002-2005). Tumor T2E status was determined by fluorescence in situ hybridization using tumor tissue specimens from radical prostatectomy. Detailed information on use of CCBs and other variables was obtained through in-person interviews. Binomial and polytomous logistic regression were used to generate odds ratios (ORs) and 95% confidence intervals (CIs).

RESULTS: The study included 1,747 PCa patients and 1,635 age-matched controls. A subset of 563 patients treated with radical prostatectomy had T2E status determined, of which 295 were T2E positive (52%). Use of CCBs (ever vs. never) was not associated with overall PCa risk. However, among European-American men, users had a reduced risk of higher-grade PCa (Gleason scores ≥7: adjusted OR = 0.64; 95% CI: 0.44-0.95). Further, use of CCBs was associated with a reduced risk of T2E positive PCa (adjusted OR = 0.38; 95% CI: 0.19-0.78), but was not associated with T2E negative PCa.

CONCLUSIONS: This study found suggestive evidence that use of CCBs is associated with reduced relative risks for higher Gleason score and T2E positive PCa. Future studies of PCa etiology should consider etiologic heterogeneity as PCa subtypes may develop through different causal pathways.