Development of a doped titania immobilised thin film multi tubular photoreactor

This paper describes a novel doped titania immobilised thin film multi tubular photoreactor which has been developed for use with liquid, vapour or gas phase media. In designing photocatalytic reactors measuring active surface area of photocatalyst within the unit is one of the critical design parameters. This dictate greatly limits the applicability of any semi-conductor photocatalyst in industrial applications, as a large surface area equates to a powder catalyst. This demonstration of a thin film coating, doped with a rare earth element, novel photoreactor design produces a photocatalytic degradation of a model pollutant (methyl orange) which displayed a comparable degradation achieved with P25 TiO2. The use of lanthanide doping is reported here in the titania sol gel as it is thought to increase the electron hole separation therefore widening the potential useful wavelengths within the electromagnetic spectrum. Increasing doping from 0.5% to 1.0% increased photocatalytic degradation by ∼17% under visible irradiation. A linear relationship has been seen between increasing reactor volume and degradation which would not normally be observed in a typical suspended reactor system. © 2012 Elsevier B.V.

A study of the kinetic solvent isotope effect on the destruction of microcystin-LR and geosmin using TiO2 photocatalysis

We have previously reported the effectiveness of TiO₂ photocatalysis in the destruction of species generated by cyanobacteria, specifically geosmin and microcystin-LR. In this paper we report an investigation of factors which influence the rate of the toxin destruction at the catalyst surface. A primary kinetic solvent isotope effect of approximately 1.5 was observed when the destruction was performed in a heavy water solvent. This is in contrast to previous reports of a solvent isotope effect of approximately 3, however, these studies were undertaken with a different photocatalyst material. The solvent isotope effect therefore appears to be dependent on the photocatalyst material used. The results of the study support the theory that the photocatalytic decomposition occurs on the catalyst surface rather than in the bulk of the solution. Furthermore it appears that the rate determining step is not oxygen reduction as previously reported. 

The photocatalytic destruction of the cyanotoxin, nodularin using TiO 2

Titanium dioxide (TiO₂) photocatalysis has been used to initiate the destruction of nodularin, a natural hepatotoxin produced by cyanobacteria. The destruction process was monitored using liquid chromatography-mass spectrometry analysis which has also enabled the identification of a number of the photocatalytic decomposition products. The reduction in toxicity following photocatalytic treatment was evaluated using protein phosphatase inhibition assay, which demonstrated that the destruction of nodularin was paralleled by an elimination of toxicity. 

The destruction of 2-methylisoborneol and geosmin using titanium dioxide photocatalysis

Geosmin (GSM) and 2-methylisoborneol (MIB) are semi-volatile compounds produced by cyanobacteria in surface waters. These compounds present problems to the drinking water industry and in aquaculture because they can taint water and fish producing an earthy-musty flavour. This paper presents an initial study on the use of TiO₂ photocatalysis for the destruction of these compounds in water. The process proved effective with the complete destruction of MIB and GSM being achieved within 60 min. These results suggest that TiO₂ photocatalysis will be a successful method for removal of taint compounds from potable water supplies and fish farms. 

Processes influencing surface interaction and photocatalytic destruction of microcystins on titanium dioxide photocatalysts

Microcystins are a family of hepatotoxic peptides produced by freshwater cyanobacteria. Their occurrence in drinking water is of concern since chronic exposure to these toxins causes tumor promotion. It is therefore essential to establish a reliable treatment strategy that will ensure their removal from potable water. We have previously described the rapid destruction of microcystin-LR using TiO₂ photocatalysis, however, since there are at least 70 microcystin variants it is essential that the destruction of a number of microcystins be evaluated. In this study the dark adsorption and destruction of four microcystins was followed over a range of pH. All four microcystins were destroyed although the efficiency of their removal varied. The two more hydrophobic microcystins (-LW and -LF) were found to have high dark adsorption (98 and 91% at pH 4) in contrast to microcystin-RR, which was found to have almost no (only 2-3%) dark adsorption across all pH. 

Hydrogen peroxide enhanced photocatalytic oxidation of microcystin-lR using titanium dioxide

Cyanobacterial toxins present in drinking water sources pose a considerable threat to human health. Conventional water treatment systems have proven unreliable for the removal of these toxins and hence new techniques have been investigated. Previous work has shown that TiO₂ photocatalysis effectively destroys microcystin-LR in aqueous solutions, however non-toxic by-products were detected. It has been shown that photocatalytic reactions are enhanced by utilisation of alternative electron acceptors. We report here enhanced photocatalytic degradation of microcystin-LR following the addition of hydrogen peroxide to the system. It was also found that hydrogen peroxide with UV illumination alone was capable of decomposing microcystin-LR although at a much slower rate than found for TiO₂. No HPLC detectable by-products were found when the TiO₂/UV/H₂O₂ system was used indicating that this method is more effective than TiO₂/UV alone. Results however indicated that only 18% mineralisation occurred with the TiO₂/UV/H₂O₂ system and hence undetectable by-products must still be present. At higher concentrations hydrogen peroxide was found to compete with microcystin-LR for surface sites on the catalyst but at lower peroxide concentrations this competitive adsorption was not observed. Toxicity studies showed that both in the presence and absence of H₂O₂ the microcystin solutions were detoxified. These findings suggest that hydrogen peroxide greatly enhances the photocatalytic oxidation of microcystin-LR.

N-terminal glycation of cholecystokinin-8 abolishes its insulinotropic action on clonal pancreatic B-cells

Monoglycated cholecystokinin octapeptide (Asp(1)-glucitol CCK-X) was prepared under hyperglycaemic reducing conditions and purified by reverse phase-high performance liquid chromatography. Electrospray ionisation mass spectrometry and automated Edman degradation demonstrated that CCK-8 was glycated specifically at the amino-terminal Asp(1) residue. Effects of Asp(1)-glucitol CCK-8 and CCK-8 on insulin secretion were examined using glucose-responsive clonal BRIN-BD11 cells. In acute (20 min) incubations, 10(-10) mol/l CCK-8 enhanced insulin release by 1.2-1.5-fold at 5.6-11.1 mmol/l glucose. The stimulatory effect induced by 10(-10) mom CCK-8 was abolished following glycation. At 5.6 mmol/l glucose, CCK-8 at concentrations ranging from 10(-11) to 10(-7) mol/l induced a significant 1.6-1.9-fold increase in insulin secretion. Insulin output in the presence of Asp(1)-glucitol CCK-8 over the concentration range 10(-11)-10(-7) mol/l was decreased by 21-35% compared with CCK-8, and its insulinotropic action was effectively abolished. Asp(1)-glucitol CCK-8 at 10(-8) mol/l also completely blocked the stimulatory effects of 10(-11)-10(-8) mol/l CCK-8. These data indicate that structural modification by glycation at the amino-terminal Asp(1) residue effectively abolishes and/or antagonises the insulinotropic activity of CCK-8. (C) 1999 Elsevier Science B.V. All rights reserved.

Major and trace elements in milk and Halloumi cheese as markers for authentication of goat feeding regimes and geographical origin

Sixty samples of milk, Halloumi cheese and local grazing plants (i.e. shrubs) were collected over a year from dairy farms located on three different locations of Cyprus. Major and trace elements were quantified using inductively coupled plasma-atomic emission spectroscopy (ICP-AES). Milk and Halloumi cheese produced in different geographical locations presented significant differences in the concentration of some of the elements analysed. Principal component analysis showed grouping of samples according to the region of production for both milk and cheese samples. These findings show that the assay of elements can provide useful fingerprints for the characterisation of dairy products.

Mild temperature palladium-catalyzed ammoxidation of ethanol to acetonitrile

The ammoxidation of ethanol is investigated as a renewable process for the production of acetonitrile from a bio-feedstock. Palladium catalysts are shown to be active and very selective (>99%) to this reaction at moderate to low temperatures (150-240 °C), with acetonitrile yields considered a function of Pd morphology. Further investigations reveal that the stability of these catalysts is influenced by an unselective product, and that any deactivation observed is reversible. Interpretation of this deactivation allows operating conditions to be defined for the stable, high yielding production of acetonitrile from ethanol.