Micro-scale biopitting by endolithic lichen and their role in meso-scale solution basin development on limestone

Data are reported demonstrating the potential role of microscale morphologies, induced by endolithic lichen communities, specifically Verrucaria baldensis, in the initiation and development of mesoscale solution basin formation on limestone in the Burren, Co. Clare. A biophysical model is proposed outlining the different microscale stages leading to solution basin initiation with a progression from initial lichen colonisation and growth, associated biopitting followed by biopit coalescence to form biotroughs, their subsequent enlargement and eventual incipient solution basin formation. This model provides one explanation for solution basin development as this end state may also be achieved through simple solutional means without biological input. The complexity of interactions at the rock / lichen interface are identified with emphasis on the spatial and temporal variability of these underlining the point that, as with macro-topographies at the landscape scale, rock surface micro-topographies also reflect historical weathering legacies.

Micro-Environmental monitoring of temperature and moisture changes in building stone

The monitoring of temperature and moisture changes in response to different micro-environment of building stones is essential to understand the material behaviour and the degradation mechanisms. From a practical point of view, having a continuous and detailed understanding of micro-environmental changes in building stones helps to assist in their maintenance and repair strategies. Temperature within the stone is usually monitored by means of thermistors, whereas wide ranges of techniques are available for monitoring the moisture. In the case of concrete an electrical resistance method has previously been used as an inexpensive tool for monitoring moisture changes. This paper describes the adaptation of this technique and describes its further development for monitoring moisture movement in building stones.
In this study a block of limestone was subjected to intermittent infrared radiation with programmed cycles of ambient temperature, rainfall and wind conditions in an automated climatic chamber. The temperature and moisture changes at different depths within the stone were monitored by means of bead thermistors and electrical resistance sensors. This experiment has helped to understand the thermal conductivity and moisture transport from surface into deeper parts of the stone at different simulated extreme climatic conditions. Results indicated that variations in external ambient conditions could substantially affect the moisture transport and temperature profile within the micro-environment of building stones and hence they could have a significant impact on stone decay.

Micro-environmental conditions modulate protein secretion and infectivity of the Trichinella spiralis L1 larva

After digestion of infected meat the free L1 of Trichinella spp. penetrate the intestinal mucosa where they moult to the mature adult stage. We have used proteomics to identify changes in protein secretion during in vitro culture of free T. spiralis muscle larvae under different environmental conditions, and to correlate these changes with their infectivity in mice. Muscle larvae were cultured in different media (RPMI-1640, C-199 and HBSS) under conditions of anaerobiosis, microaerobiosis and in 5% CO(2) at 37 degrees C. Following incubation the larval excretory/secretory proteins were analysed by two-dimensional gel electrophoresis and the larvae were used to orally infect naïve CD1 mice. For all culture media tested, infectivity of the L1 was preserved following incubation in anaerobic conditions. In contrast, the infectivity of worms cultured in nutrient-rich media was almost completely abolished in both microaerobiosis and in the presence of 5% CO(2). Some infectivity was retained in poor or reduced culture media. Comparative analysis of larval infectivity and protein secretion showed that loss of infectivity correlated with the appearance of non-tyvelosylated proteins that in turn may be related to the onset of moulting.

Micro-organic compounds in the Humber rivers

The concentrations of a range of micro-organic compounds in the Humber rivers have been measured at weekly intervals over a period of 1 year. The compounds include the triazine herbicides (simazine, atrazine, propazine, desmetryn and prometryn), selected organophosphorus insecticides (fenitrothion, malathion and parathion), phenylurea (chlorotoluron, diuron, isoproturon and linuron) and phenoxyacid herbicides (2,4-D, MCPA, MCPB and mecoprop), phenol derivatives (phenol, 2-ethylphenol, 2-chlorophenol, 4-nitrophenol, 2-methylphenol, 4-ethylphenol and 2,4-dichlorophenol), organochlorine insecticides (HEOD, DDT, TDE, DDE, HCB, alpha-BHC and lindane), PCB's and some synthetic pyrethroid insecticides (cis/trans-permethrin, fenvalerate and cypermethrin). The results indicate the high frequency of occurrence of many compounds in the southern Humber rivers Aire, Calder, Trent and Don compared with the more occasional concentrations found in the upland rivers with catchments dominated by low intensity agriculture. The more water soluble herbicides, atrazine, simazine, isoproturon and diuron are detected frequently in the southern rivers with the highest concentrations and abundance in the rivers Aire, Calder and Trent. The most abundant phenolic compound is 2,4-dichlorophenol usually occurring at concentrations <1 mu g/l. The organochlorine insecticides and PCB's are generally at concentrations <0.01 mu g/l, cis/trans-permethrin are the only synthetic pyrethroids detected and these are found in the rivers Aire and Calder at about equal concentrations of between 0.01 and 0.11 mu g/l. The results of the occurrence of simazine and atrazine in the rivers Trent, Don and Aire illustrate peaks in concentration in the spring and then later in the year during the early autumn coinciding with the first major storm after the summer. In the rivers Trent and Don, the annual exports (March 1994-95) of atrazine are lower than for simazine whereas in the R. Calder the yield of atrazine is higher than for simazine suggesting differences in use in these catchments. The maximum triazine concentration observed, i.e. 8 mu g/l of atrazine in the R. Calder, could have inhibiting effects on the phytoplankton and algal growth, although because of the transient nature of the peaks, recovery is expected to be rapid. The only other compounds measured at concentrations likely to produce detrimental ecotoxicological effects are cis/trans permethrin in the rivers Aire and Calder. (C) 1997 Elsevier Science B.V.

Numbered-up gas-liquid micro/milli channels reactor with modular flow distributor

Gas-liquid processing in microreactors remains mostly restricted to the laboratory scale due to the complexity and expenditure needed for an adequate numbering-up with a uniform flow distribution. Here, the numbering-up is presented for multi-phase (gas-liquid) flow in microreactor suitable for a production capacity of kg/h. Based on the barrier channels concept, the barrier-based micro/milli reactor (BMMR) is designed and fabricated to deliver flow non-uniformity of less than 10%. The BMMR consists of eight parallel channels all operated in the Taylor flow regime and with a liquid flow rate up to 150. mL/min. The quality of the flow distribution is reported by studying two aspects. The first aspect is the influence of different viscosities, surface tensions and flow rates. The second aspect is the influence of modularity by testing three different reaction channels type: (1) square channels fabricated in a stainless steel plate, (2) square channels fabricated in a glass plate, and (3) circular channels (capillaries) made of stainless steel. Additionally, the BMMR is compared to that of a single channel regard the slug and bubble lengths and bubble generation frequency. The results pave the ground for bringing multi-phase flow in microreactor one step closer for large scale production via numbering-up. © 2012 Elsevier B.V.

Family caregivers' ideal expectations of Canada's Compassionate Care Benefit

We present the findings of 57 interviews conducted in 2007-2008 with Canadians who have cared for a dying family member to examine their ideal expectations of the Compassionate Care Benefit (CCB) - a social programme providing job security and income support for workers caring for a dying person. Our aims are to (1) appreciate how intended users and other family caregivers view the programme's very nature; (2) identify programme challenges and improvements that emerge from considering family caregivers' ideal expectations; and (3) contribute to a larger evaluative study designed to make policy-relevant recommendations for CCB improvement. Review of transcripts across three respondent groups reveals four categories of ideal expectations: (1) eligibility, (2) informational, (3) timing and (4) financial. Ideal expectations were typically derived from respondents' experiences of care-giving, their knowledge of the programme and, for some, of applying for and/or receiving the CCB. Findings reveal that there are gaps between respondents' ideal expectations and their experienced realities. Such gaps may lead to disappointment being experienced by those who believe they should be eligible for the programme but are not, or should be entitled to receive some form of support that is not presently available. This analysis plays an important role in identifying potential changes for the CCB that may better support family caregivers, in that the ideal expectations serve as a starting point for articulating desirable programme amendments. This analysis also has wider relevance. For jurisdictions looking to create new social programmes to support caregivers based upon labour policy strategies and legislation, this analysis identifies considerations that should be made at the outset of development. For jurisdictions that already have employment-based caregiver support programmes, this analysis demonstrates that programme challenges may not always be met through legislative changes alone but also through measures such as increasing awareness. © 2011 Blackwell Publishing Ltd.

Gaussian mixture background modelling optimisation for micro-controllers

This paper proposes an optimisation of the adaptive Gaussian mixture background model that allows the deployment of the method on processors with low memory capacity. The effect of the granularity of the Gaussian mean-value and variance in an integer-based implementation is investigated and novel updating rules of the mixture weights are described. Based on the proposed framework, an implementation for a very low power consumption micro-controller is presented. Results show that the proposed method operates in real time on the micro-controller and has similar performance to the original model. © 2012 Springer-Verlag.