Accessory minerals and potentially toxic elements in Tanzanian vermiculites with respect to agricultural applications

The study assessed accessory minerals and metals in Tanzanian vermiculites with respect to their potential suitability for agricultural applications. Mineral and chemical analyses were involved. Pot experiments were also conducted to assess plant uptake of metals from soil with vermiculites. Fibrous sepiolite and amphiboles were minerals of health concern found in some samples. The sepiolite fibers had aspect ratios similar to those of asbestos minerals, which cause respiratory disorders and lung cancer when inhaled and thus pose a potential health risk to animals and humans. The amphibole fibers were thicker than 10 μm and are unlikely to be inhaled. Chromium (Cr) and nickel (Ni) concentrations in some samples were greater than the limits permitted in agricultural soils, but the elements are not highly plant available and do not inhibit the uptake of essential macronutrients. Heating vermiculites at 400-600° C enhanced extractability of Cr and Ni and should preferably be avoided. © Taylor & Francis Group, LLC.

Genetic mapping of the rice ionome in leaves and grain:Identification of QTLs for 17 elements including arsenic, cadmium, iron and selenium

Research into the composition of cereal grains is motivated by increased interest in food quality. Here multi-element analysis is conducted on leaves and grain of the Bala x Azucena rice mapping population grown in the field. Quantitative trait loci (QTLs) for the concentration of 17 elements were detected, revealing 36 QTLs for leaves and 41 for grains. Epistasis was detected for most elements. There was very little correlation between leaf and grain element concentrations. For selenium, lead, phosphorus and magnesium QTLs were detected in the same location for both tissues. In general, there were no major QTL clusters, suggesting separate regulation of each element. QTLs for grain iron, zinc, molybdenum and selenium are potential targets for marker assisted selection to improve seed nutritional quality. An epistatic interaction for grain arsenic also looks promising to decrease the concentration of this carcinogenic element. © Springer Science+Business Media B.V. 2009.

Evaluating fault tolerance on asymmetric multicore systems-on-chip using iso-metrics

The end of Dennard scaling has promoted low power consumption into a firstorder concern for computing systems. However, conventional power conservation schemes such as voltage and frequency scaling are reaching their limits when used in performance-constrained environments. New technologies are required to break the power wall while sustaining performance on future processors. Low-power embedded processors and near-threshold voltage computing (NTVC) have been proposed as viable solutions to tackle the power wall in future computing systems. Unfortunately, these technologies may also compromise per-core performance and, in the case of NTVC, xreliability. These limitations would make them unsuitable for HPC systems and datacenters. In order to demonstrate that emerging low-power processing technologies can effectively replace conventional technologies, this study relies on ARM’s big.LITTLE processors as both an actual and emulation platform, and state-of-the-art implementations of the CG solver. For NTVC in particular, the paper describes how efficient algorithm-based fault tolerance schemes preserve the power and energy benefits of very low voltage operation.

Major and trace elements in milk and Halloumi cheese as markers for authentication of goat feeding regimes and geographical origin

Sixty samples of milk, Halloumi cheese and local grazing plants (i.e. shrubs) were collected over a year from dairy farms located on three different locations of Cyprus. Major and trace elements were quantified using inductively coupled plasma-atomic emission spectroscopy (ICP-AES). Milk and Halloumi cheese produced in different geographical locations presented significant differences in the concentration of some of the elements analysed. Principal component analysis showed grouping of samples according to the region of production for both milk and cheese samples. These findings show that the assay of elements can provide useful fingerprints for the characterisation of dairy products.

Trace elements as predictors of preeclampsia in type 1 diabetic pregnancy

Preeclampsia (PE) affects approximately 5% of all pregnancies, but is increased several-fold in women with pre-gestational type 1 diabetes mellitus (T1DM). Increased oxidative stress and altered maternal plasma trace elements that modulate the antioxidant system have been implicated in PE. In non-diabetic women, increased plasma copper and iron and decreased manganese, selenium, and zinc have been associated with PE in cross-sectional studies. In a longitudinal study, we hypothesized that plasma levels of trace elements differ between T1DM women with vs. without subsequent PE. Samples were collected during the first (gestation 12.2 ± 1.9 weeks, [mean ± SD]), second (21.6 ± 1.5 weeks), and third (31.5 ± 1.7 weeks) trimesters of pregnancy, all before the onset of PE. We compared 23 T1DM women who subsequently developed PE with 24 T1DM women who remained normotensive; and we included 19 non-diabetic (non-DM) normotensive pregnant women as reference controls. Trace elements were measured using inductively coupled plasma mass spectroscopy. In T1DM women with subsequent PE vs normotensive, only plasma zinc was significantly higher at the first trimester, while copper:zinc and copper:high-density lipoprotein cholesterol ratios were higher throughout gestation (all P < .05). These findings persisted after adjustment for covariates. Higher copper:zinc ratios may contribute to oxidative stress in T1DM women who develop PE. Ratios of pro- to anti-oxidant factors may predict risk for PE in diabetic pregnancies more effectively than individual trace element levels.

Global identification of androgen response elements

Chromatin immunoprecipitation (ChIP) is an invaluable tool in the study of transcriptional regulation. ChIP methods require both a priori knowledge of the transcriptional regulators which are important for a given biological system and high-quality specific antibodies for these targets. The androgen receptor (AR) is known to play essential roles in male sexual development, in prostate cancer and in the function of many other AR-expressing cell types (e.g. neurons and myocytes). As a ligand-activated transcription factor the AR also represents an endogenous, inducible system to study transcriptional biology. Therefore, ChIP studies of the AR can make use of treatment contrast experiments to define its transcriptional targets. To date several studies have mapped AR binding sites using ChIP in combination with genome tiling microarrays (ChIP-chip) or direct sequencing (ChIP-seq), mainly in prostate cancer cell lines and with varying degrees of genomic coverage. These studies have provided new insights into the DNA sequences to which the AR can bind, identified AR cooperating transcription factors, mapped thousands of potential AR regulated genes and provided insights into the biological processes regulated by the AR. However, further ChIP studies will be required to fully characterise the dynamics of the AR-regulated transcriptional programme, to map the occupancy of different AR transcriptional complexes which result in different transcriptional output and to delineate the transcriptional networks downstream of the AR.

Improving composite damage modelling through automatic placement of cohesive elements

Numerous experimental studies of damage in composite laminates have shown that intralaminar (in-plane) matrix cracks lead to interlaminar delamination (out-of-plane) at ply interfaces. The smearing of in-plane cracks over a volume, as a consequence of the use of continuum damage mechanics, does not always effectively capture the full extent of the interaction between the two failure mechanisms. A more accurate representation is obtained by adopting a discrete crack approach via the use of cohesive elements, for both in-plane and out-of-plane damage. The difficulty with cohesive elements is that their location must be determined a priori in order to generate the model; while ideally the position of the crack migration, and more generally the propagation path, should be obtained as part of the problem’s solution. With the aim of enhancing current modelling capabilities with truly predictive capabilities, a concept of automatic insertion of interface elements is utilized. The consideration of a simple traction criterion in relation to material strength, evaluated at each node of the model (or of the regions of the model where it is estimated cracks might form), allows for the determination of initial crack location and subsequent propagation by the insertion of cohesive elements during the course of the analysis. Several experimental results are modelled using the commercial package ABAQUS/Standard with an automatic insertion subroutine developed in this work, and the results are presented to demonstrate the capabilities of this technique.

Streaming Elements for FPGA Signal and Image Processing Accelerators

Field programmable gate array devices boast abundant resources with which custom accelerator components for signal, image and data processing may be realised; however, realising high performance, low cost accelerators currently demands manual register transfer level design. Software-programmable ’soft’ processors have been proposed as a way to reduce this design burden but they are unable to support performance and cost comparable to custom circuits. This paper proposes a new soft processing approach for FPGA which promises to overcome this barrier. A high performance, fine-grained streaming processor, known as a Streaming Accelerator Element, is proposed which realises accelerators as large scale custom multicore networks. By adopting a streaming execution approach with advanced program control and memory addressing capabilities, typical program inefficiencies can be almost completely eliminated to enable performance and cost which are unprecedented amongst software-programmable solutions. When used to realise accelerators for fast fourier transform, motion estimation, matrix multiplication and sobel edge detection it is shown how the proposed architecture enables real-time performance and with performance and cost comparable with hand-crafted custom circuit accelerators and up to two orders of magnitude beyond existing soft processors.

Compositonal Analysis of Potentially harmful Elements in Soils: Implications for Epidemiology and Kidney Disease

A substantial proportion of aetiological risks for many cancers and chronic diseases remain unexplained. Using geochemical soil and stream water samples collected as part of the Tellus Project studies, current research is investigating naturally occurring background levels of potentially toxic elements (PTEs) in soils and stream sediments and their possible relationship with progressive chronic kidney disease (CKD). The Tellus geological mapping project, Geological Survey Northern Ireland, collected soil sediment and stream water samples on a grid of one sample site every 2 km2 across the rural areas of Northern Ireland resulting in an excess of 6800 soil sampling locations and more than 5800 locations for stream water sampling. Accumulation of several PTEs including arsenic, cadmium, chromium, lead and mercury have been linked with human health and implicated in renal function decline. The hypothesis is that long-term exposure will result in cumulative exposure to PTEs and act as risk factor(s) for cancer and diabetes related CKD and its progression. The ‘bioavailable’ fraction of total PTE soil concentration depends on the ‘bioaccessible’ proportion through an exposure pathway. Recent work has explored this bioaccessible fraction for a range of PTEs across Northern Ireland. In this study the compositional nature of the multivariate geochemical PTE variables and bioaccessible data is explored to augment the investigation into the potential relationship between PTEs, bioaccessibility and disease data.

Assessing elements of a family approach to reduce adolescent drinking frequency: parent-adolescent relationship, knowledge management, and keeping secrets

AIMS: To estimate 1) the associations between parent-adolescent relationship, parental knowledge and subsequent adolescent drinking frequency and 2) the influence of alcohol use on parental knowledge.

DESIGN: Path analysis of school based cohort study with annual surveys SETTING: Post primary schools from urban and intermediate/rural areas in Northern Ireland PARTICIPANTS: 4,937 post primary school students aged around 11 years in 2000 followed until around age 16 in 2005.

MEASUREMENTS: Pupil reported measures of: frequency of alcohol use; parental-child relationship quality; sub-dimensions of parental monitoring: parental control, parental solicitation, child disclosure and child secrecy.

FINDINGS: Higher levels of parental control (Ordinal logistic OR 0.86 95% CI 0.78, 0.95) and lower levels of child secrecy (OR 0.83 95% CI 0.75 0.92) were associated with less frequent alcohol use subsequently. Parental solicitation and parent-child relationship quality were not associated with drinking frequency. Weekly alcohol drinking was associated with higher subsequent secrecy (Beta -0.42 95% CI -0.53, -0.32) and lower parental control (Beta -0.15 95% CI -0.26, -0.04). Secrecy was more strongly predictive of alcohol use at younger compared with older ages (P=0.02), and alcohol use was less strongly associated with parental control among families with poorer relationships (P=0.04).

CONCLUSIONS: Adolescent alcohol use appears to increase as parental control decreases and child secrecy increases. Greater parental control is associated with less frequent adolescent drinking subsequently, while parent-child attachment and parental solicitation have little influence on alcohol use. 

Generalized collisional radiative model for light elements: C: Data for the B isonuclear sequence

A first stage collision database is assembled which contains electron-impact excitation, ionization,\r and recombination rate coefficients for B, B + , B 2+ , B 3+ , and B 4+ . The first stage database\r is constructed using the R-matrix with pseudostates, time-dependent close-coupling, and perturbative\r distorted-wave methods. A second stage collision database is then assembled which contains\r generalized collisional-radiative ionization, recombination, and power loss rate coefficients as a\r function of both temperature and density. The second stage database is constructed by solution of\r the collisional-radiative equations in the quasi-static equilibrium approximation using the first\r stage database. Both collision database stages reside in electronic form at the IAEA Labeled Atomic\r Data Interface (ALADDIN) database and the Atomic Data Analysis Structure (ADAS) open database.

Generalized collisional radiative model for light elements. Part B: Data for the Be isonuclear sequence

A first-stage collision database is assembled which contains electron-impact excitation, ionization, and recombination rate coefficients for Be, Be+, Be2+, and Be3+. The first-stage database is constructed using the R-matrix with pseudo-states, time-dependent close-coupling, and perturbative, distorted-wave methods. A second-stage collision database is then assembled which contains generalized collisional-radiative and radiated power loss coefficients. The second-stage database is constructed by solution of collisional-radiative equations in the quasi-static equilibrium approximation using the first-stage database. Both collision database stages reside in electronic form at the ORNL Controlled Fusion Atomic Data Center and in the ADAS database, and are easily accessed over the worldwide internet. © 2007 Elsevier Inc. All rights reserved.

Generalised collisional-radiative model for light elements. A: Data for the Li isonuclear sequence

A first stage collision database is assembled which contains electron-impact effective collision strengths, and ionization and recombination rate coefficients for Li, Li+, and Li2+. The first stage database is constructed using the R-matrix with pseudo-states, time-dependent close-coupling, converged close-coupling, and perturbative distorted-wave methods. A second stage collision database is then assembled which contains generalized collisional-radiative and radiated power loss coefficients. The second stage database is constructed by solution of collisional-radiative equations in the quasi-static equilibrium approximation using the first stage database. Both collision database stages reside in electronic form at the ORNL Controlled Fusion Atomic Data Center and in the ADAS database, and are easily accessed over the worldwide internet. ?? 2006 Elsevier Inc. All rights reserved.