Good Laboratory Practice for optimization research

Good Laboratory Practice has been a part of non-clinical research for over 40 years. Optimization Research, despite having many papers discussing standards being published over the same period of time, has yet to embrace standards that underpin its research. In this paper we argue the need to adopt standards in optimization research. Building on previous papers, many of which have suggested that the optimization research community should adopt certain standards, we suggest a concrete set of recommendations that the community should adopt. We also discuss how the proposals in this paper could be progressed.

Influence of service loading and the resulting micro-cracks on chloride resistance of concrete

Chloride-induced corrosion of steel in reinforced concrete structures is one of the main problems affecting their durability, but most previous research projects and case studies have focused on concretes without cracks or not subjected to any structural load. Although it has been recognised that structural cracks do influence the chloride transport and chloride induced corrosion in reinforced concrete structures, there is little published work on the influence of micro-cracks due to service loads on these properties. Therefore the effect of micro-cracks caused by loading on chloride transport into concrete was studied. Four different stress levels (0%, 25%, 50% and 75% of the stress at ultimate load – fu) were applied to 100 mm diameter concrete discs and chloride migration was measured using a bespoke test setup based on the NT BUILD 492 test. The effects of replacing Portland cement CEMI by ground granulated blast-furnace slag (GGBS), pulverised fuel ash (PFA) and silica fume (SF) on chloride transport in concrete under sustained loading were studied. The results have indicated that chloride migration coefficients changed little when the stress level was below 50% of the fu; however, it is desirable to keep concrete stress less than 25% fu if this is practical. The effect of removing the load on the change of chloride migration coefficient was also studied. A recovery of around 50% of the increased chloride migration coefficient was found in the case of concretes subjected to 75% of the fu when the load was removed.

ALMA Observations of a Gap and a Ring in the Protoplanetary Disk around TW Hya

We report the first detection of a gap and a ring in dust continuum emission from the protoplanetary disk around TW Hya, using the Atacama Large Millimeter/Submillimeter Array. The gap and ring are located at 25 and 41 AU from the central star, respectively, and are associated with the CO snowline at ~ 30AU. The gap width and depth are 15AU at the maximum and 23% at the minimum, respectively, regarding that the observations are limited to an angular resolution of ~ 15AU. In addition, we detect a decrement in CO line emission down to ~ 10AU, indicating freeze-out of gas-phase CO onto grain surfaces and possible subsequent surface reactions to form larger molecules. According to theoretical studies, the gap could be caused by gravitational interaction between the disk gas and a planet with a mass less than super-Neptune (2 Neptune mass), or result from destruction of large dust aggregates due to the sintering of CO ice.

Wireless data encoding and decoding using OAM modes

A means of encoding and decoding data using wireless orbital angular momentum (OAM) modes is proposed and analysed. Source data symbols are used to select an OAM mode, which is generated using an 8-element circular array. A 2-element array is used to detect the mode by estimating the phase gradient of the received signal, and hence identifying the transmitted data symbol. The results are presented in terms of mode estimation error.