Detection of an artificial target with low radar cross-section in presence of backscatter

This paper presents an approach to improve the detection of an artificial target with low radar cross-section in presence of clutter. The target proposed in the paper modulates the phase response of the circularly polarized incident signal by means of rotation. The same physical phenomenon can be used to steer the modulated response in a non-specular direction. The bi-static measurements of the response of the target have demonstrated good agreement with theoretical prediction as well as with full-wave simulation.

Changes in modal parameters of a steel truss bridge due to artificial damage

This study investigated how damage changes the modal parameters of a real bridge by means of a field experiment which was conducted on a real steel truss bridge consecutively subjected to four artificial damage scenarios. In the experiment, both the forced and free vibrations of the bridge were recorded, the former for identifying higher modes available exclusively and the latter for lower modes with higher resolution. Results show that modal parameters are little affected by damage causing low stress redistribution. Modal frequencies decrease as damage causing high stress redistribution is applied; such a change can be observed if the damage is at the non-nodal point of the corresponding mode shape. Mode shapes are distorted due to asymmetric damage; they show an amplification in the damaged side as damage is applied at the non-nodal point. Torsion modes become more dominant as damage is applied either asymmetrically or on an element against large design loads. © 2013 Taylor & Francis Group, London.

Artificial receptors for the extraction of nucleoside metabolite 7-methylguanosine from aqueous media made by molecular imprinting

A series of imprinted polymers targeting nucleoside metabolites, prepared using a template analogue approach, are presented. These were prepared following selection of the optimum functional monomer by solution association studies using 1H-NMR titrations whereby methacrylic acid was shown to be the strongest receptor with and affinity constant of 621 ± 51 L mol-1 vs. 110 ± 16 L mol-1 for acrylamide. The best performing polymers were prepared using methanol as porogenic co-solvent and although average binding site affinities were marginally reduced, 2.3×104 L mol-1 vs. 2.7×104 L mol-1 measured for a polymer prepared in acetonitrile, these polymers contained the highest number of binding sites, 5.27 μmol g-1¬¬ vs. 1.64 μmol g-1, while they also exhibited enhanced selectivity for methylated guanosine derivatives. When applied as sorbents in the extraction of nucleoside derivative cancer biomarkers from synthetic urine samples, significant sample clean-up and recoveries of up to 90% for 7-methylguanosine were achieved.

METAMORPHOSE VI – the Virtual Institute for artificial electromagnetic materials and metamaterials: Origin, mission, and activities

In this paper, we outline the background, mission, and activities of the Virtual Institute for Artificial Electromagnetic Materials and Metamaterials (METAMORPHOSE VI). This international association, founded in the framework of the FP-6 Network of Excellence METAMORPHOSE, aims at promoting and developing research, training, and dissemination activities in the emerging and highly dynamic field of advanced electromagnetic materials and metamaterials at both European and International levels. More than 300 researchers are currently associated with the METAMORPHOSE VI which networks them together in a learnt society. After a brief description of the association and its mission, we present an overview of the activities developed by the METAMORPHOSE VI, with a particular emphasis on the coordination of the European Doctoral Program on Metamaterials (EUPROMETA) and the organization of the International Congress on Advanced Electromagnetic Materials in Microwaves and Optics – metamaterials congress.

Urethral atrophy after artificial urinary sphincter placement:Is cuff downsizing effective?

Purpose: We reviewed the outcome of cuff downsizing with an artificial urinary sphincter for treating recurrent incontinence due to urethral atrophy.

Materials and Methods: We analyzed the records of 17 patients in a 7-year period in whom clinical, radiological and urodynamic evidence of urethral atrophy was treated with cuff downsizing. Cuff downsizing was accomplished by removing the existing cuff and replacing it with a 4 cm. cuff within the established false capsule. Incontinence and satisfaction parameters before and after the procedure were assessed by a validated questionnaire.

Results: Mean patient age was 70 years (range 62 to 79). Average time to urethral atrophy was 31 months (range 5 to 96) after primary sphincter implantation. Mean followup after downsizing was 22 months (range 1 to 64). Cuff downsizing caused a mean decrease of 3.9 to 0.5 pads daily. The number of severe leakage episodes decreased from a mean of 5.4 to 2.1 The mean SEAPI (stress leakage, emptying, anatomy, protection, inhibition) score decreased from 8.2 to 2.4. Patient satisfaction increased from 15% to 80% after cuff downsizing. In 1 patient an infected cuff required complete removal of the device.

Conclusions: Patient satisfaction and continence parameters improved after cuff downsizing. We believe that this technique is a simple and effective method of restoring continence after urethral atrophy.

Artificial urinary sphincter implantation in the irradiated patient:safety, efficacy and satisfaction

Objective To compare the long-term outcome of artificial urinary sphincter (AUS) implantation in patients after prostatectomy, with and with no history of previous irradiation.

Patients and methods The study included 98 men (mean age 68 years) with urinary incontinence after prostatectomy for prostate cancer (85 radical, 13 transurethral resection) who had an AUS implanted. Twenty-two of the patients had received adjuvant external beam irradiation before AUS implantation. Over a mean (range) follow-up of 46 (5-118) months, the complication and surgical revision rates were recorded and compared between irradiated and unirradiated patients. The two groups were also compared for the resolution of incontinence and satisfaction, assessed using a questionnaire.

Results Overall, surgical revision was equally common in irradiated (36%) and unirradiated (24%) patients. After activating the AUS, urethral atrophy, infection and erosion requiring surgical revision were more common in irradiated patients (41% vs 11%; P <0.05); 70% of patients reported a significant improvement in continence, regardless of previous irradiation. Patient satisfaction remained high, with >80% of patients stating that they would undergo surgery again and/or recommend it to others, despite previous Irradiation and/or the need for surgical revision.

Conclusions Despite higher complication and surgical revision rates in patients who have an AUS implanted and have a history of previous Irradiation, the long-term continence and patient satisfaction appear not to be adversely affected.

THE ARTIFICIAL URINARY SPHINCTER - A NEW SOLUTION FOR INCONTINENT PATIENTS

Treatment of urinary incontinence with the artificial urinary sphincter has been available in centres such as London and Liverpool for a number of years. This service is now available in the department of urology of the Belfast City Hospital. Twelve patients have had successful implantation of an artificial urinary sphincter for urinary incontinence, and ten are now fully continent. One patient with Wegener's granulomatosis developed active disease in his urethra which has precluded activation of the device. One patient has had the device removed because of erosion into the urethra.

Predicting forest attributes In southeast Alaska using artificial neural networks

Artificial neural network (ANN) methods are used to predict forest characteristics. The data source is the Southeast Alaska (SEAK) Grid Inventory, a ground survey compiled by the USDA Forest Service at several thousand sites. The main objective of this article is to predict characteristics at unsurveyed locations between grid sites. A secondary objective is to evaluate the relative performance of different ANNs. Data from the grid sites are used to train six ANNs: multilayer perceptron, fuzzy ARTMAP, probabilistic, generalized regression, radial basis function, and learning vector quantization. A classification and regression tree method is used for comparison. Topographic variables are used to construct models: latitude and longitude coordinates, elevation, slope, and aspect. The models classify three forest characteristics: crown closure, species land cover, and tree size/structure. Models are constructed using n-fold cross-validation. Predictive accuracy is calculated using a method that accounts for the influence of misclassification as well as measuring correct classifications. The probabilistic and generalized regression networks are found to be the most accurate. The predictions of the ANN models are compared with a classification of the Tongass national forest in southeast Alaska based on the interpretation of satellite imagery and are found to be of similar accuracy.

Modeling of titanium alloys by using artificial neural networks

Titanium alloy exhibits an excellent combination of bio-compatibility, corrosion resistance, strength and toughness. The microstructure of an alloy influences the properties. The microstructures depend mainly on alloying elements, method of production, mechanical, and thermal treatments. The relationships between these variables and final properties of the alloy are complex, non-linear in nature, which is the biggest hurdle in developing proper correlations between them by conventional methods. So, we developed artificial neural networks (ANN) models for solving these complex phenomena in titanium alloys.

In the present work, ANN models were used for the analysis and prediction of the correlation between the process parameters, the alloying elements, microstructural features, beta transus temperature and mechanical properties in titanium alloys. Sensitivity analysis of trained neural network models were studied which resulted a better understanding of relationships between inputs and outputs. The model predictions and the analysis are well in agreement with the experimental results. The simulation results show that the average output-prediction error by models are less than 5% of the prediction range in more than 95% of the cases, which is quite acceptable for all metallurgical purposes.

Artificial Neural Network for Compositional Ionic Liquid Viscosity Prediction

Being a new generation of green solvents and high-tech reaction media of the future, ionic liquids have increasingly attracted much attention. Of particular interest in this context are room temperature ionic liquids (in short as ILs in this paper). Due to the relatively high viscosity, ILs is expected to be used in the form of solvent diluted mixture with reduced viscosity in industrial application, where predicting the viscosity of IL mixture has been an important research issue. Different IL mixture and many modelling approaches have been investigated. The objective of this study is to provide an alternative model approach using soft computing technique, i.e., artificial neural network (ANN) model, to predict the compositional viscosity of binary mixtures of ILs [C _n-mim][NTf ₂] with n=4, 6, 8, 10 in methanol and ethanol over the entire range of molar fraction at a broad range of temperatures from T=293.0-328.0K. The results show that the proposed ANN model provides alternative way to predict compositional viscosity successfully with highly improved accuracy and also show its potential to be extensively utilized to predict compositional viscosity taking account of IL alkyl chain length, as well as temperature and compositions simultaneously, i.e., more complex intermolecular interactions between components in which it would be hard or impossible to establish the analytical model. This illustrates the potential application of ANN in the case that the physical and thermodynamic properties are highly non-linear or too complex. © 2012 Copyright the authors.

Artificial neural network model to predict compositional viscosity over a broad range of temperatures

The objective of this study is to provide an alternative model approach, i.e., artificial neural network (ANN) model, to predict the compositional viscosity of binary mixtures of room temperature ionic liquids (in short as ILs) [C _n-mim] [NTf ₂] with n=4, 6, 8, 10 in methanol and ethanol over the entire range of molar fraction at a broad range of temperatures from T=293.0328.0K. The results show that the proposed ANN model provides alternative way to predict compositional viscosity successfully with highly improved accuracy and also show its potential to be extensively utilized to predict compositional viscosity over a wide range of temperatures and more complex viscosity compositions, i.e., more complex intermolecular interactions between components in which it would be hard or impossible to establish the analytical model. © 2010 IEEE.