The use of recycled demolition aggregate in precast concrete products – Phase III: Concrete pavement flags

A study undertaken at the University of Liverpool has investigated the potential for using construction and demolition waste (C&DW) derived aggregate in the manufacture of a range of precast concrete products, i.e. building and paving blocks and pavement flags. Phase III, which is reported here, investigated
concrete pavement flags. This was subsequent to studies on building and paving blocks. Recycled demolition aggregate can be used to replace newly quarried limestone aggregate, usually used in coarse (6 mm) and fine (4 mm-to-dust) gradings. The first objective was, as was the case with concrete building
and paving blocks, to replicate the process used by industry in fabricating concrete pavement flags in the laboratory. The ‘‘wet’’ casting technique used by industry for making concrete flags requires a very workable mix so that the concrete flows into the mould before it is compressed. Compression squeezes out water from the top as well as the bottom of the mould. This industrial casting procedure was successfully replicated in the laboratory by using an appropriately modified cube crushing machine and a special mould typical of what is used by industry. The mould could be filled outside of the cube crushing machine and then rolled onto a steel frame and into the machine for it to be compressed. The texture and mechanical properties of the laboratory concrete flags were found to be similar to the factory ones. The experimental work involved two main series of tests, i.e. concrete flags made with concrete- and
masonry-derived aggregate. Investigation of flexural strength was required for concrete paving flags. This is different from building blocks and paving blocks which required compressive and tensile splitting strength respectively. Upper levels of replacement with recycled demolition aggregate were determined
that produced similar flexural strength to paving flags made with newly quarried aggregates, without requiring an increase in the cement content. With up to 60% of the coarse or 40% of the fine fractions replaced with concrete-derived aggregates, the target mean flexural strength of 5.0 N/mm2 was still
achieved at the age of 28 days. There was similar detrimental effect by incorporating the fine masonry-derived aggregate. A replacement level of 70% for coarse was found to be satisfactory and also conservative. However, the fine fraction replacement could only be up to 30% and even reduced to 15% when used for mixes where 60% of the coarse fraction was also masonry-derived aggregate.

Micro-scale biopitting by endolithic lichen and their role in meso-scale solution basin development on limestone

Data are reported demonstrating the potential role of microscale morphologies, induced by endolithic lichen communities, specifically Verrucaria baldensis, in the initiation and development of mesoscale solution basin formation on limestone in the Burren, Co. Clare. A biophysical model is proposed outlining the different microscale stages leading to solution basin initiation with a progression from initial lichen colonisation and growth, associated biopitting followed by biopit coalescence to form biotroughs, their subsequent enlargement and eventual incipient solution basin formation. This model provides one explanation for solution basin development as this end state may also be achieved through simple solutional means without biological input. The complexity of interactions at the rock / lichen interface are identified with emphasis on the spatial and temporal variability of these underlining the point that, as with macro-topographies at the landscape scale, rock surface micro-topographies also reflect historical weathering legacies.

Renal replacement treatment for diabetic nephropathy in Northern Ireland 1979-1987

Twenty-three patients with end-stage renal failure due to diabetic nephropathy received renal replacement treatment. All patients had insulin-dependent diabetes mellitus. Nineteen transplants were performed in seventeen patients. Two-year graft survival for all transplants was 74% with a two-year patient survival post-transplantation of 81%. Overall two-year patient survival was 73%, compared with 82% in non-diabetic patients receiving renal replacement treatment. In diabetic patients accepted for treatment there was a high incidence of non-renal complications, particularly vascular disease. An aggressive approach to the treatment of vascular disease in these patients may improve overall survival rates.

Renal replacement therapy in multiple myeloma and systemic amyloidosis

Renal failure frequently complicates both multiple myeloma and systemic amyloidosis. Renal replacement therapy (RRT) may be poorly tolerated and its role in such patients is not clearly defined. Of fifty patients (26 males and 24 females) referred to a single centre because of renal failure associated with multiple myeloma or systemic amyloidosis 37 progressed to end-stage renal failure and 30 of these patients received RRT. Nine patients have been treated by CAPD, 13 by haemodialysis, and 8 patients have required both forms of dialysis. Overall one year and two year survival rates were 66% and 57% respectively. The median duration on RRT was 7.5 months (range 1-96 months) with a 51% one year, and a 46% two year survival rate. Of 7 patients with amyloidosis who underwent renal transplantation, 3 died within 6 months of transplantation. Undiagnosed cardiac involvement contributed to this early mortality. We conclude that renal replacement therapy is appropriate for some patients with multiple myeloma and systemic amyloidosis who develop endstage renal failure. Careful assessment and selection of patients is necessary prior to renal transplantation.

Nitrofurazone accumulates in avian eyes - a replacement for semicarbazide as a marker of abuse

Intact nitrofurazone is present in whole eyes of chickens fed varying levels of this banned antibiotic and may therefore be used as an alternative to the controversial marker residue, semicarbazide, to monitor for abuse of this drug in primary production.

Comorbidities and current smoking status amongst patients starting renal replacement therapy in England, Wales and Northern Ireland from 2003 to 2008: national and centre-specific analyses

Introduction: The prevalence of comorbidities in incident renal replacement therapy (RRT) patients changes with age and varies between ethnic groups. This study describes these associations and the independent effect of comorbidities on outcomes. Methods: Adult patients starting RRT between 2003 and 2008 in centres reporting to the UK Renal Registry (UKRR) with data on comorbidity (n ¼ 14,909) were included. The UKRR studied the association of comorbidity with patient demographics, treatment modality, haemoglobin, renal function at start of RRT and subsequent listing for kidney transplantation. The relationship between comorbidities and mortality at 90 days and one year after 90 days from start of RRT was explored using Cox regression. Results: Completeness of comorbidity data was 40.0% compared with 54.3% in 2003. Of patients with data, 53.8% had one or more comorbidities. Diabetes mellitus and ischaemic heart disease were the most common conditions seen in 30.1% and 22.7% of patients respectively. Current smoking was recorded for 14.5% of incident RRT patients in the 6-year period. Comorbidities became more common with increasing age in all ethnic groups although the difference between the 65–74 and 75+ age groups was not significant. Within each age group, South Asians and Blacks had lower rates of comorbidity, despite higher rates of diabetes mellitus. In multivariate survival analysis, malignancy and ischaemic/neuropathic ulcers were the strongest independent predictors of poor survival at 1 year after 90 days from the start of RRT. Conclusion: Differences in prevalence of comorbid illnesses in incident RRT patients may reflect variation in access to health care or competing risk prior to commencing treatment. At the same time, smoking rates remained high in this ‘at risk’ population. Further work on this and ways to improve comorbidity reporting should be priorities for 2010–11.

Comorbidities and current smoking status amongst patients starting renal replacement therapy in England, Wales and Northern Ireland: national and centre-specific analyses

Introduction: The prevalence of 13 comorbid conditions and smoking status at the time of starting renal replacement therapy (RRT) in England, Wales and Northern Ireland are described. Methods: Adult patients starting RRT between 2002 and 2007 in centres reporting to the UK Renal Registry (UKRR) and with data on comorbidity (n¼13,293) were included. The association of comorbidity with patient demographics, treatment modality, haemoglobin, renal function at start of RRT and subsequent listing for kidney transplantation were studied. Association between comorbidities and mortality at 90 days and one year after 90 days from start of RRT was explored using Cox regression. Results: Completeness of data on comorbidity returned to the UKRR remained poor. Of patients with data, 52% had one or more comorbidities. Diabetes mellitus and ischaemic heart disease were the most common conditions seen in 28.9% and 22.5% of patients respectively. Comorbidities became more common with increasing age (up to the 65–74 age group), were more common amongst Whites and were associated with a lower likelihood of pre-emptive transplantation, a greater likelihood of starting on haemodialysis (rather than peritoneal dialysis) and a lower likelihood of being listed for kidney transplantation. In multivariable survival analysis, malignancy and ischaemic/neuropathic ulcers were the strongest predictors of poor survival at 1 year after 90 days from start of RRT. Conclusions: The majority of patients had at least one comorbid condition and comorbidity is an important predictor of early mortality on RRT.

Alternative method for producing organic fertiliser from anaerobic digestion liquor and limestone powder:High Shear wet granulation

Generally, the solid and liquid fractions (digestate) from Anaerobic Digestion (AD) energy production are considered as waste. This has a negative impact on the sustainability of AD processes because of the financial outlay required to treat digestate before being discharged into municipal water treatment plants or natural water bodies. The main aim of this research was to investigate feasibility of producing an organic fertiliser using anaerobic digestate and limestone powders as the raw materials employing a high shear granulation process. Two-level factorial experimental design was used to determine the influence of granulation process variables on, the strength, resistance to attrition and yield of the granules. It was concluded from the study that it is technically feasible to produce organic fertiliser granules of acceptable strength and product yield. Increasing the liquid-to-solid ratio during granulation leads to increased granule strength and better product yield. Although the strength of the granules produced was lower than typical strength of commercial synthetic fertiliser granules (about 5 to 7. MPa), this could be improved by mixing the digestate with a polymeric binder or coating the particles post granulation. © 2012 Elsevier B.V.