Approaching near-capacity on a multi-antenna channel using successive decoding and interference cancellation receivers

In this paper, we address the problem of designing multirate codes for a multiple-input and multiple-output (MIMO) system by restricting the receiver to be a successive decoding and interference cancellation type, when each of the antennas is encoded independently. Furthermore, it is assumed that the receiver knows the instantaneous fading channel states but the transmitter does not have access to them. It is well known that, in theory, minimum-mean-square error (MMSE) based successive decoding of multiple access (in multi-user communications) and MIMO channels achieves the total channel capacity. However, for this scheme to perform optimally, the optimal rates of each antenna (per-antenna rates) must be known at the transmitter. We show that the optimal per-antenna rates at the transmitter can be estimated using only the statistical characteristics of the MIMO channel in time-varying Rayleigh MIMO channel environments. Based on the results, multirate codes are designed using punctured turbo codes for a horizontal coded MIMO system. Simulation results show performances within about one to two dBs of MIMO channel capacity.

On the Capacity of Non-Uniform Phase MIMO Nakagami-m Fading Channels

This letter investigates the ergodic capacity of MIMO Nakagami-m fading channels with both uniformly and non-uniformly distributed phases. We first obtain a tight capacity upper bound for the channel and then derive exact expressions for the low signal-to-noise ratio (SNR) capacity metrics, based on which we examine the impact of fading parameter m on the capacity.

Capacity-building, representation and intracommunity conflict

This paper explores the nature of community capacity-building in the context of local development. It challenges some of the simplistic constructions of community as a distinctive stakeholder with a shared set of values and clear identity. Even in apparently homogeneous place-based communities such as in the Catholic Ardoyne area of North Belfast there are important differences in the way in which local people interact with the organised voluntary sector. The paper concludes by highlighting the need to reach deeper into the concerns of local people, rather than the priorities of statutory funders, as a basis for service provision and local planning.

High capacity carbon based electrodes for lithium/oxygen batteries

Porous carbon aerogels are prepared by polycondensation of resorcinol (R) and formaldehyde (F)catalyzed by sodium carbonate (C) followed by carbonization of the resultant aerogels at 800? in an inert atmosphere. The porous texture of the carbons has been adjusted by the change of the molar ratio of resorcinol to catalyst (R/C) in the gel precursors in the range of 100 to 500. The porous structure of the aerogels and carbon aerogels are characterized by N2 adsorption-desorption measurements at 77 K. It is found that total pore volume and average pore diameter of the carbons increase with increase in the R/C ratio of the gel precursors.The prepared carbon aerogels are used as active materials in fabrication of composite carbon electrodes. The electrochemical performance of the electrodes has been tested by using them as cathodes in a Li/O2 cell. Through the galvanostatic charge/discharge measurements, it is found that with an increase of R/C ratio, the specific capacity of the Li/O2 cell fabricated from the carbon aerogels increases from 716 to 2077 charge/discharge cycles indicate that the carbon samples possess excellent stability on cycling.

Characterizing capacity loss of lithium oxygen batteries by impedance spectroscopy

Polymer based carbon aerogels were prepared by synthesis of a resorcinol formaldehyde gel followed by pyrolysis at 1073K under Ar and activation of the resultant carbon under CO2 at different temperatures. The prepared carbon aerogels were used as active materials in the preparation of cathode electrodes for lithium oxygen cells and the electrochemical performance of the cells was evaluated by galvanostatic charge/discharge cycling and electrochemical impedance measurements. It was shown that the storage capacity and discharge voltage of a Li/O2 cell strongly depend on the porous structure of the carbon used in cathode. EIS results also showed that the shape and value of the resistance in the impedance spectrum of a Li/O2 cell are strongly affected by the porosity of carbon used in the cathode. Porosity changes due to the build up of discharge products hinder the oxygen and lithium ion transfer into the electrode, resulting in a gradual increase in the cell impedance with cycling. The discharge capacity and cycle life of the battery decrease significantly as its internal resistance increases with charge/discharge cycling.

Comparison and evaluation of the specificity and binding capacity of commercial and in house affinity columns used in sample preparation for analysis of growth-promoting drugs

Immunoaffinity chromatography (IAC) and affinity chromatography (AC:) are widely used for extraction of drugs from biological samples. Fifteen column types were purchased from five different manufacturers and;their ability to bind specific drugs including beta-agonists and anabolic steroids over a range of analyte concentrations in fortified bovine urine samples was assessed. The performance data obtained from these columns were compared with columns produced in this laboratory (in house columns). The in house columns gave the highest recoveries, ranging from 92 to 100% at the 1 ng spiking concentration, for five of the seven analytes assessed. Forty percent (11 of 27) of all the commercial column assessments recorded recoveries of less than 50% even when the lowest spiking concentration was applied (1 ng). For one manufacturer, only one of seven different columns purchased delivered extraction efficiencies greater than 50%. The extraction efficiencies of the clenbuterol columns were the highest with all commercially prepared columns showing at least 50% binding of radiolabelled tracer. Recoveries of alpha-nortestosterone were the lowest. The variability of these products with respect to quality control requires constant monitoring.

Recruitment and capacity-building challenges in participatory research involving young people in Northern Ireland

Consulting young people in social research is increasingly popular and is not confined to their recruitment as participants but extends to the design, delivery and dissemination of research. In this chapter we explore the recruitment and capacity building challenges involved in working with young people as researchers. We will introduce some of the theoretical issues around young people’s participation. Drawing on experiences from four separate participatory research projects with young people in Northern Ireland, we will highlight some of the difficulties encountered and give some practical approaches to managing the research process. Strategies for recruiting and training young researchers will be considered and we also reflect on what the benefits of young people’s involvement can be; not only enhancing the research process but also empowering young people and creating the potential for social agency.