Water efficiency as a means of reducing carbon emissions in Northern Ireland (NI) Water

The water and sewerage sectors' combined emissions account for just over 1% of total UK emissions, while household water heating accounts for a further 5%. Energy use, particularly electricity, is the largest source of emissions in the sector. Water efficiency measures should therefore result in reduced emissions from a lower demand for water and wastewater treatment and pumping, as well as from decreased domestic water heating. Northern Ireland Water (NI Water) is actively pursuing measures to reduce its carbon footprint. This paper investigated the carbon impacts of implementing a household water efficiency programme in Northern Ireland. Assuming water savings of 59.6 L/prop/day and 15% uptake among households, carbon savings of 0.6% of NI Water's current net operational emissions are achievable from reduced treatment and pumping. Adding the carbon savings from reduced household water heating gives savings equivalent to 6.2% of current net operational emissions. Cost savings to NI Water are estimated as 300,000 per year. The cost of the water efficiency devices is approximately 1.6 million, but may be higher depending on the number of devices distributed relative to the number installed. This paper has shown clear carbon benefits to water efficiency, but further research is needed to examine social and cost impacts. © IWA Publishing 2013.

Water and temperature relations of soil Actinobacteria

Actinobacteria perform essential functions within soils, and are dependent on available water to do so. We determined the water-activity (a_w) limits for cell division of Streptomyces albidoflavus, Streptomyces rectiviolaceus, Micromonospora grisea and Micromonospora (JCM 3050) over a range of temperatures, using culture media supplemented with a biologically permissive solute (glycerol). Each species grew optimally at 0.998 a_w (control; no added glycerol) and growth rates were near-optimal in the range 0.971–0.974 (1 M glycerol) at permissive temperatures. Each was capable of cell division at 0.916–0.924 a_w (2 M glycerol), but only S. albidoflavus grew at 0.895 or 0.897 a_w (3 M glycerol, at 30 and 37°C respectively). For S. albidoflavus, however, no growth occurred on media at ≤ 0.870 (4 M glycerol) during the 40-day assessment period, regardless of temperature, and a theoretical limit of 0.877 a_w was derived by extrapolation of growth curves. This level of solute tolerance is high for non-halophilic bacteria, but is consistent with reported limits for the growth and metabolic activities of soil microbes. The limit, within the range 0.895–0.870 a_w, is very much inferior to those for obligately halophilic bacteria and extremely halophilic or xerophilic fungi, and is inconsistent with earlier reports of cell division at 0.500 a_w. These findings are discussed in relation to planetary protection policy for space exploration and the microbiology of arid soils.

Water and Temperature Relations of Growth of the Entomogenous Fungi Beauveria bassiana, Metarhizium anisopliae, and Paecilomyces farinosus

The effects of temperature (5-50°C), water availability (0.998-0.88 water activity, aw), and aw × temperature interactions (15-45°C) on growth of three entomogenous fungi, Beauveria bassiana, Metarhizium anisopliae, and Paecilomyces farinosus, were evaluated on a Sabouraud dextrose-based medium modified with the ionic solute KCl, the non-ionic solute glycerol, and an inert solute, polyethylene glycol (PEG) 600. The temperature ranges for growth of B. bassiana, M. anisopliae, and P. farinosus were 5-30, 5-40, and 5-30°C, and optimum growth temperatures were 25, 30, and 20°C, respectively. All three species grew over a similar aw range (0.90-0.998) at optimum temperatures for growth. However, there were significant interspecies variations in growth rates on media modified with each of the three aw-modifying solutes. Growth aw optima ranged between 0.99 and 0.97 on KCl-, glycerol-, and PEG 600-modified media for M. anisopliae and P. farinosus. B. bassiana grew optimally at 0.998 aw, regardless of aw. Comprehensive two-dimensional profiles of aw × temperature relations for growth of these three species were constructed for the first time. The results are discussed in relation to the environmental limits that determine efficacy of entomogenous fungi as biocontrol agents in nature. © 1999 Academic Press.

Contaminants in surface water and sediments around the Tynagh Mine, Galway, Ireland.

A former silver mine in Tynagh, Co. Galway, Ireland is one of the most contaminated mine sites in Europe with maximum concentrations of Zn, As, Pb, Mn, Ni, Cu, and Cd far exceeding guideline values for water and sediment. The aims of this research were to 1) further assess the contamination, particularly metals, in surface water and sediment around the site, and 2) determine if the contamination has increased 10 years after the Environmental Protection Agency Ireland (EPAI) identified off-site contamination. Site pH is alkaline to neutral because CaCO3-rich sediment and rock material buffer the exposed acid generating sulphide-rich ore. When this study was compared to the previous EPAI study conducted 10 years earlier, it appeared that further weathering of exposed surface sediment had increased concentrations of As and other potentially toxic elements. Water samples from the tailings ponds and adjacent Barnacullia Stream had concentrations of Al, Cd, Mn, Zn and Pb above guideline values. Lead and Zn concentrations from the tailings pond sediment were 16 and 5 times higher, respectively, than concentrations reported 10 years earlier. Pb and Zn levels in most sediment samples exceeded the Expert Group (EGS) guidelines of 1000 and 5000 mg/kg, respectively. Arsenic concentrations were as high as 6238 mg/kg in the tailings ponds sediment, which is 62 and 862 times greater than the EGS and Canadian Soil Quality Guidelines (CSQG), respectively. Cadmium, Cu, Fe, Mn, Pb and Zn concentrations in water and sediment were above guideline values downstream of the site. Additionally, Fe, Mn and organic matter (OM) were strongly correlated and correlated to Zn, Pb, As, Cd, Cu and Ni in stream sediment. Therefore, the nearby Barnacullia Stream is also a significant pathway for contaminant transport to downstream areas. Further rehabilitation of the site may decrease the contamination around the area.

Microbial Communities Associated with Healthy and White Syndrome-Affected Echinopora lamellosa in Aquaria and Experimental Treatment with the Antibiotic Ampicillin

Prokaryotic and ciliate communities of healthy and aquarium White Syndrome (WS)-affected coral fragments were screened using denaturing gradient gel electrophoresis (DGGE). A significant difference (R = 0.907, p < 0.001) in 16S rRNA prokaryotic diversity was found between healthy (H), sloughed tissue (ST), WS-affected (WSU) and antibiotic treated (WST) samples. Although 3 Vibrio spp were found inWS-affected samples, two of these species were eliminated following ampicillin treatment, yet lesions continued to advance, suggesting they play a minor or secondary role in the pathogenesis. The third Vibrio sp increased slightly in relative abundance in diseased samples and was abundant in non-diseased samples. Interestingly, a Tenacibaculum sp showed the greatest increase in relative abundance between healthy and WS-affected samples, demonstrating consistently high abundance across all WS-affected and treated samples, suggesting Tenacibaculum sp could be a more likely candidate for pathogenesis in this instance. In contrast to previous studies bacterial abundance did not vary significantly (ANOVA, F2, 6 = 1.000, p = 0.422) between H, ST, WSU or WST. Antimicrobial activity (assessed on Vibrio harveyi cultures) was limited in both H and WSU samples (8.1% ±8.2 and 8.0% ±2.5, respectively) and did not differ significantly (Kruskal-Wallis, χ2 (2) = 3.842, p = 0.146). A Philaster sp, a Cohnilembus sp and a Pseudokeronopsis sp. were present in all WS-affected samples, but not in healthy samples. The exact role of ciliates in WS is yet to be determined, but it is proposed that they are at least responsible for the neat lesion boundary observed in the disease.

Late effects of cancer and cancer treatment-the perspective of the patient

PURPOSE: Understanding the experience of late effects from the perspective of cancer survivors is essential to inform patient-centred care. This study investigated the nature and onset of late effects experienced by survivors and the manner in which late effects have affected their lives.

METHODS: Sixteen purposively selected cancer survivors participated in a qualitative interview study. The data were analysed inductively using a narrative schema in order to derive the main themes that characterised patients' accounts of late effects.

RESULTS: Individual survivors tended to experience more than one late effect spanning a range of physical and psychological effects. Late effects impacted on relationships, working life, finances and the ability to undertake daily activities. Survivors reported experiencing psychological late effects from around the end of treatment whereas the onset of physical effects occurred later during the post-treatment period. Late effects were managed using formal health services, informal social support and use of 'wellbeing strategies'. Survivors engaged in a process of searching for reasons for experiencing late effects and struggled to make sense of their situation. In particular, a process of 'peer-patient comparison' was used by survivors to help them make sense of, or cope with, their late effects. There appeared to be an association between personal disposition and adaptation and adjustment to the impact of late effects.

CONCLUSIONS: Cancer survivors identified potential components for supported self-management or intervention programmes, as well as important considerations in terms of peer comparisons, personal disposition and making sense of experienced late effects.

Effect of reinforcement and heat treatment on elevated temperature sliding of electroless Ni–P/SiC composite coatings

The investigation is focused on the wear behaviour at elevated test temperature of composite Ni–P/SiC deposit, with varying concentration of the reinforcing SiC particles. The phase evolution measured by X-ray diffraction suggests slight crystallisation during wear testing at 200 °C. In coating without reinforcing particles, adhesive wear is accompanied by microcracks. The thermal heat generated and the cyclic loading could have induced sub-surface microcracks. Owing to the effective matrix-ceramics system in composite coatings, fine grooves, abrasive polishing and uniform wearing are observed. Reinforcing particles in the matrix hinder microcrack formation and significantly reduce the wear rate. Triboxidation is confirmed from energy dispersive X-ray spectrometry.