Effects of Elodea nuttallii on temperate freshwater plants, microalgae and invertebrates: small differences between invaded and uninvaded areas

The invasive aquatic plant species Elodea nuttallii could pose a considerable risk to European freshwater ecosystems based on its current distribution, rate of spread and potential for high biomass. However, little research has been conducted on the impacts of this species on native biota. This study takes an ecosystem-wide approach and examines the impact of E. nuttallii on selected physicochemical parameters (dissolved oxygen and pH), algae, invertebrate and macrophyte communities. Elodea nuttallii had small but significant impacts on plant, invertebrate and algal species. The richness of algal periphyton was lower on E. nuttallii than on native macrophytes. The taxonomic composition of invertebrate communities associated with E. nuttallii differed from that associated with similar native plant species, but did not differ in terms of total biomass or species richness. Macrophyte species richness and total cover were positively correlated with percentage cover of E. nuttallii. Not all macrophyte species responded in the same way to E. nuttallii invasion; cover of the low-growing species, Elodea canadensis and charophytes were negatively correlated with E. nuttallii cover, whilst floating-rooted plants were positively correlated with E. nuttallii cover. All observed differences in the macrophyte community were small relative to other factors such as nutrient levels, inter-annual variation and differences between sites. Despite this, the observed negative association between E. nuttallii and charophytes is a key concern due to the rarity and endangered status of many charophyte species.

Strength model for end cover separation failure in RC beams strengthened with near-surface mounted (NSM) FRP strips

As an alternative to externally bonded FRP reinforcement, near-surface mounted (NSM) FRP reinforcement can be used to effectively improve the flexural performance of RC beams. In such FRP strengthened RC beams, end cover separation failure is one of the common failure modes. This failuremode involves the detachment of the NSM FRP reinforcement together with the concrete cover along the level of the tension steel reinforcement. This paper presents a new strength model for end cover separation failure in RC beams strengthened in flexure with NSM FRP strips (i.e. rectangular FRP bars with asectional height-to-thickness ratio not less than 5), which was formulated on the basis of extensive numerical results from a parametric study undertaken using an efficient finite element approach. The proposed strength model consists of an approximate equation for the debonding strain of the FRP reinforcement at the critical cracked section and a conventional section analysis to relate this debondingstrain to the moment acting on the same section (i.e. the debonding strain). Once the debonding strain is known, the load level at end cover separation of an FRP-strengthened RC beam can be easily determined for a given load distribution. Predictions from the proposed strength model are compared with those of two existing strength models of the same type and available test results, which shows that the proposed strength model is in close agreement with test results and is far more accurate than the existing strength models.

Mitigation of concrete cover separation in frpstrengthened RC beams using FRP U-jackets

Concrete cover separation is a common failure mode of reinforced concrete (RC) beams strengthened with a fibre-reinforced polymer (FRP) plate bonded to the tension face (FRP-plated RC beams). Plate-end FRP U-jackets have previously been explored as a mitigation measure to delay or suppress concrete cover separation, although its effectiveness needs further clarification. The paper presents the first systemic experimental study on the use of FRP U-jackets of different forms for mitigating the concrete cover separation failure. A total of ten full-scale FRP-plated RC beams were tested. The test results show that both the ultimate load and the ductility of the beams were enhanced by the U-jackets. Among the forms of U-jackets explored, those inclined at 45o are the most effective.

Analytical model for bar-end cover separation failure in RC beams strengthened with near-surface mounted FRP

The flexural performance of RC beams can be improved using the near-surface mounted (NSM) FRP strengthening technique. A likely failure mode of such FRP-strengthened RC beams is bar-end cover separation which involves the detachment of the NSM FRP reinforcement together with the concrete cover along the level of the steel tension reinforcement. This paper presents a new analytical strength model for this failure mode. The proposed strength model and two existing strength models for this failure mode are compared with test results to demonstrate the superior performance of the new analytical model.

The effects of lichen cover upon the rate of solutional weathering of limestone

The contribution of lichens to the biomodification of limestone surfaces is an area of conflict within bioweathering studies, with some researchers suggesting a protective effect induced by lichen coverage and others a deteriorative effect induced by the same organisms.Data are reported demonstrating the potential role of endolithic lichen, in particular of Bagliettoa baldensis, in the active protection of Carboniferous limestone surfaces from rainfall-induced solutional weathering. During a 12-month microcatchment exposure period in the west of Northern Ireland, average dissolutional losses of calciumare greater from a lichen-free limestone surface compared with a predominantly endolithic lichen-covered surface by just under 1.25 times. During colderwintermonths, the lichen free surface experiences calcium loss almost 1.5 times greater than the lichen-covered surface. Using extrapolation to upscale from the micro-catchment sample scale, for the year of sample exposure, the rate of calcium loss is 1.001 g m−2 a−1 from lichen-covered limestone surfaces and 1.228 gm−2 a−1 from lichen-free bare limestone surfaces. This research has implications for our understanding of karst environments, the contribution of lichens to karren development and the conservation of lichen-colonised dimension stone within a cultural setting.

Composition and temporal variation of the algal assemblage associated with the haplosclerid sponge Haliclona indistincta (Bowerbank)

Although interactions between seaweeds and sponges have been studied in detail, general information concerning the whole epibiontic algal assemblage associated with a sponge species is virtually non-existent. We present here the first study in which the macroalgal community associated with a sponge, Haliclona indistincta (Bowerbank), was examined in detail. In the period October 2009-September 2010, the seaweed assemblage epibiontic on H. indistincta at a site of the Irish West coast was composed of 66 algal taxa (48 red algae, 7 green algae, 11 brown algae). The red algae Gelidium spinosum and Rhodothamniella floridula were the only epibionts associated with H. indistincta for the whole annual cycle. Most of the algal epibionts were filamentous species, which colonized the surface of the sponge and did not penetrate deeply into it. The algal assemblage was most abundant and species-diverse in the period late winter-spring; multivariate analyses revealed a significant variation of the community on the temporal scale of season and sampling date (weeks to months). The results indicate that the algal communities associated with sponges may be very diverse, showing that this type of assemblage deserves further detailed studies. © 2012 Elsevier B.V.