Feasibility study of high harmonic generation from short wavelength lasers interacting with solid targets

The generation of the third and fourth harmonics from the interaction of a 1 ps, ultraviolet (UV), krypton fluoride (KrF) laser with a solid surface is investigated. The conversion efficiency is seen to increase linearly with I lambda(2), with a transition from specular harmonic emission to emission into 2 pi steradians occurring between 10(15) and 10(16) W cm(-2) mu m(2). The diffuse emission is strongly dependent on the incidence angle of the laser, with the peak in emission at around 30 degrees being consistent with measurements for resonance absorption. Finally, the conversion efficiencies are found to be in agreement with particle-in-cell (PIC) simulations including appropriate density scalelengths. (C) 1998 Elsevier Science B.V.

UNUSUAL CHROMOSOME-NUMBER OF GRACILARIA-VERRUCOSA (GRACILARIALES, RHODOPHYTA) IN THE CAPE-GRIS-NEZ AREA, NORTHERN FRANCE

The chromosome number of Gracilaria verrucosa (Hudson) Papenfuss was estimated in numerous individuals from different populations of the Cape Gris-Nez area of Northern France. To optimize estimates and to minimize counting errors, several counts were made on the same nucleus and in different nuclei of the same individual. The haploid chromosome number was estimated in vegetative gametophytic cells and tetrasporocytic cells; the diploid number was estimated from tetrasporophytic vegetative cells. The basic haploid number was n = 17 +/- 1, whereas all other Gracilaria species for which chromosome numbers are available are reported to have n = 24. These include populations of G. verrucosa from Norway and Wales that have previously been shown to be conspecific with the Cape Gris-Nez populations by comparison of plastid DNA data. G. verrucosa is therefore one of the few red algae for which populations with different chromosome numbers are known.

Plasma parameter characterization of a reflex plasma source operating in oxygen

A reflex discharge plasma, obtained as a hybrid between a Penning discharge plasma (PDP) and a hollow-cathode discharge (HCD) plasma, is analysed as a possible direction-current, high-density plasma source. The experiment is run in oxygen at pressures of 10 mTorr and 1 mTorr, and for discharge currents of 100 to 200 mA. Although the gas pressure is considerably lower than those used in HCDs, the hollow-cathode effect (HCE) occurs for current levels higher than 100 mA and leads to plasma densities comparable with those obtained using inductive plasma sources. The presence of a constant magnetic field leads to the enhancement of electron emission from cathodes under ion bombardment, and to the decreasing of the ion loss by diffusion to the wall.

Opening the Frontier: The Gubbio-Perugia Frontier in the Course of History.

The frontier between Gubbio (ancient Umbria) and Perugia (ancient Etruria), in the northeast part of the modern region of Umbria, was founded in the late sixth century BC. The frontier endured in different forms, most notably in the late antique and medieval periods, as well as fleetingly in 1944, and is fossilized today in the local government boundaries. Archaeological, documentary and
philological evidence are brought together to investigate different scales of time that vary from millennia to single days in the representation of a frontier that captured a watershed of geological origins. The foundation of the frontier appears to have been a product of the active agency of the Etruscans, who projected new settlements across the Tiber in the course of the sixth century BC,
protected at the outer limit of their territory by the naturally defended farmstead of Col di Marzo. The immediate environs of the ancient abbey of Montelabate have been studied intensively by targeted, systematic and geophysical survey in conjunction with excavation, work that is still in progress. An overview of the development of the frontier is presented here, employing the data currently available.

Rapid design of a single chip adaptive beamformer

This paper presents the design of a single chip adaptive beamformer which contains 5 million transistors and can perform 50 GigaFlops. The core processor of the adaptive beamformer is a QR-array processor implemented on a fully efficient linear systolic architecture. The paper highlights a number of rapid design techniques that have been used to realize the design. These include an architecture synthesis tool for quickly developing the circuit architecture and the utilization of a library of parameterizable silicon intellectual property (IP) cores, to rapidly develop the circuit layouts.

Correlates of health status for family caregivers in bereavement

The purpose of this retrospective cohort study was to identify aspects of caregiving associated with health status among family caregivers in bereavement. Study participants included 151 family caregivers of terminally ill patients who had died, on average, 294 days prior to the study telephone interview. The interview covered two main areas: patient characteristics and caregiver characteristics. Multivariate linear regressions revealed that as the age of the care recipient (regression coefficient [b] = -0.32; 95% confidence interval [CI] -0.48,-0.15) and caregiver (b = -0.14; 95% CI = -0.25, -0.02) increased, caregivers experienced a decline in their physical health during bereavement. Furthermore, caregivers who reported that caregiving interrupted their usual activities (b = -5.97; 95% CI = -9.79, -2.15) had a decline in physical health during bereavement. A poorer mental health status during bereavement was seen in caregivers who reported poor physical health during caregiving (b = -4.31; 95% CI = -8.17, -0.45); and that they received insufficient family support in caregiving (b = -6.01; 95% CI = -9.75, -2.27). It was also revealed that a home death was associated with higher mental health of the caregiver (b = 3.55; 95% CI = 0.26, 6.84). The practice implications of these findings are discussed in this paper.

Chemically blockable transformation and ultraselective low-pressure gas adsorption in a non-porous metal organic framework

Metal organic frameworks (MOFs) are among the most exciting materials discovered recently, attracting particular attention for their gas-adsorption and -storage properties. Certain MOFs show considerable structural flexibility in response to various stimuli. Although there are several examples of 'breathing' MOFs, in which structural changes occur without any bond breaking, examples of transformations in which several bonds are broken and made are much rarer. In this paper we demonstrate how a flexible MOF, Cu-2(OH)(C8H3O7S)(H2O)center dot 2H(2)O, can be synthesized by careful choice of the organic linker ligand. The flexibility can be controlled by addition of a supplementary coordinating molecule, which increases the thermal stability of the solid sufficiently for direct imaging with electron microscopy to be possible. We also demonstrate that the MOF shows unprecedented low-pressure selectivity towards nitric oxide through a coordination-driven gating mechanism. The chemical control over these behaviours offers new possibilities for the synthesis of MOFs with unusual and potentially exploitable properties.

A Trip from a Tube to a Chip Applied Micro and Nanotechnology in Biotechnology, Veterinary and Life Sciences

More than 200 known diseases are transmitted via foods or food products. In the United States, food-borne diseases are responsible for 76 million cases of illness, 32,500 cases of hospitalisation and 5000 cases of death yearly. The ongoing increase in worldwide trade in livestock, food, and food products in combination with increase in human mobility (business- and leisure travel, emigration etc.) will increase the risk of emergence and spreading of such pathogens. There is therefore an urgent need for development of rapid, efficient and reliable methods for detection and identification of such pathogens.

Microchipfabrication has had a major impact on electronics and is expected to have an equally pronounced effect on life sciences. By combining micro-fluidics with micromechanics, micro-optics, and microelectronics, systems can be realized to perform complete chemical or biochemical analyses. These socalled ’Lab-on-a-Chip’ will completely change the face of laboratories in the future where smaller, fully automated devices will be able to perform assays faster, more accurately, and at a lower cost than equipment of today. A general introduction of food safety and applied micro-nanotechnology in life sciences will be given. In addition, examples of DNA micro arrays, micro fabricated integrated PCR chips and total integrated lab-on-achip systems from different National and EU research projects being carried out at the Laboratory of Applied Micro- Nanotechnology (LAMINATE) group at the National Veterinary Institute (DTU-Vet) Technical University of Denmark and the BioLabchip group at the Department of Micro and Nanotechnology (DTU-Nanotech), Technical University of Denmark (DTU), Ikerlan-IK4 (Spain) and other 16 partners from different European countries will be presented.

Editorial

Stoddart, S. and C. Malone, Celebrating Antiquity: introduction. Antiquity, 2002. 76(294): p. 1063-5.