Genome-wide profiling of methylation identifies novel targets with aberrant hyper-methylation and reduced expression in low-risk myelodysplastic syndromes

Gene expression profiling signatures may be used to classify the subtypes of Myelodysplastic syndrome (MDS) patients. However, there are few reports on the global methylation status in MDS. The integration of genome-wide epigenetic regulatory marks with gene expression levels would provide additional information regarding the biological differences between MDS and healthy controls. Gene expression and methylation status were measured using high-density microarrays. A total of 552 differentially methylated CpG loci were identified as being present in low-risk MDS; hypermethylated genes were more frequent than hypomethylated genes. In addition, mRNA expression profiling identified 1005 genes that significantly differed between low-risk MDS and the control group. Integrative analysis of the epigenetic and expression profiles revealed that 66.7% of the hypermethylated genes were underexpressed in low-risk MDS cases. Gene network analysis revealed molecular mechanisms associated with the low-risk MDS group, including altered apoptosis pathways. The two key apoptotic genes BCL2 and ETS1 were identified as silenced genes. In addition, the immune response and micro RNA biogenesis were affected by the hypermethylation and underexpression of IL27RA and DICER1. Our integrative analysis revealed that aberrant epigenetic regulation is a hallmark of low-risk MDS patients and could have a central role in these diseases.

Detection of Groundwater flow zones in low productivity boreholes (Submitted)

Conventional methods of detecting groundwater flow zones in open boreholes installed in fractured bedrock aquifers rely on either contrasts in water quality or on significant rates of vertical flow. In low productivity boreholes these methods have proced of limited value. Tracer tests completed in six low productivity bedrock boreholes installed into fresh Precambrian crystalline bedrock revealed measurable dilution, despite very low tranmissivities. Fluorescent tracer profiles generated during discharge pumping permitted identification of the principle zones contributing to flow. High resolution acoustic televiewer strike and dip measurements of fractures corresponding to these zones revealed a consistent pattern of regional lineament trends and suggested a strongly anisotropic flow pattern in bedrock.

The legacy of past manuring practices on soil contamination in remote rural areas

This paper demonstrates that there can be a legacy of contamination on former arable land in remote rural areas as a result of past manuring practices. In the first part of the study four farms abandoned in the late 19th to mid-20th century were investigated with samples collected from residual material in domestic hearths, the midden heaps, kailyards (walled garden for vegetables), infields (intensively managed arable land) and outfields (less intensively managed land for cropping or grazing). Consistent sequences in concentration values were found for such elements as Pb, Zn, Cu and P in the order hearth>midden>kailyard>infield>outfield. Such patterns can in part be explained in terms of atmospheric deposition on peat and turf which were subsequently burnt in hearths to result in enhanced elemental concentrations. The ash then was deposited in midden heaps and subsequently on kailyards or infields. In the second part, microanalytical results from St. Kilda are discussed. Enhanced loadings of Pb and Zn were found in the old arable land. The highest levels of Zn were found in small fragments of carbonised and humified material and bone fragments; in contrast Pb tended to be more uniformly distributed. Seabird waste was extensively applied to the arable land and some of the Zn may have accumulated in the soil by this pathway. The retention of Zn in bone is likely to have been very minor given the rarity of bone fragments as evident in thin sections (0.3%); this compares with 6.8% for black carbonised particles which are likely to provide the main storage sites for Zn.

Dimensions of Financial Autonomy in Low-/Moderate-Income Couples from a Gender Perspective and Implications for Welfare Reform

The ‘unitary household’ lives on in policymakers’ assumptions about couples sharing their finances. Yet financial autonomy is seen as a key issue in gender relations, particularly for women. This article draws on evidence from semi-structured individual interviews with men and women in thirty low-/moderate-income couples in Britain. The interviews explored whether financial autonomy had any meaning to these individuals; and, if so, to what extent this was gendered in the sense of there being differences in men's and women's understanding of it. We develop a framework for the investigation of financial autonomy, involving several dimensions: achieving economic independence, having privacy in one's financial affairs and exercising agency in relation to household and/or personal spending. We argue that financial autonomy is a relevant issue for low-/moderate-income couples, and that women are more conscious of tensions between financial togetherness and autonomy due to their greater responsibility for managing togetherness and lower likelihood of achieving financial independence. Policymakers should therefore not discount the aspirations of women in particular for financial autonomy, even in low-/moderate-income couples where there remain significant obstacles to achieving this. Yet plans for welfare reform that rely on means testing and ignore intra-household dynamics in relation to family finances threaten to exacerbate these obstacles and reinforce a unitary family model.

Human pose tracking in low dimensional space enhanced by limb correction

This paper proposes a two-level 3D human pose tracking method for a specific action captured by several cameras. The generation of pose estimates relies on fitting a 3D articulated model on a Visual Hull generated from the input images. First, an initial pose estimate is constrained by a low dimensional manifold learnt by Temporal Laplacian Eigenmaps. Then, an improved global pose is calculated by refining individual limb poses. The validation of our method uses a public standard dataset and demonstrates its accurate and computational efficiency. © 2011 IEEE.

Modelling the response of fresh groundwater to climate and vegetation changes in coral islands

In coral islands, groundwater is a crucial freshwater resource for terrestrial life, including human water supply. Response of the freshwater lens to expected climate changes and subsequent vegetation alterations is quantified for Grande Glorieuse, a low-lying coral island in the Western Indian Ocean. Distributed models of recharge, evapotranspiration and saltwater phytotoxicity are integrated into a variable-density groundwater model to simulate the evolution of groundwater salinity. Model results are assessed against field observations including groundwater and geophysical measurements. Simulations show the major control currently exerted by the vegetation with regards to the lens morphology and the high sensitivity of the lens to climate alterations, impacting both quantity and salinity. Long-term changes in mean sea level and climatic conditions (rainfall and evapotranspiration) are predicted to be responsible for an average increase in salinity approaching 140 % (+8 kg m-3) when combined. In low-lying areas with high vegetation density, these changes top +300 % (+10 kg m-3). However, due to salinity increase and its phytotoxicity, it is shown that a corollary drop in vegetation activity can buffer the alteration of fresh groundwater. This illustrates the importance of accounting for vegetation dynamics to study groundwater in coral islands.

Partial least squares model for dynamic rating of overhead line in wind intensive areas based on field measurements

This paper presents a statistical model for the thermal behaviour of the line model based on lab tests and field measurements. This model is based on Partial Least Squares (PLS) multi regression and is used for the Dynamic Line Rating (DLR) in a wind intensive area. DLR provides extra capacity to the line, over the traditional seasonal static rating, which makes it possible to defer the need for reinforcement the existing network or building new lines. The proposed PLS model has a number of appealing features; the model is linear, so it is straightforward to use for predicting the line rating for future periods using the available weather forecast. Unlike the available physical models, the proposed model does not require any physical parameters of the line, which avoids the inaccuracies resulting from the errors and/or variations in these parameters. The developed model is compared with physical model, the Cigre model, and has shown very good accuracy in predicting the conductor temperature as well as in determining the line rating for future time periods. 

Influence of embedded length on strength of BFRP rods bonded parallel to the grain in low grade timber by pullout-bending tests

Bonded-in rod connections in timber possess many desirable attributes in terms of efficiency, manufacture, performance, aesthetics and cost. In recent years research has been conducted on such connections using fibre reinforced polymers (FRPs) as an alternative to steel. This research programme investigates the pull-out capacity of Basalt FRP rods bonded-in in low grade Irish Sitka Spruce. Embedded length is thought to be the most influential variable contributing to pull- out capacity of bonded-in rods after rod diameter. Previous work has established an optimum embedded length of 15 times the hole diameter. However, this work only considered the effects of axial stress on the bond using a pull-compression testing system which may have given an artificially high pull out capacity as bending effects were neglected. A hinge system was utilised that allows the effects of bending force to be taken in to consideration along with axial forces in a pull-out test. This paper describes an experimental programme where such pull-bending tests were carried out on samples constructed of 12mm diameter BFRP bars with a 2mm glueline thickness and embedded lengths between 80mm and 280mm bonded-in to low-grade timber with an epoxy resin. Nine repetitions of each were tested. A clear increase in pull-out strength was found with increasing embedded length.