Voltammetry of oxygen in the room-temperature ionic liquids 1-ethyl-3-methylimidazolium bis((trifluoromethyl)sulfonyl)imide and hexyltriethylammonium bis((trifluoromethyl)sulfonyl)imide: One-electron reduction to form superoxide. Steady-state and transient behavior in the same cyclic voltammogram resulting from widely different diffusion coefficients of oxygen and superoxide

The electrochemical reduction of oxygen in two different room-temperature ionic liquids, 1-ethyl-3-methylimidazolium bis((trifluoromethyl)sulfonyl)imide ([EMIM][N(Tf)(2)]) and hexyltriethylammonium bis((trifluoromethyl)sulfonyl)imide ([N-6222][N(Tf)(2)]) was investigated by cyclic voltammetry at a gold microdisk electrode. Chronoamperometric measurements were made to determine the diffusion coefficient, D, and concentration, c, of the electroactive oxygen dissolved in the ionic liquid by fitting experimental transients to the Aoki model. [Aoki, K.; et al. J. Electroanal. Chem. 1981, 122, 19]. A theory and simulation designed for cyclic voltammetry at microdisk electrodes was then employed to determine the diffusion coefficient of the electrogenerated superoxide species, O-2(.-), as well as compute theoretical voltammograms to confirm the values of D and c for neutral oxygen obtained from the transients. As expected, the diffusion coefficient of the superoxide species was found to be smaller than that of the oxygen in both ionic liquids. The diffusion coefficients of O-2 and O-2(.-) in [N-6222][N(Tf)(2)], however, differ by more than a factor of 30 (D-O2 = 1.48 x 10(-10) m(2) s(-1), DO2.- = 4.66 x 10(-12) m(2) s(-1)), whereas they fall within the same order of magnitude in [EMIM][N(Tf)(2)] (D-O2 = 7.3 x 10(-10) m(2) s(-1), DO2.- = 2.7 x 10(-10) m(2) s(-1)). This difference in [N-6222][N(Tf)(2)] causes pronounced asymmetry in the concentration distributions of oxygen and superoxide, resulting in significant differences in the heights of the forward and back peaks in the cyclic voltammograms for the reduction of oxygen. This observation is most likely a result of the higher viscosity of [N-6222][N(Tf)(2)] in comparison to [EMIM][N(Tf)(2)], due to the structural differences in cationic component.

General insight into CO oxidation: A density functional theory study of the reaction mechanism on platinum oxides

CO oxidation on PtO2(110) has been studied using density functional theory calculations. Four possible reaction mechanisms were investigated and the most feasible one is the following: (i) the O at the bridge site of PtO2(110) reacts with CO on the coordinatively unsaturated site (CUS) with a negligible barrier; (ii) O-2 adsorbs on the bridge site and then interacts with CO on the CUS to form an OO-CO complex; (iii) the bond of O-OCO breaks to produce CO2 with a small barrier (0.01 eV). The CO oxidation mechanisms on metals and metal oxides are rationalized by a simple model: The O-surface bonding determines the reactivity on surfaces; it also determines whether the atomic or molecular mechanism is preferred. The reactivity on metal oxides is further found to be related to the 3rd ionization energy of the metal atom.

Domains in Ferroelectric Nanodots

Almost free-standing single crystal mesoscale and nanoscale dots of ferroelectric BaTiO3 have been made by direct focused ion beam patterning of bulk single crystal material. The domain structures which appear in these single crystal dots, after cooling through the Curie temperature, were observed to form into quadrants, with each quadrant consisting of fine 90° stripe domains. The reason that these rather complex domain configurations form is uncertain, but we consider and discuss three possibilities for their genesis: first, that the quadrant features initially form to facilitate field-closure, but then develop 90° shape compensating stripe domains in order to accommodate disclination stresses; second, that they are the result of the impingement of domain packets which nucleate at the sidewalls of the dots forming “Forsbergh” patterns (essentially the result of phase transition kinetics); and third, that 90° domains form to conserve the shape of the nanodot as it is cooled through the Curie temperature but arrange into quadrant packets in order to minimize the energy associated with uncompensated surface charges (thus representing an equilibrium state). While the third model is the preferred one, we note that the second and third models are not mutually exclusive.

A self-structured adaptive decision feedback equalizer

In a decision feedback equalizer (DFE), the structural parameters, including the decision delay, the feedforward filter (FFF), and feedback filter (FBF) lengths, must be carefully chosen, as they greatly influence the performance. Although the FBF length can be set as the channel memory, there is no closed-form expression for the FFF length and decision delay. In this letter, first we analytically show that the two-dimensional search for the optimum FFF length and decision delay can be simplified to a one-dimensional search and then describe a new adaptive DFE where the optimum structural parameters can he self-adapted.

Copying letters to patients with cystic fibrosis (CF): Letter content and patient perceptions of benefit

Background: Copying letters involves generating an extra copy of all correspondence between healthcare professionals about the patient, to the patient.

Assessing the Transaction Costs of Firms in the EU ETS: Lessons form Ireland

Until now, there has been little empirical evidence that EU Emissions Trading Scheme (ETS) transaction costs are incurred at firm level. The transaction costs (internal costs, capital costs, consultancy and trading costs) incurred by Irish firms under the EU ETS during its pilot phase (2005-2007) were measured and analysed. Evidence for the sources of transaction costs, their magnitude and the distribution of costs shows that these were mainly administrative in nature. Considerable variation in costs was found due to economies of scale, as the costs per tonne of CO2 were lower for participants with larger allocations. For the largest firms - accounting for over half the emissions - average transaction costs were €0.05 per tonne. However, for small firms, average transaction costs were €2.02 - over 18% of the current allowance price. This supports the concerns that transaction costs are excessive for smaller participants. The immediate policy implication is that additional attention will be needed to address different sizes of firms, number of installations per firm, and the size of the initial allocations.

Dublin docklands. The urban fabric as cultural heritage

Introduction

Since the 1980s there have been major policies and projects for the redevelopment of Dublin Docklands. These projects were mainly aimed at profitable development of office, commercial and residential space, without a sound plan that would preserve the identity or community of the area. The recent shift in policies and urban design principles in the Dublin Docklands Area Master Plan 2008 shows that policy makers have acknowledged that mistakes were made in the last decades of the 20th century. The current map of the Dublin Docklands Area Master Plan 2008 gives us useful information about these changes. The Ringsend/ Irishtown area, which has kept a great part of its urban form and community identity throughout centuries, is described as an ‘area of protection of residential and services amenities’ (DDDA, 2008, map A). Meanwhile, the area of the Grand Canal Docks, recently developed, is described with the objective ‘to seek the social, economic and physical development or rejuvenation
within an area of mixed use of which residential and enterprise facilities would be the predominant uses’ (DDDA, 2008, map A). This classification shows that recent development has been unable to achieve the cohesion and complexity of existing neighbourhoods, revealing flaws not only in policy, but also in the built environment and approaches to urban design.

The shift towards the consideration of more community participation reveals a need to understand the tradition and past of these communities, while the urban fabric of small plots in the existing neighbourhoods, therefore, seems to have a very important role in the conservation of identity of place and providing the opportunity for difference within regularity. On the other hand, the new fabric of residential block developments in the docklands denies the possibility of developing a sense of community, and by providing only regularity, does not leave space for difference.

This paper will address questions related to urban morphology and town analysis in the case of Ringsend and Irishtown. This will provide a tool to learn from the past and perhaps find new models of development that might be less detrimental for the heritage of cities and urban communities. One of the ideas of this paper is to adhere to the new tendency in conservation policies to provide a broader analysis of urban areas, not only considering individual monuments in cities, but also analysing the significance of urban morphology and intangible heritage. It forms part of an OPW Post- Doctoral Fellowship in Conservation Studies and Environmental History.1 Research has been carried out in different areas of urban history of Dublin’s southern waterfront, including infrastructure history and a thorough analysis of the letters of the Pembroke Estate of the 19th century, which included the areas of Ringsend and Irishtown. However, this paper focuses on the study of urban form of the area and its significance to Dublin’s heritage.

Domain Bundle Boundaries in Single Crystal BaTiO3 Lamellae: Searching for Naturally Forming Dipole Flux-Closure / Quadrupole Chains

Naturally occurring boundaries between bundles of 90o stripe domains, which form in BaTiO3 lamellae on cooling through the Curie Temperature, have been characterised using both piezoresponse force microscopy (PFM) and scanning transmission electron microscopy (STEM). Detailed interpretation of the dipole configurations present at these boundaries (using data taken from PFM) shows that, in the vast majority of cases, they are composed of simple zigzag 180° domain walls. Topological information from STEM shows that, occasionally, domain bundle boundaries can support chains of dipole flux closure and quadrupole nanostructures, but these kinds of boundaries are comparatively rare; when such chains do exist, it is notable that singularities at the cores of the dipole structures are avoided. The symmetry of the boundary shows that diads and centres of inversion exist at positions where core singularities should have been expected.

A study of Heck cyclization reactions to form phenanthridine ring systems

A survey of conditions for the palladium catalyzed intramol. Heck cyclization of protected amines has shown that the Herrmann-Beller palladacycle can be exploited under 'cationic' conditions to provide a robust and rapid route (