Microstructural evolution and mechanical properties of short-term thermally exposed 9/12Cr heat-resistant steels

The microstructural evolution during short-term (up to 3000 hours) thermal exposure of three 9/12Cr heat-resistant steels was studied, as well as the mechanical properties after exposure. The tempered martensitic lath structure, as well as the precipitation of carbide and MX type carbonitrides in the steel matrix, was stable after 3000 hours of exposure at 873 K (600 °C). A microstructure observation showed that during the short-term thermal exposure process, the change of mechanical properties was caused mainly by the formation and growth of Laves-phase precipitates in the steels. On thermal exposure, with an increase of cobalt and tungsten contents, cobalt could promote the segregation of tungsten along the martensite lath to form Laves phase, and a large size and high density of Laves-phase precipitates along the grain boundaries could lead to the brittle intergranular fracture of the steels.

I/Q imbalance in AF dual-hop relaying: Performance analysis in Nakagami-m fading

We analyze the performance of amplify-and-forward dual-hop relaying systems in the presence of in-phase and quadrature-phase imbalance (IQI) at the relay node. In particular, an exact analytical expression for and tight lower bounds on the outage probability are derived over independent, non-identically distributed Nakagami-m fading channels. Moreover, tractable upper and lower bounds on the ergodic capacity are presented at arbitrary signal-to-noise ratios (SNRs). Some special cases of practical interest (e.g., Rayleigh and Nakagami-0.5 fading) are also studied. An asymptotic analysis is performed in the high SNR regime, where we observe that IQI results in a ceiling effect on the signal-to-interference-plus-noise ratio (SINR), which depends only on the level of I/Q impairments, i.e., the joint image rejection ratio. Finally, the optimal I/Q amplitude and phase mismatch parameters are provided for maximizing the SINR ceiling, thus improving the system performance. An interesting observation is that, under a fixed total phase mismatch constraint, it is optimal to have the same level of transmitter (TX) and receiver (RX) phase mismatch at the relay node, while the optimal values for the TX and RX amplitude mismatch should be inversely proportional to each other.