Development of a rapid low cost fluorescent biosensor for the detection of food contaminants

A prototype fluorescent based biosensor has been developed for the antibody based detection of food related contaminants. Its performance was characterised and showed a typical antibody binding signal of 200-2000 mV, a short term noise of 9.1 mV, and baseline slope of -0.016 mV/s over 4 h. Bulk signal detection repeatability (n=23) and reproducibility (n=3) were less than 2.4%CV. The biosensor detection unit was evaluated using two food related model systems proving its ability to monitor both binding using commercial products and inhibition through the development of an assay. This assay development potential was evaluated by observing the biosensor's performance whilst appraising several labelled antibody and glass slide configurations. The molecular interaction between biotin and an anti-biotin antibody was shown to be inhibited by 41% due to the presence of biotin in a sample. A food toxin (domoic acid) calibration curve was produced, with %CVs ranging from 2.7 to 7.8%, and a midpoint of approximately 17 ng/ml with further optimisation possible. The ultimate aim of this study was to demonstrate the working principles of this innovative biosensor as a potential portable tool with the opportunity of interchangeable assays. The biosensor design is applicable for the requirements of routine food contaminant analysis, with respect to performance, functionality and cost. (C) 2012 Elsevier B.V. All rights reserved.

Downstream changes in the transport and storage of sediment-associated contaminants (P, Cr and PCBs) in agricultural and industrialized drainage basins

Samples of suspended, floodplain and channel bed sediment have been used to examine downstream changes in ediment-associated contaminant transport and storage in contrasting rivers in Yorkshire, UK. The concentrations of hosphorus, chromium and selected PCBs associated with sediment in the River Aire and its main tributary, the River Calder, which drain an urbanized and industrialized catchment, are considerably higher than those in the relatively unpolluted River Swale, which drains an agricultural catchment. Concentrations of sediment-associated contaminants in the Aire/Calder system increase downstream, reflecting the location of urban and industrial areas in the middle and lower reaches, and the location of point source inputs, such as sewage treatment works. The ontaminant concentrations associated with floodplain and channel bed sediment in the Rivers Aire and Calder are high, particularly in the lower reaches. This, combined with measurements of sediment storage on the floodplain and channel bed, indicate that significant storage of sediment-associated contaminants occurs in the Rivers Aire and Calder.

An evaluation of the capability of a biolayer interferometry biosensor to detect low-molecular-weight food contaminants

The safety of our food is an essential requirement of society. One well-recognised threat is that of chemical contamination of our food, where low-molecular-weight compounds such as biotoxins, drug residues and pesticides are present. Low-cost, rapid screening procedures are sought to discriminate the suspect samples from the population, thus selecting only these to be forwarded for confirmatory analysis. Many biosensor assays have been developed as screening tools in food contaminant analysis, but these tend to be electrochemical, fluorescence or surface plasmon resonance based. An alternative approach is the use of biolayer interferometry, which has become established in drug discovery and life science studies but is only now emerging as a potential tool in the analysis of food contaminants. A biolayer interferometry biosensor was assessed using domoic acid as a model compound. Instrument repeatability was tested by simultaneously producing six calibration curves showing replicate repeatability (n = 2) ranging from 0.1 to 6.5 % CV with individual concentration measurements (n = 12) ranging from 4.3 to 9.3 % CV, giving a calibration curve midpoint of 7.5 ng/ml (2.3 % CV (n = 6)). Reproducibility was assessed by producing three calibration curves on different days, giving a midpoint of 7.5 ng/ml (3.4 %CV (n = 3)). It was further shown, using assay development techniques, that the calibration curve midpoint could be adjusted from 10.4 to 1.9 ng/ml by varying assay parameters before the simultaneous construction of three calibration curves in matrix and buffer. Sensitivity of the assay compared favourably with previously published biosensor data for domoic acid. © 2013 Springer-Verlag Berlin Heidelberg.

Detection of Low-Concentration Contaminants in Solution by Exploiting Chemical Derivatization in Surface-Enhanced Raman Spectroscopy

Contaminants in surface water and sediments around the Tynagh Mine, Galway, Ireland.

A former silver mine in Tynagh, Co. Galway, Ireland is one of the most contaminated mine sites in Europe with maximum concentrations of Zn, As, Pb, Mn, Ni, Cu, and Cd far exceeding guideline values for water and sediment. The aims of this research were to 1) further assess the contamination, particularly metals, in surface water and sediment around the site, and 2) determine if the contamination has increased 10 years after the Environmental Protection Agency Ireland (EPAI) identified off-site contamination. Site pH is alkaline to neutral because CaCO3-rich sediment and rock material buffer the exposed acid generating sulphide-rich ore. When this study was compared to the previous EPAI study conducted 10 years earlier, it appeared that further weathering of exposed surface sediment had increased concentrations of As and other potentially toxic elements. Water samples from the tailings ponds and adjacent Barnacullia Stream had concentrations of Al, Cd, Mn, Zn and Pb above guideline values. Lead and Zn concentrations from the tailings pond sediment were 16 and 5 times higher, respectively, than concentrations reported 10 years earlier. Pb and Zn levels in most sediment samples exceeded the Expert Group (EGS) guidelines of 1000 and 5000 mg/kg, respectively. Arsenic concentrations were as high as 6238 mg/kg in the tailings ponds sediment, which is 62 and 862 times greater than the EGS and Canadian Soil Quality Guidelines (CSQG), respectively. Cadmium, Cu, Fe, Mn, Pb and Zn concentrations in water and sediment were above guideline values downstream of the site. Additionally, Fe, Mn and organic matter (OM) were strongly correlated and correlated to Zn, Pb, As, Cd, Cu and Ni in stream sediment. Therefore, the nearby Barnacullia Stream is also a significant pathway for contaminant transport to downstream areas. Further rehabilitation of the site may decrease the contamination around the area.

Endocrine disruptor activity of multiple environmental food chain contaminants

Industrial chemicals, antimicrobials, drugs and personal care products have been reported as global pollutants which enter the food chain. Some of them have also been classified as endocrine disruptors based on results of various studies employing a number of in vitro/. vivo tests. The present study employed a mammalian reporter gene assay to assess the effects of known and emerging contaminants on estrogen nuclear receptor transactivation.Out of fifty-nine compounds assessed, estrogen receptor agonistic activity was observed for parabens (. n= 3), UV filters (. n= 6), phthalates (. n= 4) and a metabolite, pyrethroids (. n= 9) and their metabolites (. n= 3). Two compounds were estrogen receptor antagonists while some of the agonists enhanced 17β-estradiol mediated response.This study reports five new compounds (pyrethroids and their metabolites) possessing estrogen agonist activity and highlights for the first time that pyrethroid metabolites are of particular concern showing much greater estrogenic activity than their parent compounds.

High content analysis: A sensitive tool to detect and quantify the cytotoxic, synergistic and antagonistic effects of chemical contaminants in foods

Aflatoxin B1 (AFB1), ochratoxin A (OTA) and fumonisin B1 (FB1) are important mycotoxins in terms of
human exposure via food, their toxicity and regulatory limits that exist worldwide. Mixtures of toxins can frequently be present in foods, however due to the complications of determining their combined toxicity,
legal limits of exposure are determined for single compounds, based on long standing toxicological
techniques. High content analysis (HCA) may be a useful tool to determine total toxicity of complex
mixtures of mycotoxins. Endpoints including cell number (CN), nuclear intensity (NI), nuclear area (NA),
plasma membrane permeability (PMP), mitochondrial membrane potential (MMP) and mitochondrial
mass (MM) were compared to the conventional 3-(4,5-dimethylthiazol-2-yl)-2,5 diphenyltetrazolium
bromide (MTT) and neutral red (NR) endpoints in MDBK cells. Individual concentrations of each
mycotoxin (OTA 3mg/ml, FB1 8mg/ml and AFB11.28mg/ml) revealed no cytotoxicity with MTTor NR but
HCA showed significant cytotoxic effects up to 41.6% (p0.001) and 10.1% (p0.05) for OTA and AFB1,
respectively. The tertiary mixture (OTA 3mg/ml, FB1 8mg/ml and AFB1 1.28mg/ml) detected up to 37.3%
and 49.8% more cytotoxicity using HCA over MTT and NR, respectively. Whilst binary combinations of
OTA (3mg/ml) and FB1 (8mg/ml) revealed synergistic interactions using HCA (MMP, MM, NI endpoints)
not detected using MTT or NR. HCA is a highly novel and sensitive tool that could substantially help
determine future regulatory limits, for single and combined toxins present in food, ensuring legislation is based on true risks to human health exposure.

A review of the global pesticide legislation and the scale of challenge in reaching the global harmonization of food safety standards

Pesticide use is important in agriculture to protect crops and improve productivity. However, they have the potential to cause adverse human health or environmental effects, dependent on exposure levels. This review examines existing pesticide legislation worldwide, focusing on the level of harmonisation, and impacts of differing legislation on food safety and trade. Pesticide legislation varies greatly worldwide as countries have different requirements guidelines and legal limits for plant protection. Developed nations have more stringent regulations than developing countries, which lack the resources and expertise to adequately implement and enforce legislation. Global differences in pesticide legislation act as a technical barrier to trade. International parties such as the European Union (EU), Codex Alimentarius Commission (Codex), and North American Free Trade Agreement (NAFTA) have attempted to harmonise pesticide legislation by providing maximum residue limits (MRLs), but globally these limits remain variable. Globally harmonised pesticide standards would serve to increase productivity, profits and trade, and enhance the ability to protect public health and the environment.