Thermal conductivity measurement of liquids in a microfluidic device

A new microfluidic-based approach to measuring liquid thermal conductivity is developed to address the requirement in many practical applications for measurements using small (microlitre) sample size and integration into a compact device. The approach also gives the possibility of high-throughput testing. A resistance heater and temperature sensor are incorporated into a glass microfluidic chip to allow transmission and detection of a planar thermal wave crossing a thin layer of the sample. The device is designed so that heat transfer is locally one-dimensional during a short initial time period. This allows the detected temperature transient to be separated into two distinct components: a short-time, purely one-dimensional part from which sample thermal conductivity can be determined and a remaining long-time part containing the effects of three-dimensionality and of the finite size of surrounding thermal reservoirs. Identification of the one-dimensional component yields a steady temperature difference from which sample thermal conductivity can be determined. Calibration is required to give correct representation of changing heater resistance, system layer thicknesses and solid material thermal conductivities with temperature. In this preliminary study, methanol/water mixtures are measured at atmospheric pressure over the temperature range 30-50A degrees C. The results show that the device has produced a measurement accuracy of within 2.5% over the range of thermal conductivity and temperature of the tests. A relation between measurement uncertainty and the geometric and thermal properties of the system is derived and this is used to identify ways that error could be further reduced.

Dynamics of the Indonesian seas circulation. Part II – The role of pressure head

The aim of this paper is to analyze the role of the pressure head, i.e., the difference of total pressure forces acting on the Indonesian seas waters from the western Pacific and the eastern Indian Ocean, in driving the Indonesian Throughflow (ITF) and in determining the total transport of the ITF. These questions have been discussed in the literature but no consensus has been reached. A regional model of the Indonesian seas circulation has been developed that properly resolves all major topographic features in the region. The results of model runs have been used to calculate all components of the overall momentum balance. The estimates disclose that the dynamical balance is primarily between the volume integrated Coriolis acceleration, pressure gradient and the area integral of local wind stress. It is shown that consideration of components of momentum balance in the direction of the outflow through the Indian Ocean port leads to the formulation of a diagnostic relation between total inflow transports due to the Mindanao and New Guinea Coastal Currents and the external pressure head, internal pressure head, bottom form stress, and area integrated wind stress. Based on this relation, it is concluded that the external pressure head is not the major driving force of the ITF, which is why there is no unique relation between the total transport of the ITF and the external pressure head. However, Wyrtki's suggestion to monitor the variability of the total transport of the ITF by measurement of the sea-surface-height difference between the western Pacific and the eastern Indian Ocean is validated.

Hormone therapy and intraocular pressure in nonglaucomatous eyes

Objective: The influence of sex hormones on intraocular pressure (IOP) has been the focus of recent debate. Previous studies investigating the effects of hormone therapy (HT) on IOP in postmenopausal women have produced conflicting results but have been limited by small numbers of participants. The aim of our study was to compare IOP in women without glaucoma taking HT with those not taking HT. Methods: A prospective cross-sectional study of postmenopausal women visiting a single ophthalmic medical practitioner was conducted. All women with a history of intraocular disease, a family history of glaucoma, or refractive error exceeding ±5 diopters were excluded. Applanation tonometry was used to measure IOP, and participants were then asked if they were current HT users. Results: A total of 263 participants were recruited, of whom 91 reported current use of HT; 172 had never used HT. Within the HT group, 33 were taking an estrogen-therapy and 58 were taking a estrogen-progesterone therapy. Mean IOP in the HT group was significantly lower than that in the non-HT group; the mean difference was 1.41 mm Hg (P <0.001). This difference remained statistically significant after statistical correction for age, use of systemic ß-blockers, and time of IOP measurement. There was no significant difference in mean IOP between women taking combined versus those taking estrogen-only preparations. Conclusions: Our study showed that IOP was significantly lower in women taking HT than in those who had never taken HT, even after removing other possible influences on IOP. The IOP-lowering effect of HT deserves further investigation to explore whether it may represent a possible new therapeutic modality for glaucoma. © 2010 by The North American Menopause Society.

Effect of sublingual application of cannabinoids on intraocular pressure:A pilot study

PURPOSE: The purpose of this study was to assess the effect on intraocular pressure (IOP) and the safety and tolerability of oromucosal administration of a low dose of delta-9-tetrahydrocannabinol (?-9-THC) and cannabidiol (CBD). PATIENTS AND METHODS: A randomized, double-masked, placebo-controlled, 4 way crossover study was conducted at a single center, using cannabis-based medicinal extract of ?-9-THC and CBD. Six patients with ocular hypertension or early primary open angle glaucoma received a single sublingual dose at 8 AM of 5 mg ?-9-THC, 20 mg CBD, 40 mg CBD, or placebo. Main outcome measure was IOP. Secondary outcomes included visual acuity, vital signs, and psychotropic effects. RESULTS: Two hours after sublingual administration of 5 mg ?-9-THC, the IOP was significantly lower than after placebo (23.5 mm Hg vs. 27.3 mm Hg, P=0.026). The IOP returned to baseline level after the 4-hour IOP measurement. CBD administration did not reduce the IOP at any time. However, the higher dose of CBD (40 mg) produced a transient elevation of IOP at 4 hours after administration, from 23.2 to 25.9 mm Hg (P=0.028). Vital signs and visual acuity were not significantly changed. One patient experienced a transient and mild paniclike reaction after ?-9-THC administration. CONCLUSIONS: A single 5 mg sublingual dose of ?-9-THC reduced the IOP temporarily and was well tolerated by most patients. Sublingual administration of 20 mg CBD did not reduce IOP, whereas 40 mg CBD produced a transient increase IOP rise. Copyright © 2006 by Lippincott Williams & Wilkins.

High pressure CO2 absorption studies on imidazolium-based ionic liquids:Experimental and simulation approaches

A combined experimental-computational study on the CO absorption on 1-butyl-3-methylimidazolium hexafluophosphate, 1-ethyl-3-methylimidazolium bis[trifluoromethylsulfonyl]imide, and 1-butyl-3-methylimidazolium bis[trifluoromethylsulfonyl]imide ionic liquids is reported. The reported results allowed to infer a detailed nanoscopic vision of the absorption phenomena as a function of pressure and temperature. Absorption isotherms were measured at 318 and 338K for pressures up to 20MPa for ultrapure samples using a state-of-the-art magnetic suspension densimeter, for which measurement procedures are developed. A remarkable swelling effect upon CO absorption was observed for pressures higher than 10MPa, which was corrected using a method based on experimental volumetric data. The experimental data reported in this work are in good agreement with available literature isotherms. Soave-Redlich-Kwong and Peng-Robinson equations of state coupled with bi-parametric van der Waals mixing rule were used for successful correlations of experimental high pressure absorption data. Molecular dynamics results allowed to infer structural, energetic and dynamic properties of the studied CO+ionic liquids mixed fluids, showing the relevant role of the strength of anion-cation interactions on fluid volumetric properties and CO absorption. © 2012 Elsevier B.V.

Automated detection and measurement of isolated retinal arterioles by a combination of edge enhancement and cost analysis

Pressure myography studies have played a crucial role in our understanding of vascular physiology and pathophysiology. Such studies depend upon the reliable measurement of changes in the diameter of isolated vessel segments over time. Although several software packages are available to carry out such measurements on small arteries and veins, no such software exists to study smaller vessels (<50 µm in diameter). We provide here a new, freely available open-source algorithm, MyoTracker, to measure and track changes in the diameter of small isolated retinal arterioles. The program has been developed as an ImageJ plug-in and uses a combination of cost analysis and edge enhancement to detect the vessel walls. In tests performed on a dataset of 102 images, automatic measurements were found to be comparable to those of manual ones. The program was also able to track both fast and slow constrictions and dilations during intraluminal pressure changes and following application of several drugs. Variability in automated measurements during analysis of videos and processing times were also investigated and are reported. MyoTracker is a new software to assist during pressure myography experiments on small isolated retinal arterioles. It provides fast and accurate measurements with low levels of noise and works with both individual images and videos. Although the program was developed to work with small arterioles, it is also capable of tracking the walls of other types of microvessels, including venules and capillaries. It also works well with larger arteries, and therefore may provide an alternative to other packages developed for larger vessels when its features are considered advantageous.

Real time measurement and control of viscosity for extrusion processes using recycled materials

The aim of this paper is to develop a new generation of extruder control system for recycled materials which has ability to automatically maintain constant a polymer melt viscosity of mixed recycled polymers during extrusion, regardless of variations in the Melt Flow Index (MFI) of recycled mixed grade high density polyethylene (HDPE) feedstock. The variations in MFI are due to differences in the source of the recycled material used. The work describes how melt viscosity for specific extruder/die system is calculated in real time using the rheological properties of the materials, the pressure drop through the extruder die and the actual throughput measurements using a gravimetric loss-in-weight hopper feeder. A closed-loop controller is also developed to automatically regulate screw speed and barrel temperature profile to achieve constant viscosity and enable consistent processing of variable grade recycled HDPE materials. Such a system will improve processability of mixed MFI polymers may also reduce the risk of polymer melt degradation, reduce producing large volumes of scrap/waste and lead to improvement in product quality. The experimental results of real time viscosity measurement and control using a 38 mm single screw extruder with different recycled HDPEs with widely different MFIs are reported in this work.

Limitations of a measurement-assisted optomechanical route to quantum macroscopicity of superposition states

Optomechanics is currently believed to provide a promising route towards the achievement of genuine quantum effects at the large, massive-system scale. By using a recently proposed figure of merit that is well suited to address continuous-variable systems, in this paper we analyze the requirements needed for the state of a mechanical mode (embodied by an end-cavity cantilever or a membrane placed within an optical cavity) to be qualified as macroscopic. We show that, according to the phase space-based criterion that we have chosen for our quantitative analysis, the state achieved through strong single-photon radiation-pressure coupling to a quantized field of light and conditioned by measurements operated on the latter might be interpreted as macroscopically quantum. In general, though, genuine macroscopic quantum superpositions appear to be possible only under quite demanding experimental conditions