Absolute Calibration of Atomic Density Measurements by Laser-Induced Fluorescence Spectroscopy with Two-Photon Excitation (TALIF)

The two-photon resonances of atomic hydrogen (? = 2 × 205.1 nm), atomic nitrogen (? = 2 × 206.6 nm) and atomic oxygen (? = 2 × 225.6 nm) are investigated together with two selected transitions in krypton (? = 2×204.2 nm) and xenon (? = 2×225.5 nm). The natural lifetimes of the excited states, quenching coefficients for the most important collisions partners, and the relevant ratios of the two-photon excitation cross sections are measured. These data can be applied to provide a calibration for two-photon laser-induced fluorescence measurements based on comparisons with spectrally neighbouring noble gas resonances.

Measurement of Quenching Coefficients and Developement of Calibration Methods for Quantitative Spectroscopy of Plasma at Elevated Pressures

Measurements of collisional de-excitation (quenching) coefficients required for the interpretation of emission and fluorescence spectroscopic measurements are reported. Particular attention is turned on argon transitions which are of interest for actinometric determinations of atomic ground state populations and on fluorescence lines originating from excited atoms and noble gases in connection with two-photon excitation (TALIF) of atomic radicals. A novel method is described which allows to infer quenching coefficients for collisions with molecular hydrogen of noble gas states in the energy range up to 24 eV. The excitation is performed in these experiments by collisions of energetic electrons in the sheath of an RF excited hydrogen plasma during the field reversal phase which lasts about 10 ns. We describe in addition a calibration method - including quenching effects - for the determination by TALIF of absolute atomic radical densities of hydrogen, nitrogen and oxygen using two-photon resonances in noble gases close by the resonances of the species mentioned. The paper closes with first ideas on a novel technique to bypass quenching effects in TALIF by introducing an additional, controllable loss by photoionization that will allow quenching-free determination of absolute atomic densities with prevalent nanosecond laser systems in situations where collisional de-excitation dominates over spontaneous emission.

In situ cross-calibration of in-fibre Bragg Grating and Electrical Resistance Strain Gauges for structural monitoring using an extensometer

Special issue on Sensor Systems for Structural Health Monitoring Abstract—This study addresses the direct calibration of optical fiber strain sensors used for structural monitoring and is carried out in situ. The behavior of fiber-Bragg-grating-based sensor systems when attached to metal bars, in a manner representative of their use as reinforcement bars in structures, was examined and their response calibrated. To ensure the validity of the measurements,this was done using an extensometer with a further calibrationagainst the response of electrical resistance strain gauges, often conventionally used, for comparison. The results show a repeatable calibration generating a suitable geometric factor of extension to strain for these sensors, to enable accurate strain data to be obtained when the fiber-optic sensor system is in use in structural monitoring applications.

High precision C-14 dating of Holocene peat deposits: A comparison of Bayesian calibration and wiggle-matching approaches

The chronologies of five northern European ombrotrophic peat bogs subjected to a large ANIS C-14 dating effort (32-44 dates/site) are presented here. The results of Bayesian calibration (BCal) of dates with a prior assumption of chronological ordering were compared with a Bayesian wiggle-match approach (Bpeat) which assumes constant linear accumulation over sections of the peat profile. Interpolation of BCal age estimates of dense sequences of C-14 dates showed variable patterns of peat accumulation with time, with changes in accumulation occurring at intervals ranging from 20 to 50 cm. Within these intervals, peat accumulation appeared to be relatively linear. Close analysis suggests that some of the inferred variations in accumulation rate were related to the plant macrofossil composition of the peat. The wiggle-matched age-depth models had relatively high chronological uncertainty within intervals of closely spaced 14 C dates, suggesting that the premise of constant linear accumulation over large sections of the peat profile is unrealistic. Age models based on the assumption of linear accumulation over large parts of a peat core (and therefore only effective over millennial timescales), are not compatible with studies examining environmental change during the Holocene, where variability often occurs at decadal to centennial time-scales. Ideally, future wiggle-match age models should be constrained, with boundaries between sections based on the plant macrofossil composition of the peat and physical-chemical parameters such as the degree of decomposition. Strategies for the selection of material for dating should be designed so that there should be enough C-14 dates to accurately reconstruct the peat accumulation rate of each homogeneous stratigraphic unit. (c) 2006 Elsevier Ltd. All rights reserved.

IntCal09 and Marine09 radiocarbon age calibration curves, 0 - 50,000 years cal BP

The IntCal04 and Marine04 radiocarbon calibration curves have been updated from 12 cal kBP (cal kBP is here defined as thousands of calibrated years before AD 1950), and extended to 50 cal kBP, utilizing newly available data sets that meet the IntCal Working Group criteria for pristine corals and other carbonates and for quantification of uncertainty in both the ¹⁴C and calendar timescales as established in 2002. No change was made to the curves from 0-12 cal kBP. The curves were constructed using a Markov chain Monte Carlo (MCMC) implementation of the random walk model used for IntCal04 and Marine04. The new curves were ratified at the 20th International Radiocarbon Conference in June 2009 and are available in the Supplemental Material at www.radiocarbon.org.

Investigating the Interhemisphere 14C Offset in the 1st Millennium AD and Assessment of Laboratory Bias and Calibration Errors

Past measurements of the radiocarbon interhemispheric offset have been restricted to relatively young samples because of a lack of older dendrochronologically secure Southern Hemisphere tree-ring chronologies. The Southern Hemisphere calibration data set SHCal04 earlier than AD 950 utilizes a variable interhemispheric offset derived from measured 2nd millennium AD Southern Hemisphere/Northern Hemisphere sample pairs with the assumption of stable Holocene ocean/ atmosphere interactions. This study extends the range of measured interhemispheric offset values with 20 decadal New Zealand kauri and Irish oak sample pairs from 3 selected time intervals in the 1st millennium AD and is part of a larger program to obtain high-precision Southern Hemisphere 14C data continuously back to 200 BC. We found an average interhemispheric offset of 35 ± 6 yr, which although consistent with previously published 2nd millennium AD measurements, is lower than the offset of 55–58 yr utilized in SHCal04. We concur with McCormac et al. (2008) that the IntCal04 measurement for AD 775 may indeed be slightly too old but also suggest the McCormac results appear excessively young for the interval AD 755–785. In addition, we raise the issue of laboratory bias and calibration errors, and encourage all laboratories to check their consistency with appropriate calibration curves and invest more effort into improving the accuracy of those curves.

Extended Radiocarbon Calibration in the Anglo-Saxon Period, AD395-485 and AD735-805

Radiocarbon dating has been used infrequently as a chronological tool for research in Anglo-Saxon archaeology. Primarily, this is because the uncertainty of calibrated dates provides little advantage over traditional archaeological dating in this period. Recent advances in Bayesian methodology in conjunction with high-precision 14C dating have, however, created the possibility of both testing and refining the established Anglo-Saxon chronologies based on typology of artifacts. The calibration process within such a confined age range, however, relies heavily on the structural accuracy of the calibration curve. We have previously reported decadal measurements on a section of the Irish oak chronology for the period AD 495–725 (McCormac et al. 2004). In this paper, we present decadal measurements for the periods AD 395–485 and AD 735–805,which extends the original calibration set.

Determination of absolute ion yields from a MALDI source through calibration of an image-charge detector

MALDI (matrix-assisted laser desorption/ionization) is one of the most important techniques used to produce large biomolecular ions in the gas phase. Surprisingly, the exact ionization mechanism is still not well understood and absolute values for the ion yields are scarce. This is in part due to the unknown efficiencies of typical detectors, especially for heavy biomolecular ions. As an alternative, charged particles can be non-destructively detected using an image-charge detector where the output voltage signal is proportional to the total charge within the device. In this paper, we report an absolute calibration which provides the voltage output per detected electronic charge in our experimental arrangement. A minimum of 3 x 10(3) ions were required to distinguish the signal above background noise in a single pass through the device, which could be further reduced using filtering techniques. The calibration results have been applied to raw MALDI spectra to measure absolute ion yields of both matrix and analyte ions.