The effect of nozzle geometry on the flow characteristics of small water jets

A wide variety of processes make use of plain orifice nozzles. Fuel injectors for internal combustion engines incorporate these nozzles to generate finely atomized sprays. Processes such as jet cutting, jet cleaning, and hydroentanglement, on the other hand, use similar nozzles, but require coherent jets. The spray or jet characteristics depend on the stability of the flow emerging from the orifice. This problem has been extensively researched for nozzles with diameters above 300 μm. Much less is known about the characteristics of jets produced by nozzles with smaller diameters, where viscous effects and small geometric variations due to manufacturing tolerances are likely to play an increasing role. Results are presented of a wide-ranging investigation of geometry effects on the flow parameters and jet characteristics of nozzles with diameters between 120 and 170 μm. Nozzles with circular cross-section and conical, cone-capillary and capillary axial designs were investigated. For conical and cone-capillary nozzles, the effect of cone angle and effects due to interactions between adjacent nozzles in the multi-hole cone-capillary nozzles were studied. For capillary nozzles, the effects of diameter variations and inlet edge roundness for capillary nozzles were considered. Furthermore, the effect of varying the aspect ratio (ratio of major and minor axes) of elliptical nozzles was studied. Flowrate and jet impact force measurements were carried out to determine the discharge coefficient C, velocity coefficient C, and contraction coefficient C of the nozzles for supply pressures between 3 and 12 MPa. Visualizations of the jet flow were carried out in the vicinity of the nozzle exit in order to identify near-nozzle flow regimes and to study jet coherence. The relationship between nozzle geometry, discharge characteristics, and jet coherence is examined. © IMechE 2006.

Optimising element choice for nanoparticle radiosensitisers

There is considerable interest in the use of heavy atom nanoparticles as theranostic contrast agents due to their high radiation cross-section compared to soft tissue. However, published studies have primarily focused on applications of gold nanoparticles. This study applies Monte Carlo radiation transport modelling using Geant4 to evaluate the macro- and micro-scale radiation dose enhancement following X-ray irradiation with both imaging and therapeutic energies on nanoparticles consisting of stable elements heavier than silicon. An approach based on the Local Effect Model was also used to assess potential biological impacts. While macroscopic dose enhancement is well predicted by simple absorption cross-sections, nanoscale dose deposition has a much more complex dependency on atomic number, with local maxima around germanium (Z = 32) and gadolinium (Z = 64), driven by variations in secondary Auger electron spectra, which translate into significant variations in biological effectiveness. These differences may provide a valuable tool for predicting and elucidating fundamental mechanisms of these agents as they move towards clinical application.

An R-matrix approach for plasma modelling and the interpretation of astrophysical observation

Over the last decade an Auburn-Rollins-Strathclyde consortium has developed several suites of parallel R-matrix codes [1, 2, 3] that can meet the fundamental data needs required for the interpretation of astrophysical observation and/or plasma experiments. Traditionally our collisional work on light fusion-related atoms has been focused towards spectroscopy and impurity transport for magnetically confined fusion devices. Our approach has been to provide a comprehensive data set for the excitation/ionization for every ion stage of a particular element. As we progress towards a burning fusion plasma, there is a demand for the collisional processes involving tungsten, which has required a revitalization of the relativistic R-matrix approach. The implementation of these codes on massively parallel supercomputers has facilitated the progression to models involving thousands of levels in the close-coupling expansion required by the open d and f sub-shell systems of mid Z tungsten. This work also complements the electron-impact excitation of Fe-Peak elements required by astrophysics, in particular the near neutral species, which offer similar atomic structure challenges. Although electron-impact excitation work is our primary focus in terms of fusion application, the single photon photoionisation codes are also being developed in tandem, and benefit greatly from this ongoing work.

Photoionization cross-sections for Fe II

The LS R-matrix method was used to compute new photoionization cross sections for Fe II. Results are compared with available experimental data and with previous calculations of the cross section. We also present the first fine-structure photoionization data for this ion obtained with the fully-relativistic DARC codes.

Collisional-radiative study of lithium plasmas

The sensitivity of lithium plasma models to the underlying atomic data is investigated. Collisional-radiative modeling is carried out with both the Los Alamos and ADAS suite of codes. The effects of plane-wave Born, distorted-wave, and nonperturbative R -matrix with pseudostates and time-dependent close-coupling electron impact atomic data on derived plasma quantities such as the ionization balance and radiated power are studied. Density and temperature regimes are identified where nonperturbative excitation and ionization rate coefficients must be used. The electron temperature and density ranges investigated were 0.2 eV<or = T(e) <or =90 eV and 10(10) cm(-3) <or = N(e) <or = 10(14) cm(-3).

Generalized collisional radiative model for light elements: C: Data for the B isonuclear sequence

A first stage collision database is assembled which contains electron-impact excitation, ionization,\r and recombination rate coefficients for B, B + , B 2+ , B 3+ , and B 4+ . The first stage database\r is constructed using the R-matrix with pseudostates, time-dependent close-coupling, and perturbative\r distorted-wave methods. A second stage collision database is then assembled which contains\r generalized collisional-radiative ionization, recombination, and power loss rate coefficients as a\r function of both temperature and density. The second stage database is constructed by solution of\r the collisional-radiative equations in the quasi-static equilibrium approximation using the first\r stage database. Both collision database stages reside in electronic form at the IAEA Labeled Atomic\r Data Interface (ALADDIN) database and the Atomic Data Analysis Structure (ADAS) open database.

Generalized collisional radiative model for light elements. Part B: Data for the Be isonuclear sequence

A first-stage collision database is assembled which contains electron-impact excitation, ionization, and recombination rate coefficients for Be, Be+, Be2+, and Be3+. The first-stage database is constructed using the R-matrix with pseudo-states, time-dependent close-coupling, and perturbative, distorted-wave methods. A second-stage collision database is then assembled which contains generalized collisional-radiative and radiated power loss coefficients. The second-stage database is constructed by solution of collisional-radiative equations in the quasi-static equilibrium approximation using the first-stage database. Both collision database stages reside in electronic form at the ORNL Controlled Fusion Atomic Data Center and in the ADAS database, and are easily accessed over the worldwide internet. © 2007 Elsevier Inc. All rights reserved.

Generalised collisional-radiative model for light elements. A: Data for the Li isonuclear sequence

A first stage collision database is assembled which contains electron-impact effective collision strengths, and ionization and recombination rate coefficients for Li, Li+, and Li2+. The first stage database is constructed using the R-matrix with pseudo-states, time-dependent close-coupling, converged close-coupling, and perturbative distorted-wave methods. A second stage collision database is then assembled which contains generalized collisional-radiative and radiated power loss coefficients. The second stage database is constructed by solution of collisional-radiative equations in the quasi-static equilibrium approximation using the first stage database. Both collision database stages reside in electronic form at the ORNL Controlled Fusion Atomic Data Center and in the ADAS database, and are easily accessed over the worldwide internet. ?? 2006 Elsevier Inc. All rights reserved.