The Use of Electrospray Mass Spectrometry to Determine Speciation in a Dynamic Combinatorial Library for Anion Recognition

The composition of a dynamic mixture of similar 2,2'-bipyridine complexes of iron(II) bearing either an amide (5-benzylamido-2,2'-bipyridine and 5-(2-methoxyethane)amido-2,2'-bipyridine) or an ester (2,2'-bipyridine-5-carboxylic acid benzylester and 2,2'-bipyridine-5-carboxylic acid 2-methoxyethane ester) side chain have been evaluated by electrospray mass spectroscopy in acetonitrile. The time taken for the complexes to come to equilibrium appears to be dependent on the counteranion, with chloride causing a rapid redistribution of two preformed heteroleptic complexes (of the order of 1 hour), whereas the time it takes in the presence of tetrafluoroborate salts is in excess of 24^^h. Similarly the final distribution of products is dependent on the anion present, with the presence of chloride, and to a lesser extent bromide, preferring three amide-functionalized ligands, and a slight preference for an appended benzyl over a methoxyethyl group. Furthermore, for the first time, this study shows that the distribution of a dynamic library of metal complexes monitored by ESI-MS can adapt following the introduction of a different anion, in this case tetrabutylammonium chloride to give the most favoured heteroleptic complex despite the increasing ionic strength of the solution. 

Investigating the use of compliant webs in the damage-tolerant design of stiffener run-outs

In this work, the use of a compliant web design for improved damage tolerance in stiffener run-outs is investigated. Firstly, a numerical study that incorporates the possibility of debonding and delamination (using VCCT) is used to select a favourable compliant run-out configuration. Then, three different configurations are compared to establish the merits of the compliant design: a baseline configuration, a configuration with optimised tapering and the selected compliant configuration. The performance of these configurations, in terms of strength and damage tolerance, was compared numerically using a parametric finite element analysis. The energy release rates for debonding and delamination, for different crack lengths across the specimen width, were used for this comparison. The three configurations were subsequently manufactured and tested. In order to monitor the failure process, acoustic emission (AE) equipment was used and proved valuable in the detection and analysis of failure. The predicted failure loads, based on the energy release rates, showed good agreement with the experiments, particularly when the distribution of energy release rate across the width of the specimen was taken into account. As predicted numerically, the compliant configuration failed by debonding and showed improved damage tolerance compared to the baseline and tapered stiffener run-outs.

The use of a GA to improve the postbuckling strength of stiffened composite panels susceptible to secondary instabilities

The use of genetic algorithms (GAs) for structural optimisation is well established but little work has been reported on the inclusion of damage variables within an optimisation framework. This approach is particularly useful in the optimisation of composite structures which are prone to delamination damage. In this paper a challenging design problem is presented where the objective was to delay the catastrophic failure of a postbuckling secondary-bonded stiffened composite panel susceptible to secondary instabilities. It has been conjectured for some time that the sudden energy release associated with secondary instabilities may initiate structural failure, but this has proved difficult to observe experimentally. The optimisation methodology confirmed this indirectly by evolving a panel displaying a delayed secondary instability whilst meeting all other design requirements. This has important implication in the design of thin-skinned lightweight aerostructures which may exhibit this phenomenon.

Exploring the use of physical activity loyalty cards for behaviour change in public health: randomised controlled trial

Abstract
Background Physical inactivity is a major public health concern, and more innovative approaches are urgently needed to address it. The UK Government supports the use of incentives and so-called nudges to encourage healthy behaviour changes, and has encouraged business sector involvement in public health through the Public Health Responsibility Deal. To test the effectiveness of provision of incentives to encourage adults to increase their physical activity, we
recruited 406 adults from a workplace setting (office-based) to take part in an assessor-blind randomised controlled trial.
Methods
We developed the physical activity loyalty card scheme, which integrates a novel physical activity tracking system with web-based monitoring (palcard). Participants were recruited from two buildings at Northern Ireland’s main
government offices and were randomly allocated (grouped by building [n=2] to reduce contamination) to either incentive group (n=199) or no incentive group (n=207). We included participants aged 16–65 years, based at the worksite 4 days or more per week and for 6 h or more per day, and able to complete 15 min of moderate-paced walking (self-report). Exclusion criteria included having received specific advice by a general practitioner not to exercise. A statistician not involved in administration of the trial prepared a computer-generated random allocation sequence. Random assignments were placed in individually numbered, sealed envelopes by the statistician to ensure concealment of allocation. Only the assessor was masked to assignment. Sensors were placed along footpaths and the gym in the workplace. Participants scanned their loyalty card at the sensor when undertaking physical activity (eg, walking), which logged activity. Participants in the incentive group monitored their physical activity, collected points, and received rewards (retail vouchers) for minutes of physical activity completed over the 12-week intervention. Rewards were vouchers sponsored by local retailers. Participants in the no incentive group used their loyalty card to self-monitor their physical activity but were not able to earn points or receive rewards. The primary outcome was change in minutes of moderate to vigorous physical activity with the Global Physical Activity Questionnaire, measured at baseline, week 12, and 6 months. Activity was objectively measured with the tracking system over the 12-week intervention. Mann Whitney U tests were done to assess change between groups.
Findings
The mean age of participants was 43·32 years (SD 9·37), and 272 (67%) were women. We obtained follow-up data from 353 (87%) participants at week 12 and 341 (84%) at 6 months. At week 12, participants in the incentive group increased moderate to vigorous physical activity by a median of 60 min per week (IQR –10 to 120) compared with 30 min per week (–60 to 90) in the no incentive group (p=0·05). At 6 months, participants in the incentive group had
increased their moderate to vigorous physical activity by 30 min per week (–60 to 100) from baseline compared with 0 min per week (–115 to 1110) in the no incentive group (p=0·099). We noted no significant differences between groups
for use of loyalty card (p=0·18). Participants in the incentive group recorded a mean of 60·22 min (95% CI 50·90–69·55) of physical activity per week with their loyalty card on week 1 and 23·56 min (17·06–30·06) at week 12, which was similar to that for those in the no incentive group (59·74 min, 51·24–68·23, at week 1; 20·25 min, 14·45–26·06, at week 12; p=0·94 for differences between groups at week 1; p=0·45 for differences between groups at week 12).
Interpretation:
Financial incentives showed a short-term behaviour change in physical activity. This innovative study contributes to the necessary evidence base, and has important implications for physical activity promotion and business engagement in health. The optimum incentive-based approach needs to be established. Results should be interpreted with some caution as the analyses of secondary outcomes were not adjusted for multiple comparisons.

Trends in the use of psychotropic medications among adolescents, 1994 to 2001

Objectives: Few psychotropic medications are approved for use among children younger than 18 years. Yet previous studies have shown an increase in the use of psychotropic medications among school-age children and adolescents. Most previous studies examined data only up to 1997; therefore, the results predate any impact of changing federal policies and newly marketed medications. This study examined trends in the prescription of psychotropic medications to adolescents aged 14 to 18 years in office-based care in the United States from 1994 to 2001. Methods: Data from the National Ambulatory Medical Care Survey (NAMCS) were used to determine visit rates and prescribing patterns from 1994 to 2001 for psychotropics that were prescribed in office-based treatment settings to adolescents aged 14 to 18 years. Rates of visits that resulted in a prescription for psychotropic medication were calculated for two-year periods. Analyses were conducted by type of medication, gender, and the prescribing physician's specialty. Results: Rates of visits that resulted in a psychotropic prescription increased from 3.4 percent in 1994-1995 to 8.3 percent in 2000-2001. These trends were evident for males and females. The average annual growth rates for psychotropic prescriptions were much higher after 1999. Trends were also significant across drug classes. By 2001, one out of ten office visits by adolescent males resulted in a prescription for a psychotropic medication. Conclusions: Average annual growth rates for the prescription of psychotropics to adolescents increased from 1994 to 2001, with especially rapid acceleration after 1999. This increase may be associated with changing thresholds of diagnosis and treatment, availability of new medications, and changes in federal regulatory policies concerning promotion of medications by the pharmaceutical industry.

Single crystal CVD diamond growth strategy by the use of a 3D geometrical model: Growth on (113) oriented substrates

The quality of single crystal diamond obtained by microwave CVD processes has been drastically improved in the last 5 years thanks to surface pretreatment of the substrates [A. Tallaire, J. Achard, F. Silva, R.S. Sussmann, A. Gicquel, E. Rzepka, Physica Status Solidi (A) 201, 2419-2424 (2004); G. Bogdan, M. Nesladek, J. D'Haen, J. Maes, V.V. Moshchalkov, K. Haenen, M. D'Olieslaeger, Physica Status Solidi (A) 202, 2066-2072 (2005); M. Yamamoto, T. Teraji, T. Ito, Journal of Crystal Growth 285, 130-136 (2005)]. Additionally, recent results have unambiguously shown the occurrence of (110) faces on crystal edges and (113) faces on crystal corners [F. Silva, J. Achard, X. Bonnin, A. Michau, A. Tallaire, O. Brinza, A. Gicquel, Physica Status Solidi (A) 203, 3049-3055 (2006)]. We have developed a 3D geometrical growth model to account for the final crystal morphology. The basic parameters of this growth model are the relative displacement speeds of (111), (110) and (113) faces normalized to that of the (100) faces, respectively alpha, beta, and gamma. This model predicts both the final equilibrium shape of the crystal (i.e. after infinite growth time) and the crystal morphology as a function of alpha, beta, gamma, and deposition time.

An optimized operating point, deduced from the model, has been validated experimentally by measuring the growth rate in (100), (111), (110), and (113) orientations. Furthermore, the evolution of alpha, beta, gamma as a function of methane concentration in the gas discharge has been established. From these results, crystal growth strategies can be proposed in order, for example, to enlarge the deposition area. In particular, we will show, using the growth model, that the only possibility to significantly increase the deposition area is, for our growth conditions, to use a (113) oriented substrate. A comparison between the grown crystal and the model results will be discussed and characterizations of the grown film (Photoluminescence spectroscopy, EPR, SEM) will be presented. (C) 2008 Elsevier B.V. All rights reserved.

The use of natural health products (NHP) by Ontario seniors

A random dialing telephone survey in 4 Ontario communities obtained data on the use of natural health products (NHP) from 1,071 persons 60 years and older. 553 (52%) respondents were users of NHP. Prevalence of use was similar for females (53%) and males (48%). In this population modal users were of European descent, high school graduates and employed at least part-time. Half the users received recommendations about NHP from friends or relatives; another 22% learned about NHP through self-experimentation. Most users (81 %) decided by themselves whether they would buy an NHP rather than rely on input from another source (herbalist, physician, store owner/employee). 38% of NHP users had not informed their physician that they were using an NHP. When users had discussed NHP with their physician, less than 5% of physicians responded negatively. Some users felt natural health products were safer (15%) and less expensive (4%) than prescription drugs. 30% used NHP as a last resort for the treatment of a chronic disease. Nearly half (49%) of the users believed that if the government pays for prescription drugs, it should also pay for herbal remedies; 36% said the consumer should pay. In light of the extensive use of NHP by seniors, there is a need for clinical pharmacology studies of these products.

The use of Short Time on Stream (STOS) transient kinetics to investigate the role of hydrogen in enhancing NOx reduction over silver catalysts

The role of hydrogen in promoting the reduction by ammonia of NOx on silver catalysts has been investigated using a Short Time on Stream (STOS) technique to allow differentiation between potentially reactive intermediates and relatively inactive spectator species. Under these conditions, we have used DRIFTS to identify surface nitrate species that are formed and removed on a timescale of seconds. This is in contrast to nitrate species observed under normal steady-state conditions which can continue to form over many tens of minutes. Since this timescale of seconds is very similar to the response rate at which the NH3/NOx to N-2 reaction is accelerated when H-2 is added, or decelerated when H-2 is removed, we conclude that this fast-forming and fast disappearing nitrate species is most probably adsorbed on or close to the active Ag sites. The removal of such a blocking nitrate species from the active sites can explain the effect of H-2 in greatly increasing the rate of the overall de-NOx reaction.